Re: wind noise in a 2004 chevy tahoe at 40-45 mph+
It sounds like your winsheild gasket has a leak. There is a small rubber gasket that goes around the windshield. If it is leaking air, it may wind up leaking water, rain...etc. There not cheap. It would cost around 100 or so to replace.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
chevroletforum.com > ... > General Discussion Forums > General Tech Jul 8, 2007 - I have cleaned the MAF sensor, changed the fuel filter, ... I also have a 2002 Tahoe that is posting the p171 and P174 codes and .... I have a 2000 ChevyTahoe with a 5.3L V8. ... That seems normal for the light to go off after running, the IAC motor should have its own fault code, so it may not be that, but not ...Missing: flex
Chevy 5.3 liter lifter noise and motor flush solution How to ...? 14:10https://www.youtube.com/watch?v=4RecrxxLT4sAug 29, 2011 - Uploaded by briansmobile1Chevy 5.3 liter lifter noise and motor flush solution How to .... was there an issue with the oil pressure gauge on the dash? my '04tahoe with the 5.3 when it's .... 2004 chevy suburban1500 5.3Lflex fuel - I followed this but still have the ticking. .... How to jack up your car without jacking up your car - Duration: ...Truck Jerking/Studdering Around 45-50 mph - Ford Truck Enthusiasts ...www.ford-trucks.com > ... > 1997 - 2003 F150Dec 6, 2010 - Right around 45-50 mph, my truck starts to jerk or studder as I attempt to .... the EGR system operation causes very lean air/fuel ratios that requires higher coil voltage to fire. .... 06 f150 5.4 jerking at 45-50, trucks12345, 2004 - 2008 F150, 6 ...1966 - 1977 Early Broncos, Ford Vans and other vehicles, 2014+ ...
The only thing I can think of is the brake warning sounds that warn you that your brake pads are getting worn out. They are little metal fingers that rub on the brake disks when the pads are low. That should make the noise in the summer too but I don't know for sure about that. You could ask your mechanic about it.
hope this helps.
This is sometimes caused by moulding lifting around the windshield and on the panel housing the wiper arms. Sometimes the moulding is affected by temperature. The best thing to do is trial and error taping of a small section of the moulding or the panel covering the wiper arms. What is happening is an edge is poking up and catching the wind. By taping a small section, you are smoothing out the edge that is making noise. Once found, just try removing the tape and then use a clear silicon to fill in the edge gap. You would be getting water in the vehicle if the wind was coming through the front bottom gasket of the windshield
THe wind doesn't just push the power arm off, it must be broken and will need be replaced, You need to check if the actuall bracket that holds the arm is broken as well. It has teeth on it which when the arm is put on it lock in place with a clip
There is a Fuse for the Wipers on the Box inside the Car. There actually could be one in the Relay Fuse Box under the Hood also. This box Shoud be on the Drivers Side up torwards the Firewall of the Car.
Hi, 2possible suggestions that will help you, when dealing with a wind noise it is almost always visible in the affected area by seeing a redich resedue caused by entering dust particles,
you could also use''masking'' duckt tape to seal off all your suspect areas(starting with the r/h section of the windshield) then by trail and error systematically remove piece by piece of this tape untill your noise is located, then you can decide on what to do with the ''leak''