Question about 2011 Honda Odyssey EX-L

Open Question

2011 odyssey passenger heated seat goes off when drivers seat is turned on

Passenger seat heats for a short time then turns off it also turns off when drivers seat is turned on no problem with drivers heated seat

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: heated seat switch bulb replacement

Had the same problem. Bought a new switch online for about $20. Remove the trim piece around the shift knob and then you can easily disconnect the switch and replace it. To remove the trim piece, start from the top and work your way towards the back of the car. There are three clips that hold it in place on each side and it will just pop off easily.

Posted on Mar 08, 2009

Ad
  • 295 Answers

SOURCE: How can I turn off the passenger airbag?

The air bag is unable to disconnect.
The vehcile should not be tampered.

Posted on Apr 30, 2009

  • 32 Answers

SOURCE: Passenger side heated seat switch lamp burnt out

Its simple. you need to pop up the surrounding area of the shifter unit . everything is in place with clips so you will need something plastic but soft enough to not scratch or crack anything. perhaps a toothbrush handle. find something to get leverage on and pry. it should pop up, exposing the switch. You will notice a tiny circular thing behind the switch. those turn and allow the tiny bulb to come out.

Posted on Nov 07, 2009

citroenchris
  • 600 Answers

SOURCE: i also neeed to change

I have changed the lamps in a couple of the lock/unlock switch in the doors, the rocker does not come off without breaking,that said on some makes (Honda use more than one) you can unclip the back of the switch and there are 3 liliput bulbs soldered on the small circuit board, somewhere like Radio Shack sell them.

Posted on Jan 12, 2010

K42282
  • 98 Answers

SOURCE: MY DRIVER'S SEAT ONLY HEATS THE BACK PORTION AND

-The passanger seat only heat the bottom of the seat. It does not have a heat pad in the back portion.

-For the driver seat, it sound like the bottom heat pad had burn out and need to be replace. The back portion and bottom share the same fuse. It takes time and the right tool to replace this heat pad, trust me I know.

Posted on Jan 20, 2011

Testimonial: "THANKS WILL LOOK IN TO REPLACING THE BOTOM PART."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 Lincoln MKS Heated Seat on driver's side stopped working (Light in button turns off on its' own)


The most common cause of this problem is that the drivers seat heater grid is open or burned out. That is based on 25 years as a Ford dealer technician.

Feb 27, 2017 | Lincoln Cars & Trucks

1 Answer

Driver side seat heater light comes on and goes right out seat wont heat up passenger side works fine


The problem lies in the drivers side seat, the heating element for the back of the seat or the seat heating element has an open or shorted circuit. the part from ford will run you about $150.00 dollars.

Dec 09, 2010 | 2006 Ford Fusion

2 Answers

I have a 2004 Chevy Silverado. The heated seat on the drivers side does not work. When you push the button to turn it on, the lights come on briefly then turn off.


Would you say it stays on about 30 seconds and does the passenger side do the same thing? If possible retrieving the codes will narrow down the search for a correct solution.If the passenger side is ok we may be able to eliminate the passenger side as bring part of the problem.Please advise so will know which way to go with your solution.


Condition/Concern:
Driver and passenger heated seats inoperative or shut off in 30 seconds. There will be DTCs B2435, B2440, B3606 and/or B1825 set in the Drivers Seat Module. The adjustable pedal position sensor, seat recliner position sensor and both heat seat thermistors share the same 5 volt reference internal to the Drivers Seat Module. A fault in any of these components/circuits can make the heated seats inoperative or shut off in 30 seconds, as well as, the seat recliner and/or adjustment pedals may move in short increments when operated. A fault in heated seats, adjustable pedal or seat recliner will affect BOTH heated seats.
Note:: Even if the vehicle is not equipped with adjustable pedals DTC B3606 still may set.


To help isolate the area of concern use the Tech 2 or a comparable scanner and go to "Sensor Data" in the Drivers Seat Module. Monitor the following parameters for being out of range:
Recline Position- Normal range .39V-4.58V
Pedal Position (if equipped) - Normal range .39V-4.58V
Psgr. Seat Heat Sensor- Normal range 1V-4V
Drvr. Seat Heat Sensor- Normal range 1V-4V
If a parameter is found to be out of range inspect circuits for any opens, shorts to ground, or voltage. If none found replace the suspect component.

Please be aware of the following common areas of concern:
  1. The adjustable pedal position sensor internally shorted pulling the 5 volt reference low. Disconnect the adjustable pedal position sensor and see if the heated seats start working correctly, if so replace. Note Important:: The APP (Accelerator Pedal Position) sensor is NOT the adjustable pedal position sensor. Make sure the correct sensor, adjustable pedal position sensor, is disconnected.
  2. The seat recliner position sensor internally shorted pulling the 5 volt reference low. Disconnect the recliner position sensor and see if heated seats start working correctly, if so replace.
  3. An open in either heated seat thermistor circuits (signal or low reference). The most common is the passenger thermistor where it passes through seat connector C305 pin "L" or "K" or C399 pins "R" or "G".
  4. A chaff to ground on either heated seat thermistor signal circuits. The most common is circuit 5475 black/red or dark blue shorted to ground in the passenger seat near the buckle. Note Important:: The heated seat thermistors act differently to "OPENS and SHORTS" than the adjustable pedal position sensor and seat recliner position sensor. The adjustable pedals and seat recliner sensors can be disconnected for testing of the heated seats. Where as the heated seat thermistor circuit must be working correctly before EITHER heated seat will operate. Disconnecting one thermistor, which may have a concern will not allow the opposite heated seat to work correctly, BOTH side must be operational before EITHER heated seat will operate.
Clearing DTCs
If DTCs will not clear when using the Tech 2 or comaparable scanner after a repair has been made, try operating the device in which the repair was made. Example, if a repair was made to the passenger heated seat thermistor circuit, the DTCs may not clear unless the passenger heated seat is operated.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.

Nov 17, 2010 | 2004 Chevrolet Silverado 2500HD

2 Answers

FRONT HEATED SEATS


you need to check the resistance in each of the heated seat elements in the seat. There's a two wire connector under the back of each front seat. The connector should be green. disconnect it and measure the resistance along the circuit going into the seat. if it isnt .1 - .3 ohms, replace the appropriate heated seat element

Jan 04, 2010 | 2004 Cadillac Escalade

2 Answers

Driver's side heated seats keeps shuting off


try swopping the feed wires around and run the passenger one over to teh drivers side

Oct 23, 2009 | 2004 Saturn VUE

2 Answers

Heated seats


The body control module in this vehicle sees a short in the seat heater system. These vehiucles are typical of the heater wiring shorting out. When you try to use the bad heater the computer shuts off all the heaters.

You will need to install a new seat heater pad.

Sep 05, 2009 | 2004 Cadillac Escalade Esv

2 Answers

Driver Heated Seat 03 Suburban


Identical thing here with my '03 Surburban LT.

Mar 07, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

Buick Lesabre Heated Seats not working


The problem is most likely caused by shorted heating grids in the seat cushion itself, kind of like the heating element in an electric blanket, very expensive to replace.

Dec 12, 2008 | 2003 Buick LeSabre

1 Answer

Driver Heated Seat 03 Suburban


The most likely failure point is the driver heated seat elements. They probably have excessive resistance and once they warm up a little they short out the module and it defaults to not working. I would recommend replacing both upper and lower driver seat elements.

Aug 12, 2008 | 2003 Chevrolet Suburban

Not finding what you are looking for?
2011 Honda Odyssey EX-L Logo

Related Topics:

1,019 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...