Question about 2008 Chevrolet Aveo

2 Answers

Check Engine Light Code P2135, what could be the possible cause or causes?

The check engine light come on after resetting the light usually stumbles and hesitates. This continues every time the car isn't warm and usually settles out once warm. Have even had the check engine light extinguish for periods and then eventually come back, I take it that there isn't a latch to the relay on the light???

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 36 Answers

May Solar term door position sensor problem, is probably the solar term door things, solar term door initialization method, the solar term door was reset (reset method: open the key block second, is the instrument indication full bright that a block, then wait 20 seconds, step on accelerator, maintain 10 seconds, release the accelerator pedal, switch off the ignition, the key is pulled out, the initialization is complete. Use obd2 for automotive diagnostics , you can improve vehicle safety performance and driving more safer.

Posted on Dec 09, 2013

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,674 Answers

I would start by stopping or calling a dealer regarding recall/technical service bulletin regarding your throttle position sensor. Have you VIN & Mileage ready, to see if it's covered under powertrain warranty.

Posted on Nov 27, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 22 Answers

SOURCE: does the check engine light reset itself once the

If you are a DIY'er you can get a OBDII scan tool that connects to your laptop that can tell you the error code and allow you to reset your check engine light. This will save you $80 each time over going to a mechanic for a diagnostic. They are easy to use and will help you know what the issues are if you do have to go to a mechanic.
Check out http://www.fitityourself.netau.net/OBDII.html
Or you can try disconnecting your vehicles negative battery lead for 5 minutes. That should clear the code. if you check engine light comes back on after several days, you still have a problem

Posted on Apr 14, 2010

emissionwiz
  • 79123 Answers

SOURCE: Chevy aveo error codes. I have a check engine light on.code p2135

P2135 Throttle Position Sensor (TPS) Property Malfunction, remember this is not a car that is built by GM it is a Korean import.

Posted on Jun 07, 2010

pctech1
  • 1940 Answers

SOURCE: check engine light on- auto

The code P0053 is for your Bank 1 Oxygen Sensor, the closest Oxygen Sensor to the engine, connected to the Exhaust. Replace your Oxygen Sensor, clear the code, and see if it comes back.

Posted on Mar 12, 2011

redds55
  • 2620 Answers

SOURCE: 2002 Impala LS... check engine

A faulty throttle position sensor or an intake air leak near the mass air flow sensor.

Posted on Aug 09, 2011

pchambley
  • 334 Answers

SOURCE: 04 impala ss once it's warm check engine light

Need to get the codes..But first guess is the oil pressure switch

Posted on Sep 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can cause the check engine light to be on?


Circuit Range Performance error.

When is the code detected? Malfunction is detected when an excessively low or high voltage from the sensor is sent to ECM. Possible symptoms Engine Light ON (or Service Engine Soon Warning Light) P0121 CHEVROLET Description The throttle position sensor (TPS) responds to the accelerator pedal movement. This sensor is a kind of potentiometer which transforms the throttle position into output voltage, and emits the voltage signal to the Engine Control Module (ECM). In addition, the sensor detects the opening and closing speed of the throttle valve and feeds the voltage signal to the ECM. Idle position of the throttle valve is determined by the ECM receiving the signal from the throttle position sensor. This sensor controls engine operation such as fuel cut. On the other hand, the Wide open and closed throttle position switch, which is built into the throttle position sensor unit, is not used for engine control.

Read more: https://www.autocodes.com/p0121_chevrolet.html


https://www.autocodes.com/p0121_chevrolet.html

chevrolet code was P0121 Google Search

Sep 04, 2017 | Chevrolet Cars & Trucks

1 Answer

2001 ford taurus 3.0 v6 code p0306 misfire


Please go to this page for engine misfire causes.

Aug 08, 2012 | 1997 Ford Taurus

2 Answers

I have codes: po455, po123. po406 po606.p2104, po2106, p2110, & p2135 help please!


(so i cleared the code..all was fine.) No it wasn't ,you don't just clear code's without doing the diagnostic's for that code . It's just a matter of time ,when the PCM/ECM - engine computer runs that test again, that light will come back on. P0455 is a large leak in the evaporative emission system .Sorry dude but you don't stand a snow ball's chance in guam of fixing this .
Do you know what electronic throttle control is ?
P2135 - ETC Throttle Position (TP) Sensor A/B Voltage Correlation Description: The powertrain control module (PCM) flagged a fault indicating that TP1 and TP2 disagree, or that TP1 should not be in the present position given the position of TP2 unless a concern is present. Possible Causes:
  • TP sensor shorted internally to VREF.
  • TP sensor harness is shorted to power.
  • TP sensor signal wires are shorted together.
  • Damaged TP sensor.
Diagnostic Aids: Compare the TP1 and TP2 PID values for a full sweep and correlation. Refer to the chart in pinpoint test DV. GO to Pinpoint Test DV .
Compare TP1 and TP2 PID values to the typical reference values in Section 6 . Application Key On Engine Off Key On Engine Running Continuous Memory All GO to DV4
P2110 - Throttle Actuator Control (TAC) System - Forced Limited RPM Description: The TAC system is in the failure mode effects management (FMEM) mode of forced limited RPM. Possible Causes:
  • Cross-wired TAC motor.
  • Damaged powertrain control module (PCM).
Diagnostic Aids: This DTC indicates only that the FMEM condition exists, and can be set in combination with DTCs P2100, P2101, or P2107, meaning the electronic throttle body (ETB) faults should be diagnosed first. Application Key On Engine Off Key On Engine Running Continuous Memory All GO to QE1
Do yourself a favor an take it to a qualified repair shop.

