Question about 1997 Toyota RAV4

Open Question

How to replace fuel filler neck on a 1997 rav4

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1997 rav4 fuel filter location?

i just got done replacing my fuel filter on my 1997 rav4 and i didnt need any special tools. sockets and wrenches. no leaks and everything is fine. you just need patience and descent skills with tools.

Posted on Nov 26, 2008

motor1258
  • 6674 Answers

SOURCE: filler neck needs replacing\corrosion was the problem

On a 2006? Have you spoken to Toyota regarding this? Call owner relations number in manual. Unless it's been sitting in salt water for 3 years.

Posted on Jun 12, 2009

  • 103 Answers

SOURCE: fuel tank leaks gas when topped off

filler neck may have hole in it

Posted on Jan 02, 2010

  • 14 Answers

SOURCE: fuel filler neck location on 04 avalon

just behind the fuel flap

Posted on Jun 18, 2010

  • 77 Answers

SOURCE: When fueling my 2007 Toyota

look 4 a crimp in vent line there is a vent line that goes 2 a canester try un hocking it if it solves problem change canister it pluged

good luck

Posted on Apr 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge grand caravan 2005 filler neck replacement


1)Block front wheels.
2)Jack up the left rear tire off of the ground.
3)Put blocks up under the frame.
4)Take off the left rear tire.
5)Take out the plastic liner in the fender well that covers the fuel filler neck.
6)Loosen up the hose clamps on the rubber fuel filler hoses. (at the neck side); once the clamps are off plan on buying new ones. This next part of the job is VERY IMPORTANT! use a flat screwdriver and pry 360 degrees all around the rubber filler neck hoses. (they get kinda glued on from being on there so long). Next Get some PB Blaster lube or WD-40 (it has to have the small red squirt hose) and spray the lube up in between the hoses while you pry around. the more you do this the easyer it will be to pull the metal filler neck pipe out.
7)Now its time to take out the 4 bolts that hold the pipe on.
Use a 10mm socket and extension to take out 4 bolts up top behind the fuel filler door.
8)Pull the filler neck out and put everything back together the way it came apart and your done!

Aug 26, 2016 | 2005 Dodge Grand Caravan

1 Answer

How to replace seal on the fuel tank that filler tube goes into on 1997 Lincoln town car


You need to remove the filler neck, it has screws I think inside the gas fill door. Pull it out of the fuel tank, go under the car and remove the old rubber donut seal where tube enters the fuel tank, spray some car cleaner on the rubber and as quickly as possible insert the tank fill tube and put it all back together.

Jul 19, 2016 | Lincoln Cars & Trucks

2 Answers

Fix fuel pump


Removal & Installation To Remove:
  1. Properly relieve the fuel system pressure.
  2. Drain the fuel tank through the filler pipe.
  3. Support the fuel tank.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Filler neck
    • Shield and tank straps
    • Fuel lines and vapor hose from pump and tank
    • Electrical connection from fuel pump
    • Fuel tank
    • Fuel pump/sending unit assembly by turning the locking ring (located on top of the fuel tank) counterclockwise using a spanner wrench
    • Fuel pump from the fuel lever sending device
To Install:
  1. Install or connect the following:
    • Fuel pump in tank with new seal around opening
    • Tank and connect fuel lines and vapor hose
    • Tank to the frame
      1. Torque to: 33 ft. lbs. (45 Nm)
    • Shield
    • Fuel filler neck and clamp
    • Negative battery cable
  2. Refill the tank.
  3. Run the engine and check for leaks.
View of the in-tank fuel pump assembly. 7924jg21.gif

prev.gif next.gif

Nov 06, 2010 | 1997 GMC Jimmy

2 Answers

Fuling problem, gas backs up in filler and cuts off, hard to fill with fuling cutting off every 3-5 seconds.


That would be your carbon canister. You will need to replace that to fix your problem. It will be somewhere between your fill opening and the gas tank. Look for a line running from filler tube that would be it. Also you may have an access hole for your fuel pump in trunk, if you do, you can probably see the top of it in the direction of your filler tube. Hope you find it. Shouldn't be to bad, but that is your problem.

Nov 04, 2010 | 1997 Plymouth Breeze

1 Answer

How to replace fuel pump


Empty fuel tank, support fuel tank, remove straps from tank (you'll probably have to replace those). Remove fuel filler neck from inside fuel door or at tank, drop tank, remove wire clips and fuel lines as necessary, remove fuel pump, put new pump in. Installation is reverse.

Jun 27, 2010 | 1997 Plymouth Breeze

1 Answer

What can i do to fix the problems of po440,441 and 446?


Hello, and welcome to FixYa. Please allow us to assist you.

You have a verry common condition; we see this quite often.

The codes you mention are usually caused by one (or a combination) of the three things that follows.

1. You do not have the 'factory' fuel tank cap fitted to the car; 'Aftermarket' fuel caps do not seal properly, and the leak of thefuel fumes under the cap will light the light.

2. The o-ring that seals the cap to the fuel filler neck is worn, or otherwise compromised, which will also allow the fumes to escape and light the light.

3. There could be rust on the filler neck tube, which would not allow a tight seal between the cap
s o-ring seal and the filler neck.

I would recommend replacing the fuel cap with a factory replacement, and inspect the filler neck sealing surface for rust buildup. If you see rust, a replacement filler neck will be in order.

Thanks for choosing FixYa fo assistance today.

Jun 10, 2010 | 2001 Toyota Corolla

1 Answer

Gas filler neck replacement


open the fuel cover and remove the bolts.Remove the ground strap from the filler tube from under the car.Remove the hose clamps to the rubber hose going into the tank and pull off the hose.Now the filler tube will come out[ if has'nt already fallen out and hit you in the head].

Nov 18, 2009 | 1997 Oldsmobile Cutlass Supreme

1 Answer

Gas cap is contacting inside of filler neck


YES IT CAN FROM THE RUBBER HOSE UP TO WHERE YOU PUT THE GAS IN

Aug 07, 2009 | 2007 Mercedes-Benz E320 BLUETEC Sedan

1 Answer

How to change dodge neon fuel filler neck? The old one on my 1997 SOHC rusted off and messing my fuel system.


unbolt the neck from the body of the car. Drop the gas tank enough to get the neck out. Reinstall.

Mar 10, 2009 | 1997 Dodge Neon

Not finding what you are looking for?
1997 Toyota RAV4 Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...