Question about 2004 Nissan Quest

Open Question

Where is the tail light fuse located for a 2005 nissan quest

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Nissan Quest 2004 Tail Lights

Robynumber1,

Thanks for the email back. The nissan quest tail lights werenot operating, but the break lights were working. This was ultimately caused by a blown fuse. The fuse was blown by loose trailer lighting wires dragging on the ground, thus shorting. Problem fixed.

Posted on Nov 19, 2008

  • 203 Answers

SOURCE: Replacing the tail lights of our 2005 Nissan Murano?

if the lite cover has no screws the access is in the boot pull back the boot/trunk carpet and you should see a cover over the tail lites access should be through there

Posted on Nov 21, 2008

  • 19 Answers

SOURCE: lighter fuse location

  1. its located where c isd5dc36d.gif6e27a13.gif

Posted on Jun 30, 2009

SOURCE: replaced tail light fuse, which turned on tail

most likely you have a short in one of the bulb connectors or the hot wire from them is pinched on medal somewhere. Or you have water intrusion shorting one out. Inspect the bulbs. Leave both bulbs out. install fuse. Press brake pedal several times and hold. Inspect fuse. if its blown its the pedal switch that's bad or a pinched wire from there. If good put one bulb in. Test again,, then the next bulb. If you see something obvious fix it.

Posted on Jul 18, 2009

johnjohn2
  • 5763 Answers

SOURCE: 1997 nissan quest camshaft sensor where is it & how to replace it

The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck

Posted on May 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tail light fuses


The fuse box should be located under the hood of your 06 nissan quest. You have to remove its cover and underneath the cover there should be a diagram just locate the turn signal fuse location check what amperage it is (should be stamped with 10, 20 etc...) go to the auto parts store get a replacement fuse install it in the fuse box and off you go... Hope this helps...

Oct 12, 2013 | Nissan Quest Cars & Trucks

1 Answer

Fuse for tail lights keeps blowing


You have a serious short circuit in the wiring to the tail lights. Fuses protect the wiring in your vehicle from catching fire.
You need to trace the tail light wiring from the fuse box to the tail lights to locate the fault/short circuit.
A wiring diagram can help as it shows the colour code of the wires to the tail lights.
This problem can be difficult to trace and you most likely need an auto electrician to fix this problem. It could mean installing a new wire to the tail lights as a quicker fix and bypass the fault..

Apr 19, 2013 | 1993 Nissan Quest

1 Answer

My nissan Quest 97 the tail lights stays on when the vehicle is turn off?


There is a short in your multi funtion switch. Inside the steering colum

Oct 22, 2012 | 2005 Nissan Quest

3 Answers

Dash and interior lights do not work


Dash lights are on the same fuse as the tail lights. Dash lights not working is an indication that the tail lights are not working. The first thing to check is that the tail light fuse is not blown. Most of the time replacing the tail light fuse will restore both the tail lights and the dash/interior lights. If this is not the case you may have to trace the wires and look for a broken or unplugged wire in the harness.

Nov 18, 2011 | 1994 Nissan Quest

1 Answer

My 2005 nissan altima has both tail lights out, the break lights work and i searched all over for the tail light fuse, but i cannot seem to find it. help?.


if its like most nissan s you have to remove the glovebox and the fuse box is behind it, the main box can also be located beside your battery, if both tail light blow it will, blow a fuse, so check your lights regular to save you the hassle of looking for fuses.

Aug 29, 2010 | 2005 Nissan Altima

1 Answer

Tail lights on 1999 Nissan Quest will not go off when I stop the vehicle and turn the engine off. Only way to get them to go off is to remove the fuse.


is it the tqail lmaps or stop lamp bulbs on?
If stop lamp bulbs, repalce the stop lamp switch on the brake pedal

Apr 06, 2010 | 1999 Nissan Quest

1 Answer

The tail lights are 'gone' on the 2007 Quest 3.5 S


sounds like a blown fuse , some tims the tail lights are on a fcircut by themselves or with small circuts like dash lighting, check all fuses both in vechile and under hood.

Aug 18, 2009 | 2007 Nissan Quest 3.5 Minivan

1 Answer

2005 NIssan quest camshaft sensor


for a Nissan Quest, it is in the distributor. Not serviceable, replace distributor. Famous for nearing failing and getting brown dust on optical sensor for camshaft sensor. buy on ebay for $200. Cleaning optical sensor is temp repair.

Call dealer & see if yours is there too.

Jun 21, 2009 | 1997 Nissan Quest

1 Answer

Nissan Quest 2004 Tail Lights


Robynumber1,

Thanks for the email back. The nissan quest tail lights werenot operating, but the break lights were working. This was ultimately caused by a blown fuse. The fuse was blown by loose trailer lighting wires dragging on the ground, thus shorting. Problem fixed.

Aug 17, 2008 | 2004 Nissan Quest

Not finding what you are looking for?
2004 Nissan Quest Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...