Nov 08, 2017 | 2005 Mercury Mountaineer

1 Answer

Car has little power, burning an extreme amount of gas, makes rumbling noise, and engine light is on. I have had new spark plugs and an enginge coil put on it and it is still doing the same thing.


if check engine light is on, get it scanned to find problem code. if no scanner most auto parts stores will scan for free. just get the codes from them to see what is wrong! you can start at airfilter and continue to throttle body to see if all is ok. there are a few causes for this, so have it scanned if light stays on.for instance- a maf sensor causes poor running, it will set a code or check engine light will come on, lack of power, buck/****, hesitation/stumble on acceleration, a bad cam sensor will throw off spark timing which will impact fuel econony. and cause engine to misfire and poor acceleration. this code will also set check engine light on. so get it scanned to find problem code. have a good day !

Apr 25, 2011 | 2005 Chevrolet Cobalt

1 Answer

My chevy aveo 2008 has a check engine light and the code 2135 comes up


CODE P2135 THROTTLE POSITION SENSOR 1 - 2 CORRELATION ERROR CONDITIONS, POSSIBLE CAUSES TP SENSOR 1 SIGNAL LOW REFERENCE OR 5V VREF CIRCUIT IS OPEN, TP SENSOR 2 SIGNAL LOW REFERENCE OR 5V VREF CIRCUIT IS OPEN, TP SENSOR 1 SIGNAL CIRCUIT IS SHORTED TO THE TP2 SIGNAL CIRCUIT, THROTTLE BODY ASSEMBLY IS DAMAGED OR IT HAS FAILED.

Apr 03, 2011 | Chevrolet Aveo Cars & Trucks

1 Answer

I have a hyundai sonata 2007 limited My car has both the esc off and the check engine lights on check engine is always on when the esc off light turns on the car runs very slow, it doesnt accelerate even...


TSB # 08-FL-004-1 CHECK ENGINE LIGHT P2135 DTC DIAGNOSIS....
there is a problem with the pedal assembly which has your throttle position sensor causing the codes, dealer only part you can install yourself with some know how

Mar 10, 2011 | Hyundai Sonata Cars & Trucks

2 Answers

Trouble code P0320 ignition/dist. engine speed input circuit


P0320 - Ignition / distributor engine speed circuit malfunction

The ignition engine speed sensor input signal to Powertrain Control Module (PCM) or Electronic Control Module (ECM) is continuously monitored. The test fails when the signal indicates that 2 successive erratic profile ignition pickup (PIP) pulses occurred.

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- The engine may stumble or stall

When is the code detected?
The P0320 code is triggered when 2 successive erratic PIP pulses are detected.

Possible Causes:
- Loose wires/connectors
- Faulty Crank Position Sensors
- Arcing secondary ignition components (coil, wires and plugs)
- Low battery charge
- Powertrain Control Module

Possible Solutions:
- Resecure loose wire or connectors
- If battery charge is low, recharge or replaced battery
- Replaced crank position sensor
- Replaced starter motor


Test it and tell us news.

Nov 18, 2010 | 2004 Ford Explorer

1 Answer

Chech engine light code says # 2 misiing


Misfire 2 Cyl generated DTC P0302 Code - Cylinder #2 Misfire

A P0302 code means that the the car's computer has detected that one of the engine's cylinders is not firing properly. In this case it's cylinder #2.

Symptoms may include:
* the engine may be harder to start
* the engine may stumble / stumble, and/or hesitate
* other symptoms may also be present

Causes: A code P0302 may mean that one or more of the following has happened:
* Faulty spark plug or wire
* Faulty coil (pack)
* Faulty oxygen sensor(s)
* Faulty fuel injector
* Burned exhaust valve
* Faulty catalytic converter(s)
* Running out of fuel
* Poor compression
* Defective computer

Possible Solutions: If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.

If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Hope helps (remember rated this).

Jul 19, 2010 | 1999 Chevrolet Malibu

Not finding what you are looking for?
2008 Chevrolet Aveo Logo

405 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...