Question about Suzuki Cars & Trucks

Open Question

Throttle cable sticking on 1988 suzuki samurai

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
lesabre1972
  • 474 Answers

SOURCE: 1988 suzuki samurai WONT MOVE

First thing just try to push or pull the 4x4 lever if you get it to move and it feels like it went into some gear try to drive the truck.If this works look on the shifter for the 4x4 and put it in 2 wheel drive (H2 is two wheel drive,H4 is 4x4 high,and L4 is 4x4 low range).Make sure you have the clutch depresed when you try to move the 4x4 lever.If you try this stuff with no fix try and look for clutch adjustment on the transmision you may need to adjust it or your clutch is bad.

Posted on Aug 30, 2008

Ad
  • 84 Answers

SOURCE: LEAKING OIL FROM T-CASE SHAFT TO TRANSMISSION

Have you tried the dealer, they should have this seal, if not let us know the measurements and we can help

Posted on Dec 23, 2008

  • 1 Answer

SOURCE: suzuki samurai

Look at the timing belt and make sure it is on and tight. Then maybe pull the distributor and make sure it isn't bad

Posted on Dec 24, 2008

ewashmidas
  • 362 Answers

SOURCE: Rear wheel bearings for my 1988 Suzuki Samurai

They are pressed in, not an easy job.

Posted on Feb 11, 2009

  • 142 Answers

SOURCE: I have a 1988 suzuki

The transmission doesn't have a dipstick but it does have a fill level plug located at the rear of the extension housing, just to the passengers side. It is a round plug with a 3/8 square hole in it.
Fill trans till oil overflows out of this hole.
Use VMX80 or similar.

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i get piece out of transmission that speedo cable goes in on 88 suzuki samurai.


You can try using some heat to free up the corrosion around seam. Or a penetrating oil and let soak for some time

Nov 26, 2014 | 1988 Suzuki Samurai

1 Answer

1988 susuki throlte stuck open when started


Have you looked into the throttle body to see if the throttle plate is actually open, or does it have a vac leak or a problem with the idle air control valve ?

Feb 25, 2013 | 1988 Suzuki Samurai

1 Answer

88 Suzuki Samurai idles fine but wont take gas?


check the carb main jets i just had that problem rebuilt the carb and fixed it. auto zone has rebuild kit for around 30 dollars easy to rebuild if you take a lot of pictures!! spray all the jets out with carb cleaner around 4 dollars

Dec 29, 2012 | 1988 Suzuki Samurai

1 Answer

How do i remove a starter for a 1988 Suzuki Samurai


Disconnect negative terminal of battery.
Remove positive lead from starter solenoid.
Remove the solenoid wire (brown).
Remove two bolts holding starter to bellhousing.
Lift starter out.

Apr 16, 2012 | Suzuki Samurai Cars & Trucks

1 Answer

Il be going down the road and my throttle sticks wide open.later on its ok, then the problem occures again.


The pedal and the command cable are worn out and they jam. Either replace them or oil them thoroughly.

Jan 27, 2010 | 1987 Suzuki Samurai

2 Answers

My '87 samurai sputters badly when i give it throttle.


Try changing the fuel filter.If it is running ok at lower speeds around 50kmh/30mph I would say fuel supply is the problem.
Hope this helps.

Jul 27, 2009 | 1988 Suzuki Samurai

1 Answer

1988 Samurai clicks when i try to start


this is an starter soleniod symptom

Jun 09, 2009 | 1988 Suzuki Samurai

2 Answers

E brake light stays


Most likely just a bad sensor. If the brake isn't stuck on. This happens on other vehicles I'm sure its possible on suzuki's. I would stick some electrical tape over the light and then you have no worries. =). Or you can do alot of tearing apart to test the sensor. Thanks, Lee

Jun 05, 2009 | 1988 Suzuki Samurai

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...