Question about 1994 Plymouth Sundance

Open Question

1994 plymouth sundance 2.2 map sensor located?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 124 Answers

SOURCE: Replacing the heater core on a '88 Plymouth Sundance?

Behind the dash. You will have to pull the whole dash assembly. It looks like a little radiator.

Posted on Mar 28, 2009

  • 64 Answers

SOURCE: Where is the speed sensor location on a 1999 plymouth grand

<img src' "http://www.2carpros.com/forum/automotive_pictures/170934_plymouth_voyager_1.jpg" />
This is a diagram of where and what it looks like. Its located on the back side near the firewall on your transmission. GOOD LUCK!

Posted on Sep 14, 2009

  • 7353 Answers

SOURCE: What does a MAP Sensor look like, where is it

So you dont know where it is, or what it looks like, but you know its bad, and need to replace it? Its on the end of the intake plenum, 3 wires, once you find it, you will figure out how to replace it.

Posted on Oct 14, 2009

  • 14036 Answers

SOURCE: where is the relay located for the turn signals on

your fuse block is located behind the steering column cover acessible by removing the fuse access panel above the hood latch release lever.the relay and flasher module is located behind an access panel in the glove box.included in the module are hazard and turn signal flashers along with time delay and horn relays.you have additional relays mounted on the inner fender panel near the battery and strut tower.

Posted on Dec 14, 2009

ZJLimited
  • 17970 Answers

SOURCE: Where can I find the map sensor in a 1994 plymouth

For 1994 Plymouth Truck Voyager 2WD 3.0L MFI 6cyl the MAP Sensor is located under hood, passenger side, upper engine area, end of intake manifold cover, mounted next to alternator on engine.

Hope helps (remember rated this).

Posted on Jul 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is the M A F SENSOR PLYMOUTH 93 SUNDANCE


chrysler does not use a MAF sensor on any of there engines. They use a MAP sensor (mass air pressure). What engine to you have?

Jul 26, 2012 | 1993 Plymouth Sundance

1 Answer

Timing mark for the timing belt for a 1994 plymouth sundance


i need to find the timing marks are for a 94 plymouth sundance

Mar 04, 2011 | 1994 Plymouth Sundance

1 Answer

Code 51 on a Plymouth sun dance. How do I fix it?


Code 51 = Oxygen sensor stuck in lean mixture mode. ( this will often cause engine to run rich due to oxygen sensor telling engine controller that it is running lean, thus send more fuel) This may be caused by M.A.P. sensor as well, so check vacuum lines and clean connections on MAP sensor first. It should be one of 2 things, Fault from MAP sensor, or faulty oxygen sensor.

Nov 01, 2010 | 1990 Plymouth Sundance

1 Answer

Where can I find the map sensor in a 1994 plymouth voyager


For 1994 Plymouth Truck Voyager 2WD 3.0L MFI 6cyl the MAP Sensor is located under hood, passenger side, upper engine area, end of intake manifold cover, mounted next to alternator on engine.

Hope helps (remember rated this).

Jul 05, 2010 | 1994 Plymouth Voyager

2 Answers

Where is the fuel filter


To the rear of the gas tank under the car.

Oct 20, 2009 | 1994 Plymouth Sundance

1 Answer

Where and how the o2 sensor goes on a 1994 plymouth sundance


Oxygen sensor is going to be on your exhaust somewhere between the exhaust manifold and right before it goes into the catalytic converter. Some of them screw in

Oct 10, 2009 | 1994 Plymouth Sundance

1 Answer

Suddenly stop turning over have power to starter switch etc. but won't start friend says that clutch sensor is dead but I don't know what I'm looking for. I've got half of the dash apart still not fin


Clutch position sensor? Never heard of one. There is a switch on the pedal arm that won't let you crank the engine unless the clutch is depressed. Do the headlight test. Turn on you headlights and push in the clutch and crank over the engine. If your lights dim, your battery is low, If the lights go out uou have a loose battery connection or poor cable to battery contact. If they do nothing, then you need to ck the clutch switch. I would say it is number 2

May 20, 2009 | 1994 Plymouth Sundance

1 Answer

88 Plymouth Sundance


I don't have a manual for the 1988 Plymouth Sundance, but I'll see what I can find.  You would replace it.  If you/your daughter plan to keep the car for a whle (and you plan to be her mechanic), I would recommend purchasing a Haynes manual for it.  As soon as my vehicles' warrantees expire, I buy the manuals. The MAP (Manifold Absolute Pressure) sensor is usually connect to the air duct near the intake manifold.  Looks like for your car they run from $40-$70, depending on your engine size and turbo or not.  Good luck!

Jan 25, 2009 | 1988 Plymouth Sundance

Not finding what you are looking for?
1994 Plymouth Sundance Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...