Question about Cars & Trucks

1 Answer

2006 jeep wrangler with automatic transmission has a hard shift at the very first initial start of vehicle and then will drive good

Posted by on

Ad

1 Answer

Remove & clean the transmission valve body

New fluid & one bottle of Red Lubgard ---
no other product or additives

Gets worse when cold !!!

Posted on Nov 27, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: 2006 matrix shifting in transmission problem

This is a known condition. And, is under warranty.

Take your vehicle to a Toyota dealership. Ask them to replace your ECU per TSB (Technical Service Bulletin) TC015-07. The new ECU has redesigned logic that rectifys your condition.

Posted on Sep 22, 2008

  • 1 Answer

SOURCE: transmission shifts hard down from highway gear only (D>3rd)

I had the same thing! It was a computer issue. It only cost me about $35.00.

Posted on Dec 29, 2008

csmock132
  • 4669 Answers

SOURCE: 2004 Jeep Wrangler - Clunking Noise when shifting out of Park

It could be lash in the differential which is normal, but it could also be a loose u-joint in the driveshaft. Check the rear driveshaft u-joints.

Posted on Mar 12, 2009

emissionwiz
  • 76164 Answers

SOURCE: transmission shifting problem[automatic]

the next step is to have the service trouble codes run to see if any trans related codes pop up, here is how u do that, go to the link for instructions, let me know what u find if anything, but that is the 1st step in the further diag of this problem
http://check-engine-light-codes.blogspot.com/2006/04/chrysler-1985-95-obd1-code-self.html

Posted on May 03, 2009

  • 1 Answer

SOURCE: 1991 Jeep Wrangler Stuck In Gear

I had the same problem, but in first gear. What I did to free it up, with the shifter out of the transmission, looking down into the hole you will see two linkages side by side with a slot in each. The trouble is the linkage got out of sink. What you do is put a large screw driver into (shifter lever) slot and try to move them (they are hard to move) to you find neutral.

Posted on May 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How much transmission fluid is in a 1999 jeep wrangler


Automatic Transmission, 32RH Initial Fill..........4.1 quarts
Automatic Transmission, 30RH Initial Fill..........4.1 quarts
Automatic Transmission, Total Fill
3 speed 32RH..........8.6 quarts
3 speed 30RH..........7 quarts
Manual Transmission, AX-5 2WD..........7.4 pints
Manual Transmission, AX-15 2WD..........6.8 pints
Manual Transmission, AX-15 4WD..........6.8 pints

Feb 14, 2011 | 1999 Jeep Wrangler

1 Answer

I have a 1987 jeep wrangler and it will not shift into 4 wheel dr


The front axle connects 4wd by vacuum. check the vacuum hoses that run to the actuator. Pay close attention to the vacuum hoses running underneath the battery as battery acid can eat thru those hose easily. Good Luck.

Dec 27, 2009 | 1987 Jeep Wrangler

1 Answer

Jeep 1992 Wrangler won't shift into gear


Not frozen, probably split shifted. Two gears at once.Is this a floor stick or column ahift. Surely not automatic, right? Ley me know and I'll tell you how to undo it

Jul 08, 2009 | 1992 Jeep Wrangler

1 Answer

88 wrangler wont shift


Clutch pedals have a safety interlock switch that keeps a manual transmission vehicle from starting. It sounds like the pin on the bottom of the shifter in the trans is getting worn and needs to be replaced. You can remove the boot on the shifter and the cover on top of the trans and see the pin. It's a simple matter of getting the pin out and installing a new one. Just make sure everything lines up good on the install and everything is clean. Another thing that may be the culprit are the synchronizer plates could be worn nearlt out. To replace or fix this you will need the trans out of the vehicle and tear it down. Start with an inspection of the pin and the linkage as well, then if it doesn't work correctly then you may have to tear into it.

Jun 19, 2009 | 1999 Jeep Wrangler

1 Answer

2004 Jeep Wrangler - Clunking Noise when shifting out of Park


It could be lash in the differential which is normal, but it could also be a loose u-joint in the driveshaft. Check the rear driveshaft u-joints.

Mar 12, 2009 | 2004 Jeep Wrangler

1 Answer

1999 jeep wrangler no reverse


i would say your reverse gear is locking up on you and that you need to get it to a transmission shop before you break the gear off trying to back it up,,it will mess up the other gears

Feb 13, 2009 | 1999 Jeep Wrangler

2 Answers

Hi there. I have a 1997 Jeep Wrangler TJ Automatic (Hard Top.) Yesterday after being in the snow the transmission started to act up on the way home. It was holding gears to long sometimes and it even took...


You may have gotten some snow it the connector for the TCM ( transmission control Module) computer for the transmission, or you may have pulled a wire off from the bottom of the vehicle check for any loose wiring harness connectors on the Transmission.
If you find tis information helpful please geve me a good rating
Thank you ,Randy

Aug 10, 2008 | 1997 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...