Question about Cars & Trucks

2 Answers

Astrostart won't start the car

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You may need to reset the system.

SEQUENCE ACTIVATED BY THE PARKING BRAKE .
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply the parking brake Once Twice
Note: The system can be set - at time of installation - to require that the parking brake be applied once or twice.
If set for two actuations, pause one second between the two.
4. Remove key from ignition (the system keeps the engine running).
5. Exit the vehicle.
6. Within 60 seconds, close all doors.
7. The system will stop the engine and blink the parking brakes once to confirm the sequence is valid (vehicle is
ready for a remote start command).
SEQUENCE ACTIVATED BY THE REMOTE CONTROL
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply parking brake.
4. Send the start command (Model 801 & 2101 - Model 903 ).
5. Remove key from ignition (the system keeps the engine running).
6. Exit the vehicle.
7. Using the remote, send the STOP command. The system will stop the engine and parking lights will blink once
to confirm that the sequence is valid (vehicle is ready for a remote start command).
http://www.astrostart.com/Support/Guides.aspx

Posted on Jan 28, 2013

Ad
  • Level 1:

    An expert who has achieved level 1.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Check your battery,or not clean battery terminals,or starter motor solenoid.

Posted on Apr 23, 2014

  • dean hanson Dec 02, 2014

    If any of the above were causing the problem the vehicle would not start with the key which I assume it does!

×

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

elshaddai159
  • 1016 Answers

SOURCE: My car was running, then

Hi,
You need to have the cam angle and crankshaft position sensors checked. These are 2 parts which enable the ignition system to fire. If these are ok then check that the rotor in the distributor is turning when you crank the engine.
If it is not turning then you have a cambelt/chain or gear problem which you will need to repair before it will start again.
Hope this helped.
Thanks
Jason

Posted on Jul 20, 2011

johnf1aresti
  • 1104 Answers

SOURCE: Car won't start. Gages bounce quickly & make a clicking sound on 2006 ford taurus

check your battery,or not clean battery terminals,or starter motor solenoid.

Posted on Aug 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an Astrostart hst5224, It will star then immediately shut off. My jeep is A manual transmission


[PDF]MODEL RSS-5225 - DirectedDealers.com

www.directeddealers.com/manuals/OG/Astrostart/RSS-5225_OG-Eng.pdf
Immediately report any malfunction to the AstroStart dealer that performed the ... Always turn off the main switch when not using the remote starter for .... The startmodule will inform you of the status of door locks, the alarm and of the engine. .... If the trunk is opened for more than 5 minutes, the system switches to the.

How do you reprogram an AstroStart remote HST5224

www.answers.com > Wiki Answers > Categories > Cars & Vehicles
In order to reprogram an AstroStart HST5224 remote, you must putthe key in the ignition ... lamp) b, press and hold UNLOCK button, after 1 second key LED will flash once c, .... C. Turn the ignition to ON (Do NOT Start) then back to OFF. ... B.Immediately after letting go of the lock and unlock buttons, press the lock button by ..

Nov 24, 2015 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

98 Pontiac Bonneville intermitanly stalls & won't restart.


If you have a vats system (anti-theft) it needs to be reset

May 05, 2017 | 1998 Pontiac Bonneville

1 Answer

My 2004 chevy venture won't start. Changed the


Did the fuel pump come on?

Did you check fuel pressure at the motor?


Try jumping the relay to get pump on?

Read a wiring diagram-- so you know what your doing?

Check Power & Grounds to pump when the tank was down?

Dec 22, 2012 | Cars & Trucks

1 Answer

I have an astrostart remote hst5224 that has a new battery and it beeps...but nothing else


This remote can operate up to four different vehicles, the default is 2, make sure you are in the correct mode. This is changed by pressing the "P" button on the back of the remote for two seconds, each press advance the mode one position. do this till you find the one that works. There are only four to try

Oct 03, 2012 | Cars & Trucks

1 Answer

Loud knocking


Sort of sounds like the timing belt broke-- if you have one

The valves may have hit the pistons & that is why it won't turn over

I don't know any of that is true & won't wish it on anyone,but
it is a place to start

Sep 13, 2012 | 2001 Saab 9-3

1 Answer

Astrostart 2100 autostart will not work all the time


It would almost appear that your battery is weak. If the engine doesn't freely turn over the remote start will not work because it recognizes the problem. I would also hope that you plug in your block heater when it's really cold.

Feb 06, 2012 | Chrysler Town and Country Cars & Trucks

1 Answer

Hello. My 1997 Chevy Tahoe refuses to start. The problems began with a bad fuel pump. I changed. It worked. The fuel pump died again. I changed it again and it has been working. I parked it for two weeks....


Now you have a good battery & a starter that turns over the motor

Have you cycled the key on & off with a fuel pressure gauge on the
fuel rail?

Do you have a fuel filter that isn't over 3 or 4 years old?

Have you checked for spark while cranking ? Use an old plug on the wires,
if you have ignition wires,don't ground the wire without resistance

If you removed the ducting & MAF Sensor it won't start

Tell us what you checked & exactly how that was done.

Jun 09, 2011 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

5,118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...