Replaced battery,will not idle.
SOURCE: door panel toyota
three steps.
1. locate screw holes for door handle (and other areas maybe) and remove. the screws may be located behind plugs that you remove with small flat screw driver
2. disconnect and remove power lock/window unit, usually pries up from one end (rear of car) and slides out. be careful not to stracth leather or upholstry
3. using screwdriver, pry bar, nail bar or other flat piece of metal pry panel away from door one clip at a time. try to pry near the clip, otherwise you risk damaging the panel's interior
post another problem if you get further and still have trouble.
paul
SOURCE: Where do you add transmission fluid to a 2004 toyota tundra auto
You add Transmission fluid through the dipstick tube, you will need a small funnel, you can buy one at a local auto parts store.
With the engine warm and the truck in park and running, pull out dipstick, wipe it clean, replace, then pull out and check level.
Let me know if you need further assistance.
Please rate this solution.
Lone99star
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jason_77a19afa8d604dee
SOURCE: 140 amp fuse blown request replacement instructions
you have to remove or access the bottom half of under hood fuse panel to remove bolts on teh bottom of that fuse.
SOURCE: How do I replace the spark plugs on my 2004 toyota
i believe on those the plugs go in through tops of the valve covers with a coil pack on top of each plug just unplug and un bolt the coil and remove and chang plugs
SOURCE: how do I adjust the idle on a 2000 toyota tundra
This is all controlled by a computer, you are going to need to take it to a dealer, OR you can buy a tuner that will also control idle
224 views
Usually answered in minutes!
×