Question about 1996 Dodge Caravan

1 Answer

A670 transmission i need the input shaft clearance on front wheel drive chrysler caravan A670 transmission, thank you. Rick.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

That would be .015-.060".

Posted on Feb 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the input turbo speed sensor located for my 2004 Chevy Cavalier? Is inside the transmission?

The input would be on the front wheels .The out put is on the output of the transmission .So the input from the wheels turning is sent to the pcm and compared with the out put of the transmission out put shaft that puts the drive force to the road .
It could be reversed from front to rear but the concept is the same the computer senses the free wheel spin rate and then adjusts controls like fuel trim and timing air intake and so on compared to the speed of the transmission shaft
Hope this helps

Sep 09, 2016 | 2004 Chevrolet Cavalier

3 Answers

Need to know steps involved to disconnect transfer case from transmission so that I can still drive my Yukon

best bet is junkyard replacement. worst case. remove tc and get a longer driveshaft to the rear end

Jun 29, 2017 | 2001 GMC Yukon

3 Answers

Is there a drive shaft

no, there is no "drive shaft" on a 94 oldsmobile. It is front wheel drive. you have a CV shaft from trans to left front wheel and a separate CV shaft from trans to right front wheel.

Jan 14, 2011 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Goes into gear but doesn 't go anywhere

If the axles are checking out fine you have a bad transmission, a bad torque converter and or front transmission pump, if it is front drive..... if its rear drive you may still have a bad trans or a sheared off U Joint on the drive shaft...this is standard problems for an automatic system, if its a stick you may have a burnt out clutch assembly, a broken input shaft or out put shaft in the trans, defective shift linkage.
Hope this helps you.

Sep 09, 2010 | 2001 Dodge Caravan

1 Answer

Need cylinder numbering order for a 200 chrysler 300m, front wheel drive. The engine is not tranverse mounted. Thanks, Rick B

For the 2000 Chrysler 300M 3.5L:

Firing Order:


Ignition Coils on respective Plug

Mar 19, 2010 | 2000 Chrysler 300M

1 Answer

2001 Dodge Caravan Drive Shaft/Transmission -- Accident damage

Personally I would not sign off the claim without that transmission being pulled out, & inspected. We're talking aluminum housing etc & that certainly doesn't stand up to a good whack, like the old cast iron did. At the least, I'd ask insurance company to have it examined by a dealership or transmission place , and get their assurance that nothing was damaged, in writing.

May 21, 2009 | 2001 Dodge Grand Caravan

1 Answer

1999 Mercury Mountaineer- Chattering Reverse to Drive Automatic

sounds like the u-joints in the front axle are bad or were installed incorrectly they only come into play when the wheel is turned. These are the axle ujoints not the driveshaft ujoints

Apr 08, 2009 | 1999 Mercury Mountaineer

1 Answer


A good mechanic should replace the seal with in 2-3 hours, mainly tearing apart your drive wheel on that side along with the drive shaft. This is a good time to replace the drive shaft if any of your CV joints are leaking.
Good Luck!! PHX

Oct 30, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
1996 Dodge Caravan Logo

Related Topics:

317 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides