Question about 1998 Ford Windstar

Open Question

1998 ford windstar blows the ecm fuse?

I have pullde the resteer pudded the relay fuel ect, cked oms ? put it all back but rester i put rester back in place with key on it blows fuse? what help can i get

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shaggyrat
  • 1224 Answers

SOURCE: E.E.C fuse keeps blowing in 1991 Ford Explorer

if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing

sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go

Posted on May 26, 2008

dustyboner
  • 331 Answers

SOURCE: 1996 windstar relay

The fuel pump power on the Windstar is controlled by a component called a Constant Control Relay Module (CCRM).
Its located located on the driver's side of the engine compartment.d7fb0ae.jpg

Posted on Oct 22, 2008

  • 1 Answer

SOURCE: fuse and relay box underdash

You may download the Owners Manual at: http://www.analogstereo.com/pdf/om/windstar_owners_manual_2001.pdf

Posted on Dec 10, 2008

  • 65 Answers

SOURCE: Ford Escort 1998 fuel pump not working.

good old ford lol, try looking at the crank sensor its located at the front of the engine tucked in right hand side of exhaust manifold and gearbox, two pin plug, i have also known these to have no end of faults with the fusebox.
easy to remove, and solder the connections inside they all suffer eventually, if your not to handy with cars i recommend taking to a auto electrician, easy if you know how. Good luck Davelee

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: I need to know what

The fuse number for the fuel pump motor is #5 located under the hood. And it takes a 15A fuse.

Posted on Apr 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does my 1998 ford windstar fuel pump have a fuse?


Power is supplied to the fuel pump relay through 20A FUSE N in the engine compartment fuse box.

Jan 22, 2017 | 1998 Ford Windstar

1 Answer

My 2000s10 keep blowing the ecm b fuse when i trun the key on


That fuse ECM B also power's the fuel pump an fuel injectors ! It the under hood fuse / relay box ,pull out the fuel pump relay then put fuse ECM B back in an see if it still blows , You could have a shorted injector or fuel pump or the relay !

Mar 14, 2015 | 2000 Chevrolet S-10

1 Answer

My 1998 Ford Windstar will not pass 20 mph


Check for plugged fuel filter or line. check fuel for water in the gas.check gas pedal linkage for binding.check transmission is shifting check air box and filter make sure you didnt suck in a plastic bag. check exhust that tail pipe is not blocked.with anything plastic bag ,potato,ect.check for pcv valve or vacuum line off. Check your emergancy brake is not on. check for overheating front or rear brakes they could be stuck on . If this was helpful please leave good feed back

Sep 15, 2014 | 1998 Ford Windstar

1 Answer

I have a 1998 windstar that when I start it and run it for a few it blows my fuel pump fuse I have replaced the the fuel pump pressure sensor what could be the cause of it oh and it keeps giving the...


Well code 1450 for a Ford product is a problem with the gas tank venting system.
I would think the pump in the tank is blowing the fuse, and it could be from excessive pressure in the tank.

Jul 31, 2013 | 1998 Ford Windstar

1 Answer

I put a new fuel pump in a 98 ford windstar it wont kick on


check the fuel pump relay it the possible cause or the fuse

Aug 09, 2012 | 1998 Ford Windstar

1 Answer

Pcm fuse keeps blowing and van won't run


sounds like dead short....would look at wire diagrahm to see what ground is hitting a hot wire...maybe alternator,starter, fuse block....ect....

Jun 19, 2010 | 1998 Ford Windstar

1 Answer

1998 Windstar--My fuel pump is working, and I am getting gas up to the fuel rail, but my injectors are not working.


Check Fuses All Of Them Under Hood, Dash ect...., Check Fuseable Links Make Sure Check Engine Light on dashboard is on ....Probe ECM For Answers like Cam Sensor,Crank Sensor ect...just example...but i would probe ECM Memory for answers..hope this helps

Jun 18, 2010 | 1998 Ford Windstar

1 Answer

Heat & a/c stopped working wont blow any air fuse not blown bought new blower motor connected it and it still wont work 1998 ford windstar van


Check the blower motor relay next to the blower motor,it could be a blower module,but it is the problem.

Apr 16, 2010 | 1998 Ford Windstar

1 Answer

Will not start and checked fuel pump no power to fuel pump i also have blown fuse for ecmb that blows as soon as i replace it


ECM B fuse supplies a constant 12v hot at all times to the VCM/PCM and to the fuel pump relay. The fuse is blowing telling you that there is a short to ground somewhere. Try this, take the fuel pump relay out and put a new fuse in. If it doesn't blow put the relay back in and if it blows then try a new relay. The relay may be shorted to ground internaly. Other wise you'll have to trace the wires to the VCM and the pump relay to look for a chafed wire that's contacting metal. The wire coming from the ECM B fuse is orange and has a splice in it going to the pump relay and the VCM/PCM.
Hope this helps.....Andrew

Mar 28, 2010 | 1999 Chevrolet S-10 Pickup

Not finding what you are looking for?
1998 Ford Windstar Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...