Question about Cars & Trucks

1 Answer

1999 Dodge Dargano

Also not computer codes and fuel pressure is okay

Posted by on

1 Answer

So we will stand by until you have a question

Posted on Nov 27, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 dodge intrepid stalls out while driving and sitting in red light why


Dodge 2000 Intrepid stalling on Traffic Light - This is caused by either wrong amount of Fuel or Air mixing in Idle condition. Please check fuel pressure at Idle which should be at least 38 psi and should go up when you press the accelerator. If fuel pressure is okay then Clean out the Throttle body carefully. This should solve the problem if no Check engine light is on. If Check engine light is on then please confirm and give me the codes present in On Board Diagnostic port (Auto Zone or Advance Auto will read the codes free for you) and we will go from there.

Jan 05, 2015 | 2000 Dodge Intrepid

1 Answer

1999 dodge ram 59 cummins starts runs great all the sudden dies while driving but it will start right back what culd be the problem


fuel problem i would have thought , check out the fuel pump and relay , fuel pressure , have the OBD codes read as should tell you what sensor/switch is at fault

May 21, 2014 | 1999 Dodge Ram 2500 4WD

1 Answer

Has fuel pressure but not getting gas


The FIRST thing to do is scan your onboard computer network for possible fault codes. You may just have a code for a cranshaft position sensor or Mass Air Flow sensor or something similar that will explain why the engine is not getting any fuel.

Check the fuel delivery system to make sure it is performing according to manufacturers specifications:

The fuel pressure specification for 1999 Dodge Durango is 44-54 Psi. (3.0-3.8 kg/sq.cm) Please note that the specification published by the manufacturer is with the key ON, engine OFF and the fuel pump being activated with a scan tool.

Also note that "CLOSE" is not good enough. I have had vehicles towed in that were only 2 or 3 Psi under the minimum specification that would not start.

If the fuel pressure/fuel delivery is within specifications, then you need to check your fuel injection system. If it gets this far, let me know and we can continue diagnosis.

Jan 03, 2012 | 1999 Dodge Durango

2 Answers

My 1999 Dodge 1500 will just die for no reason, but after is sits you can start it and it will run for day before it will do it again


Since it is a 1999 you can take it to any autoparts store and they will read your error code off the computer. WRITE EACH ONE DOWN IN THE ORDER IT CAME OFF. Those codes will give you a place to start tracking back the problem. I could guess and be wrong and it could cost you bucks for no reason.

Jun 04, 2011 | 1999 Dodge Ram

1 Answer

1999 dodge caravan runs okay until you try to quickly accellerate or when attempting to go up a steeper grade. At these times it pops back through the intake and you lose power The power loss is worse...


have a fuel pressure check ran on the vehicle to make sure it is mantaining the proper fuel pressure at all times.it may be holding enough to keep it running at low acceleration.i hope this helps

Jan 20, 2011 | 1999 Dodge Caravan

3 Answers

Car wont start, I have replaced fuel Filter, Fuel Pump, altenator, Battery, fuse is good, what could it be


Check for spark, and compression...possible timing problem or electrical..

Apr 12, 2010 | 1999 Ford Taurus

1 Answer

Car starts but only runs about 5 seconds


scan it.to see if the camsensor or crank sensor also egr valve.working.make sure egr valve not stuck open.if all is good.your fuel pressure low.change fuel filter check fuel pressure.if fuel pressure good.you got a intake manifold leak or broke vacuum line .check power brake booster vacuum line.if look good remove brake booster check valve.blow through it.if you can replace it.if not its okay.a bad or dead fuel fuel injectors will cause engine to stall out.

Jul 05, 2009 | 1999 Dodge Intrepid

2 Answers

Loss of Power


Hey you need to go buy a fuel pressure gauge, there not expensive, and doesnt take a roket scientist to install. If you suddenly just lost power it would have nothing to do with your PCM(ECU). if your fuel pressure is low then you might want to replace your lift pump. If its still powerless, then go out and spend some money cause you have overworked your injection pump. but the first thing you should do is simply change your fuel filter. Good luck!!!

Jun 29, 2009 | 1999 Dodge Ram 2500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...