Question about Cars & Trucks

1 Answer

My 2002 Mazda protege 5 automatic will not shift into 4th gear

It shift into first 2nd ans 3rd but not 4th

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 344 Answers

Take it into a trans mission shop to have them road test it to see what the problem is with it,

Posted on Nov 28, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1997 Mazda protege transmission, Hard shifting from 1st gear

I would try a flush. If its set up like my 96, and it likely is, changing the trasmission gasket and filter will be difficult. Mine has a medal plug on the bottom and takes an allen wrench, and possibly a breaker bar. If you take out this plug, drain, flush then refill via the dipstick tube and a funnel, it may help. You may need to do this a couple of times due to fluid still in the torque converter, pan, etc.
Lucas is good stuff, I would add it again when I was done. The tranny fluid should be pink, mine looked like used oil black before I flushed it.
Also, when adding the new fluid, shift slowly up and down through all of the gears to lube well and check your fluid levels after 100 miles or so, as sometimes a bubble will form and make it look full....then not after it pops.

Posted on Dec 23, 2008

  • 6982 Answers

SOURCE: 02 jeep liberty won't shift into 3rd or 4th gear.

Ratio codes generally indicate a pressure loss & slipping which the computer reads as a gear ratio problem. Likely you need a rebuild.

Posted on Mar 16, 2009

  • 4 Answers

SOURCE: 2002 kia optima slipping into 3rd and 2nd gear while driving

UPDATE! ! ! Fixed this problem! YES ! ! ! The speed sensors was all that needed replacing. NOT ANY SOLENOIDS ! !. Two of them cost $160 and it solved the problem! Do not buy from the dealers. An after market version is available for $50 each. I was forced to buy dealers.

Posted on Apr 04, 2009

  • 1 Answer

SOURCE: 2002 Mazda Protege acceleration problem

I had the same problem and found that the air admission tube was badly cracked.

Since this let air enter the engine downstream of the mass airflow sensor it is not measured so the engine ECU don't send the proper amount of fuel to provide the right air/fuel mixture. At higher RPM, the vacuum in the tube is enough to close the crack and hide the problem.

I temporarly repaired it with duct tape until I get the part.

Stephane

4cc37fa.jpg

Posted on May 27, 2009

  • 2 Answers

SOURCE: automatic transmission not shifting into 3rd or 4th

my 1999 f250 super duty will not shift into overdrive

Posted on Aug 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda 2300 grindes when shifting into 4th


4th gear is not a gear as such but a coulping of the input and out put shafts to make a complete shaft
If there is a problem moving this coupling it indicates a syncro ring problem or spigot bearing failure in the end of the input shaft
either way it amounts to a gear box removal and pull down for repairs.

Jul 07, 2015 | Mazda Cars & Trucks

1 Answer

2002 Mazda Tribute hard shift/shift flare only from 2nd to 3rd gear


bad sign that, get it checked, do not allow it to slip.
or it can get worse fast.

Jul 18, 2014 | 2002 Mazda Tribute

1 Answer

2003 Grand Am Automatic will shift normal from 1-2 but will not shift into 3 or 4.


Worn clutches or solenoid issues if it is an Alison style box.

Apr 02, 2017 | Pontiac Cars & Trucks

2 Answers

1997 Mazda protege LX 1.5 automatic transmission


You are going to need a transmission shop. Mazdas do not always throw codes. You have an early OBD transmission, which do not send out many codes.

Aug 02, 2009 | 1997 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...