Question about 2001 Ford Expedition
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That's because they are hidden quite well. If you look at the engine, you'll see yellow plastic prongs (?) that look like spark plugs, but hook up to the silver tubing. That's the fuel injectors. BUT, right behind the yellow plugs, are black ones. The black one is the connector to the spark plug. The plug itself sits about 4 inches down into the block of the engine. They are a real pain, and from what I can tell, you only have decent access to the first 2-4 of them, then they get too far back and start going under the dash (you'll see what I mean when you get there).
Posted on Aug 06, 2008
Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start
Posted on Feb 05, 2009
The theft light blinking indicates a PATS (perimeter anti-theft concern.It means that the computer has not recieved a signal from your key when trying to start the vehicle. A few things could be wrong.
1...The key you are using to start the vehicle is not programmed to the vehicle or broken internally. So try a different key(one that you know is programmed to the vehicle) if you have more than 1. If the theft light goes on and flashes when you try to start the vehicle, you must wait about 5 minutes before trying the second key because the computer goes into antiscan or theft mode and wont let any keys start the vehicle.
2... There is a small transciever ring located arount the key cylinder which recieves the key signal. The wiring for the tranciever runs down the steering column into the dashboard wiring. Sometimes these wires break. If you have a tilt steering wheel, move it all the way down and try to start, then try moving it all the way up and try to start. Keep in mind the antiscan that I mentioned in #1. If this works then you need to check the wiring at the base of the steering column. A white connector with 4 wires. Pull on each wire to see if any are broken.
3... Check fuse #30 on interior fuse panel. If it is blown then you will have to trace down the cause of the short. The ignition coils are on this fuse also so one could be shorted. Disconnect all ignition coils(you may have 8 located on each plug if 5.4l engine or 2 located on l+r front of engine if 4.6l engine) and see if the short is gone. If the short is still present disconnect the radio noise supression capacitors( small black box approx 1" x 1" square with a single wire coming out) that are located on the left and right front of the engine. Pay close attention to all the wiring around the coils, look for any areas that may have rubbed thru and shorted.
These are things that I would look for first and are the most likely causes. This should get you started in the right direction. Be patient and post your findings if you fix it or not.
Posted on Apr 10, 2010
Tips for a great answer:
Nov 27, 2016 | 2001 Ford Expedition
Jan 07, 2014 | 2007 Ford Expedition Eddie Bauer EL
Jun 23, 2010 | 2007 Ford Expedition Eddie Bauer EL
Mar 31, 2010 | 1999 Ford Expedition
Feb 02, 2010 | 2000 Ford Expedition
Oct 13, 2009 | 1999 Ford Expedition
Jun 02, 2009 | 2007 Ford Expedition Eddie Bauer EL
May 28, 2008 | 2007 Ford Expedition Eddie Bauer EL
95 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: