Question about Cars & Trucks

Open Question

Vacuum diagram for 2000 gmc safari

Vacuum hose diagram for heater control valve

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: vacuum hose

It's alot to handle at once but, I hope this helps you out...

<p>

http://www.courtesyparts.com/betasite/maxima-a32b-1995-1999/genuine-nissan-parts/engine-electrical/223-vacuum-piping/-c-1783_1784_1814_1817.html

Posted on Aug 12, 2008

Ad
clarktravis8
  • 74 Answers

SOURCE: 2000 GMC Safari anti-lock brakes

There was actually a recall for this. Go to your local GMdealer and have them check your VIN for a recall. If not under recall get out of there its easy to repair yourself don't let'em fool you.Remove the front pads caliper and rotors. Locate the abs sensor mounted to the wheelbearing assembly by a small socket head cap screw (Allen wrench). Removethe bolt and softly gently/wiggle the abs sensor around until it pops upout of the hole. some will break, which is why it wouldbe nice if the recall applies to your vehicle that way if they break gm replaces. Once you get both sides removed, clean themounting surface of all rust or build up with w-d 40 and small steel toothbrush then wipe off excess with clean rag and mild soap and warm water, dry completely make sure no spray residue exist on parts, Next apply a thin layer of lubricant grease to preventfuture rusting and reassemble.The rust build up under the sensor is causing the angle to change resultingin inaccurate wheel speed readings in the abs module your abs module will interprets this asa wheel is either slipping or skidding and applies your abs. This should make you happy with no more irritations. Please rate me. If you need further assistance you can always ask me. Good luck with this.

Posted on Apr 25, 2009

localwonder
  • 6784 Answers

SOURCE: i need a diagram of a 1995 gmc safari v6 power

Diagrams below


bac3f8a.jpg


e1fba92.jpg

Posted on May 26, 2009

  • 396 Answers

SOURCE: where is the heater control valve 2000 siverado

Most heater control valves are up next to the firewall behind the engine. Look for coolant hoses running to that area.

Posted on Oct 13, 2009

  • 17 Answers

SOURCE: I need a vacuum hose diagram for 1999 gmc jimmy

go to a parts store and get the haynes manual. they have them for pretty much everything. they're only like 20 bucks and you can rebuild your car by going through it...they have wiring, vaccuum, brakes, everything. or google it. or check with GM, they should have that info

Posted on May 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 1996 gmc sierra 1500 truck that when i turn on my heater it come form the front defrost and not out of the vents and i can find the vacuum hoses any where


Hoses should be run from motor through firewall somewhere...also check for vacuum (ball) Usually ball shaped...this ball stores vacuum to help operate vacuum accessories. Also...I've found problems with the control panel itself...partially electrical..and part vacuum...usually several hoses coming from it. I have a 96 Safari...a lot of similarities.

Sep 19, 2015 | GMC Cars & Trucks

1 Answer

Check if acuator is working properly


Make sure the heater control valve is switching when dial is moved to heat. It is located under the evaporator box on the right side of the engine compartment.

Nov 04, 2014 | 2000 GMC Safari

1 Answer

Defrost, heater, vent switch isn't switching the control to a differnt source


There is a small vacuum hose that runs along the front of the throttle body.Usually gets brittle and brakes .This runs to the passenger side of the firewall this goes to the heater box.without vacuum the valve under the dash can not switch.I hope this helps

Oct 19, 2012 | 1997 GMC Safari

1 Answer

I want to install a rear heater in a safari, how do i run the power, and hoses, if any, to and from the battery/heater?


You could just Tee into the heater hoses in front and run a hot wire from the accessory side of the key switch. The blower would need some sort of fuse. Factory systems are wired into the front control.

Sep 03, 2012 | 2000 GMC Safari

1 Answer

Where is the HVAC box located on a 2000 GMC Sierra 4X4. I beleive the mixing door is not working correctly, I'm only getting warm air not hot. All ready changed thermostat and checked hoses.


Check in the one heater hose will be a control valve. Check the operation of the valve(this is the heater control valve). If the lever on it appears to be moving. Take the valve out and manually check that the valve is opening and closing the whole way. If not replace the valve and recheck. If it is the heater core may be clogged not allowing the hot coolant to flow thru so you can get heat.

Oct 01, 2009 | 2000 GMC New Sierra 1500

1 Answer

My vent will not change from defrost on my 2000 Safari


YOU HAVE A VACUUM LEAK AT A/C PLENUM. IT'S VACUUM CONTROLLED AND DEFAULT IS DEFROST, IF VACUUM LOSS IS EXPERIENCED THIS WILL HAPPEN. TRY TRACKING FOR A SMALL PLASTIC LINE THAT GOES INTO VEHICLE FROM UNDER WINDSHIELD FROM ENGINE COMPARTMENT. USUALLY BY ACCUMLATOR OR EVAP CASE. FIND A BREAK IN IT OR HEAR A HISS NOISE WHILE VEHICLE RUNNING THAT'S IT. REPAIR HOLE OR SUPPLY HOSE TO MANIFOLD

Jul 12, 2009 | 2000 GMC Safari

4 Answers

A/c comes out of front defroster. I also found a vacuum hose lose near the front firewall and I cant find out where it goes.


I tried to give you a vaccum diagram but the manufacture will not release that info to outsiders. you need to find where the hose goes to.if you loose vac to the controls it goes to defrost mode.

May 27, 2009 | 1999 GMC Safari

1 Answer

Where are the vacuum hoses for the heater control for 1997 safari


runs off intake on drivers side of thottle body to passanger side heater box . They get brittle and break by throttle body .

Feb 25, 2009 | 1997 GMC Safari

1 Answer

Rear heat or rear air conditoner not workin in my 1997 gmc safari


two different problems !

Rear heater problem: find under the hood where is hose for cooling liquid goes to front heating core!
you will see there also vacuum tubesgoing in to little valve ! disconnect the vaccum tubes ( engine off)
and spray in wd 40 in to the vlave ... valve is stuck and wont open flow to rear heater !

you do not have to replace tha thing . its very well made and because you dont turn this often in summer
it gets stuck. i had same problem. also make sure vacuum is working - Engine running turn rear heater on - vacuum sucks to open valve. and before that make sure fuse is ok .

for rear AC mine does not work either and it is leak on pipes that go from front to rear .. 10 feet of pipes and tubing $$ expensive repair ... forget it ... open the window...

jebadiah

Jan 22, 2009 | 1997 GMC Safari

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...