Question about 2003 Dodge Neon

1 Answer

Need to replace heater core.

I have quite a few issues with my car. I like the neon and want to work them out. I replaced a wheel bearing and need another now. I have a bad wheel cylinder in one of the drums. Need new front brakes and rotors. Now I have a check engine light on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 2,101 Answers

Replacing the heater is a very bad job. the dash will need to removed with the steering coluum. once you do that the nuts that hold the heater box are on the out side on the firewallthis is the link to my garagetps://www.facebook.com/TedsRepairs

Posted on Nov 27, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

slazabaza
  • 47 Answers

SOURCE: front wheel hub assembly replacement

if you have basic knowledge you should be able to carry out this job yourself. you will probably need to ring a dealership and ask very kindly if you could have the torque settings for the nuts and bolts ect.

hope this helps.

Posted on Mar 18, 2009

greg_margo
  • 1959 Answers

SOURCE: Car shudders on acceleration

I'd check the motor mounts. Shuddering upon acceleration indicates movement of the engine inside the compartment. Best of luck.
Greg

Posted on May 20, 2009

pippall
  • 1486 Answers

SOURCE: 2001 dodge neon rear drum removal wheel cylinder

You need a pullers to get it off.But if your lucky putting a screwdriver between the drum and back-plate and pize it when your hitting with a hammer it may come off.good luck.

Posted on Jun 03, 2009

  • 334 Answers

SOURCE: I need a diagram on how to replace rear brake pad

get a haneys repair manual. at the auto parts. the book has what your looken for

Posted on Aug 08, 2009

germcelchar
  • 389 Answers

SOURCE: I have replace wheel cylinder on 97 Stratus, bleed

Itsw very unlikely their is a problem with the master cylinder. When you pump the brake's to bleed them it uses up the vacuum and the brakes will be spungy because the servo isnt working properly. After bleeding leave it running for a few minutes then try the pedal it should be ok. If their is a problem with the master cylinder then the pedal would go all the way to the bottom but not spungy. You may need to bleed the brake on the other side to get all the air out of the system.

Posted on Sep 15, 2009

Testimonial: "Thanx you gave much better advice than most garages I spoke with."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GEEZ!! We just figured out why the rear carpeting flooded and replaced the rear light seals, now the front carpet seems to be wet. WHY???


if it hasnt been raining, it might be the heater core. make sure you arent low on coolant, because the heater core uses radiator fluid. if you are losing coolant and the heater smells funny, then you need to replace the heater core. its behind the dashboard.

Mar 18, 2011 | 2002 Dodge Neon

2 Answers

2002 Neon, constantly replacing rear wheel bearings. Why?


are hte wheels aligned this can cause pressure on the wheel bearings are they being put on to tight this will also cause this how about grease

Feb 09, 2011 | Dodge Neon Cars & Trucks

1 Answer

Need to replace heater core in a 2004 neon 2.0 w/ac any short cuts


no it calls for 5.5 hours plus a vac and recharge of the a/c unit. i charge 425.00 for this including the heater core and the recharge if the a/c was working when it arrived.if your undertaking this project yourself get a haynes manual from your parts store so you can see how its done. hope this helps

Jan 24, 2011 | 2004 Dodge Neon

1 Answer

Where is the heater core located on a 2004 dodge neon and what do i have to do to change it


Inspect/Replace If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core.
When a heater core leaks, a new heater core is installed or the old one repaired.
Heater Housing
  • The heater housing is usually under the dash and must be removed to gain access to the heater core.
  • Procedures for replacing the heater core vary with the year, make, and model of car. It threfore necessary to consult the manufacturer's repair manuals for the proper procedure for replacement.
f74-01.gif The heater housing is disassembled to get to the heater core. Heater Core
  • Remove the access panels(s) or the split heater/air conditioning case to gain acess to the heater core.
  • Remove the heater coolant hoses.
  • Remove the cable and/or vacuum control lines (if equipped).
  • Remove the heater core securing brackets and/or clamps.
  • Lift the core from the case. Do not use force. Take care not to damage the fins of the heater core when removing.
  • To reinstall the heater core, reverse the removal steps.
When the heater core leaks and must be repaired or replaced, it is a very difficult and time-consuming job primarily because of the core's location deep within the firewall of the car. For this reason always leak test a replacement heater core before installation.

Dec 01, 2010 | 2004 Dodge Neon

1 Answer

I have a 1999 neon dodge and cannot get the heater to heat i have put new thermstat and bleed the raditor what next?


Have you checked to see if the heater core needs to be replaced. That could be your problem. The core is usually on the drivers side on the under the dash. Try this. I hope it works. Good luck.

Sep 19, 2010 | 1999 Dodge Neon

1 Answer

Right Front Hub Noise- 1997 Neon


you need to buy the whole assembly. i know what you mean. I have a '68 coronet that still has the origional wheel bearings in it, and now they don't last 5 years. ( and they wonder why they're all gone broke)
No, it shouldn't blow up, but it will keep getting worse, and it probably does affect your mileage, somewhat.

May 14, 2009 | 1997 Plymouth Neon

Not finding what you are looking for?
2003 Dodge Neon Logo

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...