Question about Cars & Trucks
Get a circuit tester and have somebody crank the engine go to starter small wire check for voltage when hiting ignition if no power bad relay or bad wire easy way to fix if wire just replace the wire all way from suitch to starter ok need more help let me know
Posted on Nov 27, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1998 buick lesabre wont start
Do you have a Chip in the Key? if so that Could be the Problem,Ya see the chip is a resistor and if it looses its ELECTRONIC VALUE in its Case Resistance it wont start to test this Turn the Key in the ON posission then do the Screwdriver thing If it Starts Key is Good and Most Likely the Ignition (SWITCH) is Bad <<ELECTRICAL Side NOY LOCKEST SIDE For More Info Recontact Me
Posted on Jan 21, 2009
Get a test light, and see if your starter has battery power, (big wire/stud) on starter. itll light up if you do. then there should be a little wire. thats your igntion switch wire. have someone start your car while you testing the little wire. if the light comes on. then your starter is probably bad, even if its new they still can be bad. If it doesnt light up then, you need to locate the starter relay in engine compartment,I should have one. test to see if it clicking when you try to start it. youll feel it. If not pull it out and test to see if you have power. do the same test with someone starting it and see if you light comes on. If it comes on then replace the relay. and you could try and see if your ignition fuse is ok. I hope this gets you started. if not right back were your stuck at.
Posted on Apr 12, 2009
If you look under the hood, there is a starter relay that might be the problem - but more common than that, - Do you have an alarm system of anykind? If so, It sounds alot like that is the problem, and they are notorious for causing "no start" problems as such - Unfortunatey, the wiring for these (even to just remove one) can be rather involved (as they often cut the starter wire to install an interrupt) so you may have to take it to an auto electric shop, or one that specializes in alarm systems - Also, dealers sometimes install special "electronic lot key systems" in all of their new cars, requiring that the "electronic key" must be present in the vehicle (along with the correct physical key) in order for it to start - I'd check for one of those systems as well - Hope that helps...
Posted on Aug 29, 2009
SOURCE: My 1999 nissan altima won't
1999 Nissan/Datsun Altima 2.4L SFI DOHC 4cylNo Start when Ignition key ON, check "inspect" this items:
1. Ignition Switch: Improperly Connected or Faulty Ignition Switch.
2. Battery: Battery Discharged or Faulty or Coroded, Broken, Shorted or Poorly Connected Battery Cable.
3. Solenoid Switch: Starter Solenoid Switch Faulty.
4. Starter Starter Motor Faulty.
5. Wireset: Worn or Damaged Spark Plug Wires.
6. Coil -Ignition-: Faulty Ignition Coil.
7. Distributor Cap: Loose, Cracked or Worn Distributor Cap.
8. Spark Plug: Incorrectly Gapped or Fouled Spark Plug(s).
9. Distributor Cap and Rotor Kit: Loose, Cracked or Worn Distributor Cap.
10. Carburetor: Worn, Faulty or Damaged Carburetor.
11. Fuel Pump Faulty Fuel Pump.
Send news about this.
Posted on Sep 02, 2009
SOURCE: no spark on a 1996 vw jetta
With a volt meter,check for positive 12V on the coil.
post to body metal ground when the KEY is at on position.
Check alarm for ignition and/or start cut off.
Bad relay on alarm cut off (Bosch type relay)
Posted on Dec 14, 2009
Tips for a great answer:
Feb 05, 2015 | Cars & Trucks
Feb 13, 2014 | Volkswagen Beetle Cars & Trucks
Nov 24, 2013 | 1996 Honda Civic
IGNITION KEY WILL NOT RELEASE
can be faulty ignition lock cylinder. I suggest to wiggle the steering wheel
a bit and see if the key gets released out. If that is not helping
then first turn steering wheel to right and try removing the key, or next turn
steering wheel to left and see if you can remove the key.
wd-40 in the ignition key hole and let it remain there for few minutes, after
that once again try to remove the key and see if that helps.
if that is not helping then ignition lock cylinder has to be removed out and
key has to be manually removed.
more troubleshooting on these types of issues, I suggest you to refer the help
links mentioned below. Its the accurate solutions mentioned in it. That will
help you to narrow the problem: -----
the link below: ------
Camry: Key Will Not Come Out Of Ignition?
2001 Toyota Tacoma:
Ignition Switch Will Not Turn Off?
Car will not turn the ignition to start?
Ignition Key OFF but engine still running?
Key Stuck in ON position?
2012 Dodge Ram: Ignition Key will not release?
Ignition locked up on Mercury Villager?
Key won't turn in the ignition on Toyota
How to remove ignition switch on VW Car models?
How to Replace Ignition Switch on Chevrolet Caprice Classic?
1995 Ford Taurus: Ignition switch not turning OFF?
Ignition Problem Troubleshooting
Feb 15, 2013 | 1999 Volkswagen Jetta
How to remove ignition switch on VW Car models?
Nov 28, 2012 | 2010 Toyota Corolla
Sep 07, 2012 | 1999 Cadillac DeVille
Jul 23, 2012 | 1999 Ford Super Duty F 450
Apr 16, 2011 | Isuzu Rodeo Cars & Trucks
Jan 20, 2011 | 1999 Oldsmobile Alero
May 20, 2010 | Cars & Trucks
267 people viewed this question
Usually answered in minutes!