Question about Honda Cars & Trucks

Open Question

Location of oil sending unit for 95 honda passport 3.2 engine

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 508 Answers

SOURCE: locate the oil sending unit on a 2003 6.0 2500HD silverado

You will find it down by the oil filter.

Posted on Feb 07, 2009

  • 78 Answers

SOURCE: oil pressure sending unit

Hi there;

Your looking foer the oil pressure sensor on the 2004 8.1L.
You will find it located directly behind the EGR valve threaded into the block just to the drivers side of the center bolt for the transmission to block connection.


Posted on Mar 17, 2009

  • 1 Answer

SOURCE: where is the oil sending unit on a 93 chevy silverado 350 engine

the oil sending unit is located at the back of the motor right below the rotor cap it is about 3 inches long and has a 3 wire plug hooked t it

Posted on Apr 28, 2009

  • 126 Answers

SOURCE: Where is the oil sending unit located on a 2003 Chevy Tahoe 5.3 engine

its in the block behind intake manifold .

Posted on May 05, 2009

  • 1986 Answers

SOURCE: I keep getting a stop engine low oil pressure

Just wondering if you put in the correct amount of oil and tightened everything back up properly...

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel light on a 98 honda passport flashes

These Isuzu-built vehicles had many problems with fuel system components. Particularly the sending unit in the tank. Note: If the unit is replaced, the PCM must be updated to accept the new pump calibration before it will work.

Mar 17, 2014 | 1998 Honda Passport

1 Answer

I cant seem to locate the ect(coolant temp sensor on my 95 passport. where is it?

in the rear of the engine betwwen firwall and engine. passenger side

May 16, 2011 | 1996 Honda Passport

1 Answer

Where is the oil sending unit on a 95 olds delta 88

The OPSU (Oil Pressure Sending Unit) could be located in two different places, the most common location being on the top rear of the engine block along the rear valley ridge, just behind the intake manifold and next to the distributor. The other location would be on the side of the engine block just above the oil filter housing.

Jun 05, 2010 | Oldsmobile 88 Cars & Trucks

1 Answer

Temp sending unit where is it at????

Left side of engine as you look at it from the front of the car. it is about halfway down the side located ON THE ENGINE BLOCK, not the head.

Mar 21, 2010 | 1995 Honda Passport

1 Answer

Locating oil pressure switch on 1995 honda passport

it is actually called the oil sending unit. It is located on the lower left side of the engine near the oil filter.

Dec 02, 2009 | 1995 Honda Passport

1 Answer

Where do I add motor oil on a Honda 95 Passport?

Look in the hood. You will find a knob black in colour with the sign oil on it

May 25, 2009 | 1995 Honda Passport

1 Answer

Oil filter

Should be on the backside of the engine just above the drive axle. Good luck

Apr 25, 2009 | 1994 Honda Passport

1 Answer

My fuel gauge is not working times it would drop to E and a symbol of a gas tank start flashing. thirty seconds later it gradually climb back to the original location. however, the check engin...

its the sending unit located on top of the gas tank , have to drop the tank and replace-cheapest on ebay ! good luck had the same problem a year ago on my 01 passport/rodeo

Apr 21, 2009 | 2001 Honda Passport

2 Answers

1995 honda passport. When engine is cold oil pressure reads about 50, when the engine is warm the pressure gauge reads 0. What is are the possible problems. Just had the valve cover gaskets changed and...

It could be that during the changing of the gaskets that some debris may have ended up in the oil passages in the heads slowing the flow of the returning oil. Or could be the oil pressure unit itself.

Mar 04, 2009 | 1995 Honda Passport

5 Answers

Where is the oil pressure sending unit on 2004 dodge stratus?

per the Haynes manual for the 95-05 Dodge Stratus on the 2.0L & 2.4L DOHC 4 cyl engines, the oil pressure sending unit is located at the left end of the rear side of the block. On 2.4L SOHC 4 cyl engines, the sending unit is located at the left end of the rear side of the block. On 2.5L & 3.0L V6 engines, the sending unit is located on the oil filter housing, on the front side of the block. On 2.7L V6 engines, the sending unit is located at the left end of the rear side of the block. To access it, remove the heat shield.

Jan 23, 2009 | 2004 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides