Question about 2005 Honda Accord
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check 7.5 fuse (#8) inside the car by your left foot and check the 30 amp fuse in the engine compartment (according to your diagram on the inside of your fuse box lid).
You can replace the fan motor pretty easy but you'll want to unplug it and test it first by running an automotive battery to the plugs of the fan with 2 jumper wires. The fan is above the right foot of the passenger area. There are three 8mm screws to remove then it drops out. Careful with the wiring.
If your fan is still good, you'll have to consider removing your knob and switch assembly to see if something is unplugged in there. Good luck.
Posted on Oct 03, 2009
if your not getting any air coming out of the vents then your problem is your blower motor. test the wire harness to see if its getting power,if it is then your blower motor is bad if its not getting power then check your relay.
Posted on Jan 17, 2009
The part from the dealer is $180.65 ,labor is .5 hours about $50. If you go to a independent shop the cost should be less:)
Posted on Nov 24, 2009
If the fuse is good,check to see if there is voltage to the blower motor,if there is,replace the blower motor.Sometimes,not always,if you bump the blower motor,it will start working,if this happens,then the blower motor is bad,if it does not,the fan switch could be bad,but the relay is usally near the blower motor.Testing it with a test light is the best way to test it,ground one end of the test light,the other end has a point on it.Use the piont of the test light to touch all the legs on the relay,with the key on,and the fan on high.The test light will light up,on almost all the legs,but it will also activate the relay when you touch the right leg of the relay,the relay needs to stay plugged up as you do this.If you can not access the legs of the relay,because of a skirt on the relay,push the point of the relay into the wire that you are testing,or into the plug,near the leg of the relay.The legs I am refuring to,are the prongs on the relay.If the relay clicks and turns the fan on,when you touch the right one,then the fan,and the relay are good,it will be the blower fan switch.Now if you already have high,blower fan,and the lower speeds are the problem,replace the blower resister,It is mounted right next to the blower motor,and has about 7 wires plugged into it.
Posted on Jan 09, 2010
Tips for a great answer:
on Jun 21, 2011 | Honda Accord Cars & Trucks
HEATER BLOWER MOTOR
faulty blower motor resistor. The low and medium speed on blower motor is
controlled by resistor and its actual speed is high. So because resistor is not
working, blower motors actual speed which is high is working.
can be faulty blower motor or faulty blower motor resistor. Get the blower
motor inspected. If it's faulty it has to be replaced.
blower motor testing and replacing, check the link below: ----
These will help.
Nov 28, 2012 | 1988 Honda Accord 4 Door
Nov 01, 2011 | 1991 Honda Accord
Nov 13, 2010 | 2005 Jeep Grand Cherokee
Mar 06, 2010 | 1991 Honda Accord
Oct 22, 2009 | 1996 Honda Passport
Jan 16, 2009 | 1994 Honda Accord
217 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: