Question about Cars & Trucks

1 Answer

Cooling fans will not turn off

Car is off and cool and fans will not turn off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,338 Answers

Cooling fan relay could be bad,circuit is staying open.

Posted on Nov 27, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: my cooling fans not running so my car kep rning

Assuming the fuses are fine the most likely culprit is one of 3 fan relays located on the red cradle at the bottom of you rad. I had the same problem and repalced all 3 seeing as they are a pain to access

Posted on Jan 31, 2010

  • 3 Answers

SOURCE: cooling fans

how long does it stay on?? electric fans have a thermostat and can keep running after your car has been turned off

Posted on Sep 21, 2008

  • 84 Answers

SOURCE: cannot find cooling fan relay

check the owers manual for location usualy in the main electrical box under the hood. they are just a pull out plug with 4 prongs some times 5 pull straight back youll b fine

Posted on Apr 28, 2009

yotaguy
  • 232 Answers

SOURCE: The electric radiator cooling fan will not turn off

As long as the fan eventually shuts off this isn't a problem,the fan will continue to run for a bit after the car is turned off,once it reaches a set temprature it will turn off.

Posted on May 02, 2009

jagjeffery
  • 318 Answers

SOURCE: replaced cooling fan relays,the cooling fan

remove the cooling fan relay you should have power on the pink and black wire and the solid red wire going to the base for the relay if you do then check then turn the a/c on and check for your ground sigal from the darkgreen and white wire if no ground you have a bad fan control module located on the right side of the engine compartment

Posted on Jun 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When I turn the engine off the engine cooling fan stays on and does not shut off


depending on the engine temperature the fan is supposed to remain on after you turn the engine off, until the engine reaches a preset cooler temperature. when it reaches cooler temperature usually within 5 minutes or so it should cut off... if you cut it off and it is running 30 minutes later.. then there is a problem with the fan relay or temperature sending unit.

Sep 28, 2015 | 2009 Dodge Grand Caravan

1 Answer

My 1994 Toyota Previa LE overheats when I put on AC. It overheats while on idle.


cooling fan not running.check for faulty cooling fan relay or fuse.cooling fan fan should be running when you turn on AC.hotwire cooling fan make sure cooling fan motor okay.

Jul 10, 2013 | Cars & Trucks

2 Answers

Engine cooling fan only works when ac or defrost is on


if engine at long stand still,the engine temperature will rise about 190 degrees the cooling fan suppose to automaticaly turn on when coolant temperature sensor get hot it cause its resistance decrease causing pcm to send power to coolant fan relays and cooling fans, when you turn on AC the cooling fans suppose to turn on to cool down AC CONDENSOR, IF NOT AC WONT WORK COOLING FAN COOLS DOWN REFRIGERANT SO IT CAN RECYCLE THROUGH THE SYSTEM AGAIN.your cooling is suppose to turn on when engine at a sit still if vechicle not moving as coolant temperature rises at a set point the cooling fans will turn on cool down engine.cooling fans dont turn on when you first cold stsrt vechicle unless you have AC SWITCH ON.if cooling fans dont turn on when vechicle at a long stand still or moving along slow traffic.if coolant temperature sensor been replaced and fuses and relays okay have dealership check see if pcm driver circuit working faulty pcm will cause cooling fans not to turn on.

Sep 27, 2012 | 1996 Buick Century

1 Answer

I have a 2006 PT cruiser and the cooling fan will not turn off


on a lot of vehicles, the electric fan cooling the radiator will stay on when the car is turned off. this is normal and happens when the senser tells the fan that the engine is hot and needs cooling. if it stays on for prolonged periods, there is a problem somewhere. should cool and turn off automatically. R

Aug 25, 2012 | 2006 Chrysler PT Cruiser

1 Answer

Fan comes on when switch ignition on instead of when hot Tazz


If the fan not turning on when car engine getting hot,then car will notice overheating.Click this link below for troubleshooting:---http://technoanswers.blogspot.in/2012/02/car-running-hot.html--------To know how engine cooling system works ,click the link below :----Engine cooling components working?

http://repairhelpcenter.blogspot.com/2011/11/engine-cooling-components-working.html

------------------
How does Vehicles Engine cooling system works? http://repairhelpcenter.blogspot.com/2011/11/how-does-vehicles-engine-cooling-system.html
------------How to Replace Engine cooling Fan:-- http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-engine-cooling-fan-on.html
-----------Replace Fan Relay but still Radiator cooling fans not working? http://schematicsdiagram.blogspot.com/2011/12/replace-fan-relay-but-still-radiator.html
----------DIC says "COOLING FAN FAULT"? http://schematicsdiagram.blogspot.com/2011/12/dic-says-cooling-fan-fault.html
---------Where Is Radiator Fan relay and Fuse Located?

http://schematicsdiagram.blogspot.com/2011/12/where-is-radiator-fan-relay-and-fuse.html

--------

This will help.

Thanks.

Feb 09, 2012 | Cars & Trucks

1 Answer

How do i check the cooling fan my car is over heating


HOT WIRE COOLING FAN USING JUMPER WIRES TO BATTERY.IF FAN DONT RUN WHEN HOT WIRED FAN MOTOR BAD NEED REPLACING. IF FAN RUN WHEN HOT WIRED. CHECK COOLING FAN FUSE AND RELAY.IF ALL IS GOOD.YOUR ENGINE COOLANT TEMPERATURE SENSOR NOT WORKING.IT CONTROL COOLING FAN AT SET TEMPERATURE IF SENSOR OPEN OR FAULTY THE COOLING FAN WONT TURN ON.CHECK COOLING FAN WIRES FOR DAMAGE.IF ALL STILL CHECK OUT GOOD HAVE VECHICLE SCANNED FOR PCM FAULT.IF IT FAILS NO COOLING FAN WONT TURN ON.

