Question about 1997 GMC Jimmy

Open Question

I need a diagram for brake lines for 1997 gmc jimmy

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1118 Answers

SOURCE: need to replace brake line from rear axle forward

Chanses are it broke behind the gas tank wear it runs along the frame rail. You don't need a diagram to fix that, just unhook it at both ends and break it off or cut it off buy the tank and take the pieces with you to a auto parts store and they will match it up with new line, just take a tape measure and measure from the rear axel to the front block or perportioning valve, and don't worry about the piece behind the tank, just run the new line alongside the old one behind the tank unless you want to pull the tank out.

Posted on Sep 06, 2009

  • 740 Answers

SOURCE: set timing 1997 jimmy

Ok that's pretty simple Put cylinder # 1 on TDC= top dead center on the (compressionstroke piston all the way up). Mark on metal part of distributor (with marker) where the number one is on the cap( that's where the number 1 wire plugs in) Then in-plant distributor make sure that rotor point is pointed to #1 on the cap, turn distributor shaft until this is achieved or as close as possible try to center shaft so you can adjust... ****** or advance to fine tune after you in-plant distributor if needed. Contact if you need more help . Good Luck

Posted on Jan 06, 2009

ZJLimited
  • 17970 Answers

SOURCE: looking for a vacum line diagram so i can print it 1996 gmc jimmy

GMC S10/S15/Sonoma Pick-Ups 1982-1993 Repair Manual
VACUUM DIAGRAMS (See Figures 1 through 85)

Below is a listing of vacuum diagrams for most of the engine and emissions package combinations covered by this manual. Because vacuum circuits will vary based on various engine and vehicle options, always refer first to the vehicle emission control information label, if present. Should the label be missing, or should vehicle be equipped with a different engine from the car's original equipment, refer to the diagrams below for the same or similar configuration.
Check the link autozone.com (free register), select the year ('91 sample), Brand, Model, Sub-Model, Engine Size and make the next root...
1991 GMC TRUCK S15 4WD 4.3L TBI 6CYL REPAIR GUIDE >> EMISSION CONTROLS >> VACUUM DIAGRAMS

I really hope helps with this (remember rated this help). Good luck.

Posted on Jan 07, 2010

  • 11 Answers

SOURCE: spark plug wires diagram, need

2009-11-26_175522_4.3_vortec.png this should be it

Posted on Apr 10, 2010

  • 75 Answers

SOURCE: replace water pump on 1997 gmc jimmy 4.3 litre

there are four nuts that you must remove at the front of the pulley between the fan. remove fan, fan shroud,loosen accessory belts. remove water pump pulley and the pump bolts will be exposed. check belts for replacement while you have them loose. reverse procedure to install.

Posted on Apr 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to repair not working rear lights 1997 gmc jimmy


brake lights not working - 1997 GMC Jimmy - RepairPal

repairpal.com > Questions > GMC > Jimmy > 1997 GMC Jimmy
Jan 11, 2011 - hi about 2 days ago i realized my brake lights were not working but my turn signal lights were working and parking lights as well but no brake ...

Tail Lights don't work but third brake light does, not fuses ...

answers.edmunds.com > Edmunds Answers
Sep 23, 2009 - 97 GMC Jimmy 4x4 blinkers work, reverse lights work, above window ... I just lost hazard lights and rear brake lights, they were working 2 days ... If it is a frayed wire or solder point, then you can repair it, but not any worn contacts. ... Does anyone have any suggestions on 1997 Honda Accord tail & brake lig.

Nov 19, 2015 | GMC Cars & Trucks

2 Answers

Does a 1997 Gmc jimmy have back bums or pads


You mean drums? Depends on the vehicle options but should be rotors/pads. Easy to check - look through the wheel spokes and if pads, you should see the rotor.

Feb 24, 2015 | 1997 GMC Jimmy

1 Answer

1997 GMC Jimmy brake line popped


A new brake line assembly is required.

May 15, 2013 | 1997 GMC Jimmy

1 Answer

I need a vacuum line diagram for a 1997 GMC Jimmy. Have a line off and cannot locate where it goes.


Should have a vacuum hose diagram on the
Emissions Label on radiator support or glued
under the hood.
Just for engine compartment

Jun 09, 2011 | GMC Jimmy Cars & Trucks

2 Answers

Looking to see whick fuse is for the brake lights for a 97 gmc jimmy


The brake light fuse is located inside the the fusebox, i have enclosed two diagrams to show you what every fuse is for and the other is the fuse box and the locations are numbered, i hope this is helpful.johnjohn2_20.gifjohnjohn2_21.gif

Nov 16, 2010 | 1997 GMC Jimmy

1 Answer

I'm looking for a diagram for my 1997 GMC Jimmy. The gas tank is leaking and I want to see all the parts that I might have to order.


This is hard to say with out removing the tank, you will need a tank and sometimes the sending unit and pump while tank is down the only other thing would be the fuel lines, if the lines are rusted and dont come loose then you will neeed to make new ones, heres a couple of diagrams to help you, take note there are two style tanks depending on if you have a 2 door or 4 door, one mounts in the rear and the other on the side, i also belive you have plastic fuel lines and shouldnt have a problem with them, while the tank is out the pump asm, which comes complete with sending unit and pump should be replaced, hope this is helpful, good luck.johnjohn2_1.jpgjohnjohn2_2.jpgjohnjohn2_3.jpgjohnjohn2_4.jpg

Nov 04, 2010 | 1997 GMC Jimmy

1 Answer

Where can I find a diagram of the brake lines for a GMC Jimmy? I nwws to replace the left rear brake line and I need to know the routing of the brake lines and where the line is at the ABS module


If it's a metal line, Your local auto parts store should be able to order it for you or worst case you'll have to make your own from straight tubbing and a bender. I don't recall ever seeing diagrams for metal lines, usually there pre made to replace the factory one or you can splice a replacement piece in place of a damaged section. AS far as the line goes to the module, try following it up to it with a good flahlight and a sharppe from the rear forward.

May 30, 2010 | 1994 GMC Jimmy

1 Answer

Need 95 gmc jimmy vacuum diagram. I have a loose


THat goes to your map sensor. If you look very closely under your hood there will be a vac line diagram there

May 09, 2010 | 1995 GMC Jimmy

Not finding what you are looking for?
1997 GMC Jimmy Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...