Question about Cars & Trucks

1 Answer

Cant remove my starter from 1997 fordareostar

Posted by on

  • dbzawada
    dbzawada Nov 28, 2012

    i have the bolts off end cables off but i cant seem too get theb starter past the driveshaft and exhaust pipe do i need too remove either 1 of them too get the starter p[ast too beable too replace it its a 1997 ford areostar

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,370 Answers

CAR STARTER REMOVAL? TESTING


One Wire From Starter Motor Goes To Solenoid And Other Goes To BATTERY. Starter GETS 12 VOLT SUPPLY FROM BATTERY AND WITH THESE VOLTAGE IT TURNS THE MOTOR AND THIS TRIGGERS THE STARTER SOLENOID AND YOUR VEHICLE RUNS.============

For your help there are few relatively help links showing how to remove and install starter with proper instructions:-----

These help links will help.

Click the link below:-----


How to test starter solenoid? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html -------------------- How to test cars starter? http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html ----------- How to replace starter in car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-starter-in-car.html

-----------
How to replace Starter on Infiniti Q45? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

----------
2006 GM Montana: How to replace Starter Solenoid?

http://repairhelpcenter.blogspot.in/2012/06/2006-gm-montana-how-to-replace-starter.html

-----
Saturn SL2: How to replace Starter Motor?

http://howtobyme.blogspot.in/2012/06/saturn-sl2-how-to-replace-starter-motor.html

--------

Saturn SL2 Starter Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/saturn-sl2-starter-wiring-diagram.html

----------

Oldsmobile starter solenoid replacement procedure?...

--------------------

How to replace Oldsmobile starter moor?

----------

Oldsmobile starter motor testing?

-------------

Oldsmobile STARTER MOTOR NOISE DIAGNOSIS?

------------

These details will help.

Thanks.

Posted on Nov 26, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 V8 4.6l. It turns over, but why won't it start?


Part 1 -How to Test the Starter Motor (Ford 4.6L, 5.4L)

troubleshootmyvehicle.com > Ford > 4.6L, 5.4L
Mar 2, 2011 - Page 1 of 3: How to test a BAD Starter (Ford 4.6L and 5.4L Pick Up and SUV). ... a BAD starter motor on your 4.6L or 5.4L V8 equipped car, pick up or SUV. ...and will turn over the engine; -OR-; The starter motor won't do a thing. ... Crown Victoria ... 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005.

Question: 1997 Crown Victoria Lx Cant Turn on and Cant ...

www.2carpros.com/.../question-1997-crown-victoria-lx-cant-turn-on-an...
May 26, 2014 - Ok so i put the keys in the car turn the key but seems to me it moves more ... 1997 Ford Crown Victoria • 4.6L V8 RWD Automatic • 99,625 miles ... Keywon't turn off accessories or turn car over and ignition cylinder turns too ...

Oct 19, 2015 | Ford Crown Victoria Cars & Trucks

1 Answer

Removed two bolts from starter and cannot get starter out heard may be extra support bolts but cant locate


I had a Toyota with an odd-ball starter bolt from the back side of where the starter mounted. It didn't even look like a starter bolt, but sure enough, it was. So keep checking, you may have a third bolt you haven't found.

Aug 22, 2013 | 1997 Mitsubishi Diamante

1 Answer

1997 f 350 7.3 engine cant find diesal leak its dripping off starter its dry on top


check the fuel line on the frame that runs right by the starter it may have a pin hole in it that causes it to spray fuel on the starter.

Jan 26, 2011 | 1997 Ford F350 Crew Cab

1 Answer

Trying to change a stater cant find the bolts on top


the top bolts come in from the rear of the bell housing. They these bolts mount both the bell housing to the block and the starter motor to the block. Under neath just line up wich mount bolts are close to the starter and undo them, possibly 2 that hold them. once remove starter should fall straight into your hand

Jan 22, 2011 | 1997 Ford Expedition

1 Answer

Removed starter bolts but cant get it to drop didnt know if need to take loose motor mounts to raise engine for clearance


Some times you need to move the steering in one direction or the other to get room to move the starter. Look on the New starter for a Rearward bolt coming from the Trans side. Sometimes you have 3 starter bolts.

You don't need to lift the engine.

Jul 01, 2010 | 1997 Mercury Grand Marquis

2 Answers

I have a 1997 acura tl 3.2 that needs a starter! Well I cant get the starter out of the car its to tight! What do I need to do to change the starter? Can I remove something to give me room to pull the...


breaker bars will add leverage you might have to remove some of the intake stuff, and break cleaner which will loosen the bolts

just for starters

Jun 02, 2010 | 1997 Acura TL Series

1 Answer

Need to replace the starter on a 1997 dodge grand caravan


to remove the starter from motor you need to disconnect the battery negative wire from the battery. then remove the battery wire and start wire from solenoid. remove the bolts holding the starter to the transmission bellhousing. then remove starter. installation is the reverse of removal.

Apr 28, 2010 | 1997 Dodge Caravan

1 Answer

Wont start battery good altenator good,how to remove starter


The starter bolt actually goes through the motor mount so in order to remove the starter you must support the engine with and engine support or hoist. (some put a jack underneath the oil pan which is not an approved method but it works if that's all you have) Other than that you seem to have the rest under control.

Jan 30, 2009 | 1997 Volkswagen Golf

1 Answer

1997 wrangler starter removal


alot of the time the line up dowels rust into the block. usually soaking where the starter meets the block with a rust penetrant and wiggling the starter around does the trick

Jan 07, 2009 | 1997 Jeep Wrangler

1 Answer

Replacing a starter on a 1997 Dodge Intrepid


No, you can access the starter from the bottom of the engine without having to remove anything else. I replaced the starter on my 94 3.3 myself without having to remove anything else. Good Luck!!!!!

-Matthew

Nov 11, 2008 | 1997 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,466 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...