Question about 1996 Dodge Ram

1 Answer

Windshield wipers not working, can't find fuse?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 379 Answers

Some times there are no fuses if that the case you have a bad windshield wiper motor just replace and it should work


but before u do that be sure to make sure that you have check for a fuse for it

Posted on Nov 27, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: windshield wiper fuse blows everytime I turn the ignition on

YOU MIGHT HAVE A SORT TO GROUND.A WIRE MIGHT BE LOOSE AND TOUCHING SOMETHING ELSE I WOULD HAVE A PRO TAKE CARE OF THIS PROBLEM

Posted on Apr 07, 2009

  • 192 Answers

SOURCE: can't find fuse box for horn,turning signal and windshield wiper

I looked this up on WikiAnswers. Apparently the 2005 dodge magnum has 2 fuse boxes. One is under the hood on the passenger side and the other is in the trunk, next to the battery, in the spare tire storage well.

Posted on May 11, 2009

motor1258
  • 6674 Answers

SOURCE: windshield wiper fuse blows everytime I turn the ignition on

Try removing the harness connector to the motor, and see if it still blows the fuse, then you've isolated the problem.

Posted on Jun 05, 2009

  • 67 Answers

SOURCE: Front Windshield wipers do not turn on

better diagnostic with scanner in body control mode there its posible to test wiper relay,motor ectr,its better than be replacing parts,

Posted on Nov 23, 2009

  • 289 Answers

SOURCE: windshield wiper turns on when car starts, then won't stop

The van is now about 13-14 years old, chances are that the switch has worn to a point that the finite metal particles are shorting it out causing it to be on all the time. Re and clean the switch contacts, you should be good to go. Please let me know how you make out. Good luck..

ash

Posted on Jan 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wipers will not turn on 2006 colorado


There are two relay's in the under hood fuse / relay box . Wiper relay an wiper relay 2 . Maybe one is bad . also check fuse #14 25 amp. Wiper fuse.Plus the BCM - body control module has a hand in making the wipers work . Are you familiar with automotive electronic control modules ?
The Wiper/Washer System consists of the following components:
• Windshield wiper/washer switch
• Body control module (BCM)
• Wiper micro relay
• Wiper 2 relay
• Wiper diode
• Windshield wiper motor
• Windshield washer pump
• Windshield washer nozzles
• Windshield washer solvent container
• Windshield wiper arm and blade assemblies
• Windshield wiper transmission
• WIP/WASH 10A fuse
• WIPER 25A fuse

Wiper/Washer System Description
The body control module (BCM) controls wiper motor low speed operation. The washer pump and high speed operation are controlled directly by the wiper/washer switch. The windshield wiper/washer switch supplies voltage on the signal circuits to the BCM for windshield wiper/washer operation. When WASH, MIST, DELAY, LOW, or HIGH is detected, the BCM energizes the wiper micro relay by suppling voltage to the relay coil. This allows battery voltage from the WIPER fuse to flow through the relay switched input then through the contacts and out the relay switched output to the wiper 2 relay switch contacts. Since the wiper 2 relay switch contacts are normally closed to the low speed circuit of the windshield wiper motor, the motor will operate at low speed.

Do you have any speed !

Oct 06, 2017 | Cars & Trucks

1 Answer

Front windshield wipers not working. which is the correct fuse to check and the amp?


The fuse for the wipers is under the hood. And it is a green 10 amp fuse for it.

Feb 21, 2015 | 1998 Dodge Caravan

1 Answer

My 1995 Ford Ranger's windshield wipers don't work


That involves airbag removal & a lot of delicate work. Let someone experienced handle it.

Jul 15, 2017 | Ford Ranger Cars & Trucks

1 Answer

My windshield wipers don't work, where is the fuse for it


my 07 is fuse under dash number 41 look in your manual it will show you where it is located

Jul 15, 2012 | 2009 Scion tC

1 Answer

Windshield wipers work when fuse is in but won't turn off unless you remove the fuse. Won't pass inspection. Help!


Check the relay relay maybe latched on. See if there is an identical relay in the box and swap them if problem goes away replace relay.

May 23, 2012 | Ford Escort Cars & Trucks

2 Answers

1998 Toyota Sienna Windshield Wipers not working


The fuse is the 20 amp WIPER fuse, located in the fusebox under the driver side of the dash, farthest on the left, 2nd one up from the bottom.

Jan 02, 2009 | 2008 Toyota Sienna

Not finding what you are looking for?
Cars & Trucks Logo

460 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...