Dec 13, 2010 | Hyundai Elantra Cars & Trucks

2 Answers

Electric Radiator Fan Does Not Come On


Chevy dealer says will not come on until temperature reaches 219 f

May 16, 2010 | 2007 Chevrolet Silverado 1500 2WD

1 Answer

Where is the switch that cuts on the cooling fans on a 2000 grand am with a 3.4 engine


The computer turns on the fan. Based on sensors from the motor.
DTC P0480 - COOLING FAN CIRCUIT

Circuit Description

The cooling fan is controlled by PCM through the fan relay based on inputs from ECT sensor, IAT sensor, A/C selector switch, A/C refrigerant pressure switch and vehicle speed sensor. PCM controls cooling fan by grounding cooling fan control circuit which turns on cooling fan relay.

The fan relay will be commanded on when ECT reaches 223°F (106°C) or greater, A/C is requested or vehicle speed is less than 38 MPH. Cooling fan relay will also be commanded on regardless of vehicle speed when a DTC is set requesting cooling fan to be on, ECT is 304°F (151°C) or greater, or A/C refrigerant pressure is high. Cooling fan may also be commanded on when engine is not running, on certain conditions.

Conditions for setting DTC:

Battery voltage greater than 9.5 volts.

Cooling fan fault line detects a malfunction for 6 seconds.

1. Check cooling system. Ensure coolant level and belt tension are correct. Adjust/repair as necessary. After repairs, go to step 23). If no adjustment or repairs were required, go to next step.

2. Turn ignition on, with engine off. Using scan tool, check if cooling fan is operating with ECT at less than 209°F (98°C). If cooling fan is off, go to next step. If cooling fan is on, go to step 4).

3. Command cooling fan relay on. If cooling fan operates, go to step 23). If cooling fan does not operate, go to step 5).

4. Turn ignition off. Disconnect PCM harness connector. If cooling fan turns off, go to step 23). If cooling fan does not turn off, go to step 6).

5. Disconnect cooling fan relay harness connector. Using a test light connected to ground, probe battery feed circuits in relay harness connector. If test light illuminates on both terminals, go to step 7). If test light does not illuminate on both terminals, go to step icon_cool.gif.

6. Disconnect cooling fan relay harness connector. With test light connected to ground, probe battery feed circuit in relay harness connector. If test light illuminates, go to step 9). If test light does not illuminate, go to step 10).

7. Connect a jumper wire between cooling fan relay battery feed and cooling fan battery feed circuit. If cooling fan operates, go to step 11). If cooling fan does not operate, go to step 12).

8. Repair open in battery feed circuit. After repairs, go to step 23).

9. Repair short to voltage in cooling fan battery feed circuit. After repairs, go to step 23).

10. Connect test light battery voltage and probe cooling fan control circuit. If test light illuminates, go to step 13). If test light does not illuminate, go to step 21).

11. Connect test light to battery voltage and probe cooling fan control circuit. Using scan tool, command cooling fan on. If test light illuminates, go to step 14). If test light does not illuminate, go to step 15).

12. With jumper wire still connected, disconnect cooling fan harness connector. Using test light connected to ground, probe cooling fan battery feed circuit. If test light illuminates, go to step 16). If test light does not illuminate, go to step 17).

13. Repair short to ground in cooling fan control circuit. After repairs, go to step 23).

14. Check terminals to cooling fan relay. Repair as necessary. After repairs, go to step 23). If terminals are okay, go to step 21).

15. Check cooling fan control circuit for open or poor connection. Repair as necessary. After repairs, go to step 23). If circuit or connection is okay, go to step 22).

16. Connect test light to battery voltage and probe cooling fan ground circuit. If test light illuminates, go to step 1icon_cool.gif. If test light does not illuminate, go to step 19).

17. Repair open or poor connection in cooling fan ignition feed circuit. After repairs, go to step 23).

18. Check for poor connections at cooling fan harness connector. Repair as necessary. After repairs, go to step 23). If connections are okay, go to step 20).

19. Repair open or poor connection in cooling fan ground circuit. After repairs, go to step 23).

20. Replace cooling fan motor. After replacing cooling and motor, go step 23).

21. Replace cooling fan relay. After replacing relay, go to step 23).

22. Replace PCM. Program replacement PCM using required equipment. After replacing PCM, go to next step.

23. Turn ignition on, with engine off. Command cooling fan on. If cooling fan operates, system is okay. If cooling fan does not operate, repeat step 1).

May 16, 2010 | 2000 Pontiac Grand Am GT

1 Answer

Car runs hot at an idle. turn on the air and the fan comes on and cools off . does the ect control the fan function when the air is off? 1994 camaro 3.4.


The Cooling fan is Wired in in such a way so as to Automaticly Turn on Cooling Fan If the A/C is Switched ON. If "WITHOUT the A/C on" The Cooling Fan Doen NOT come ON Untill Engine. is @ 210-230 Degrees
There IS a Problem with the Engine COOLING SYSTEM, A Faulty Coolant Temp Sensor Will Cause this Problem. The Cooling fan is Also A Candidate For Testing.

Answering your Quwstion YES The Engine Coolant Temperture Sensor Tells the ECM What the TEMP Is and the ECM Grounds the Cooling FAN Relay to Turn ON Cooling FAN. Temp Sensor is the Usual Culpret, BUT Relay Comes in a CLOSE Second. Hope this Helps !!!

Jun 15, 2009 | 1994 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...