Question about 1991 Acura Legend

Open Question

Acura legend automatic transmission removal and installation

How to remove and install an acura legend automatic transmission?

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 155 Answers

SOURCE: Can you disable car alarm in 1991 Acura Legend by

If it's a cheap aftermarket alarm, check for a red wire coming off the hot side of your battery with an inline fuse. If it's not, try to locate the alarm "computer" under the driver's side dash or nearby your fuse panel. You'll find a black box with a wiring diagram glued to the side, normally strapped to a wiring harness or other fixed element. If this is the type of alarm you have, you'll need to trace each wire coming from the alarm computer and unclip each fastener that's clipped to your vehicle's factory wiring. The trouble with these types of alarms is that they can get power from a number of sources (stereo, interior lights, etc.). Good luck with this one!

Posted on Jun 12, 2009

  • 46 Answers

SOURCE: Clearance to remove 93 Acura Legend starter

you can either remove driver's side halfshaft or battery tray and alternator to remove the starter. i chose the halfshaft, since it gave a little more room to unbolt the starter. no need to drain transaxle when removing driver's side halfshaft. unbolt balljoint and tierod end from knuckle. i also removed the pinch bold that attaches the strut to the knuckle to allow more movement to remove the axle. axle nut is 36mm. use a large screwdriver or small prybar to gently pry the halfshaft from the transaxle, be careful not to damage the seal. upper bolt on the starter is really tough to get access to...

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the freeze plug located on a 1991 Acura Legend


more info on freeze plug failure? - The Acura Legend & Acura RL Forum

www.acura-legend.com/vbulletin/.../more-info-freeze-plug-failure-1436...

May 29, 2010 - 5 posts - ‎2 authors
my mechanic told me that my freeze plugs could have failed, i have already searched ... Car 1: 1991 Acura Legend ... Car 1: 94 acura legend ls. anti freeze leak
3 posts
May 11, 2010
Easiest way to
7 posts
Jul 17, 2007
Manual transmission fluid change help
13 posts
Apr 7, 2007
engine block heater?
15 posts
Dec 21, 2003
More results from www.acura-legend.com

Where is the freeze plug located on a 1991 Acura Legend ...

www.fixya.com/cars/t26009696-freeze_plug_located_1991_acura_legend
1 hour ago - where is the freeze plug located on a 1991 Acura Legend - Acura Cars & Trucks question.

Acura Legend leaking freeze plug Questions & Answers ...


Dec 16, 2015 | Acura Cars & Trucks

1 Answer

How remove the trans out of 1992 Acura vigr


1992 Acura Legend Manual Transmission problems ...

? 4:21
www.youtube.com/watch?v=iB7p0PKrDIA
Jan 1, 2012 - Uploaded by Ryan Kucan
1992 Acura Legend Manual Transmission problems ... How toremove the shift linkage pin from a Honda Acura transmission - Duration: 1:56.

Sep 12, 2015 | Acura Cars & Trucks

1 Answer

Rear main seal (slow) leak on a acura 95 legend. how soon should it be fixed and how much will it cost?


With any leak it should be fixed as soon as possible as far as cost, that will depend on teh shop you take it to and which method they use to replace it. They typically have 2 options, pull the transmission and replace it from the outside or pull the motor and replace the seal. Typically a Transmission shop will charge you about $600 to $800 to remove and install a Transmission plus the cost of the part and the labor to install the new seal.

May 22, 2011 | 1995 Acura Legend

1 Answer

How do you remove the transmission pan on a 1993 acura legend


first locate the automatic transmission... there should be a black or silver pan directly on the bottom of the transmission. should be fairly easy to get to... loosen all the bolts that are holding the pan on. be careful fluid will drain out as soon as you crack those open so either drain it first or loosen one side of the pan and let it hang down a little bit and drain that way...

Mar 03, 2011 | 1993 Acura Legend

1 Answer

How do you drain the transmission fluid from a 1988 acura legend coupe?


The drain plug is on the right side of the automatic transmissions towards the front. You will get 2 to 3 quarts out and need to get Honda approved fluid (which is really Dextron I). It is $8 a quart at the dealer and the Castrol version is half the cost.

Apr 03, 2010 | 1988 Acura Legend

1 Answer

How do change a Thermostat for a 91 Acura Legend


  1. Drain the cooling system and remove the lower radiator hose from the thermostat housing.
  2. Remove the thermostat housing bolts, the housing and the thermostat.
  3. Clean the gasket mounting surfaces.
  4. To install, use new gaskets and reverse the removal procedures; install the thermostat's spring end toward the engine. Torque the housing bolts to 9 ft. lbs. (12 Nm).
  5. Refill and bleed the cooling system.

Jan 19, 2010 | 1991 Acura Legend

1 Answer

Do cam shaft arrow on the car hav to match in the same position


yes you should always have the cam sprockets aligned with tdc and the engine should be on tdc whenever removing or installing the heads.

Mar 18, 2009 | 1993 Acura Legend

1 Answer

How to remove tranny filter from a 1992 acure legend automatic tr


I have good news and bad news.....good news acura does not use a common trans pan.the transaxle does have a brass filtering element inside the trans between the cases and acura never recommends replacement untill the trans is overhauled .bad news you propably did some unecessary work so far.just remove the drain bolt on the side of the case and refill at the dip stick approx 3 qts,check your handbook for EXACT fluid and amount. DB

Jan 28, 2009 | 1990 Acura Legend

Not finding what you are looking for?
1991 Acura Legend Logo

Related Topics:

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...