- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you have what they call a flasher unit, its a relay of sorts ,, it makes the items you list Blink, its a small box usually located near the fuse box,, your actual switch can be fine, but if the flasher unit quit, ( which is usually the case) the blinkers won't work, ( some systems use the same flasher unit for blinkers and emergency flashers, and others use one for each )
If you mean the left turn signal indicator on the dashboard won't blink...sometimes means the actual bulb for your left blinker is out. If you mean the actual exterior blinker bulbs don't blink...may be the flasher.
You need to replace flasher unit. This regulates the flashing speed. Check under the drivers side dash (it may hang amongst wires or in a fuse box) or under bonnet where all the large fuses are (these will be in a covered box). Sounds like under dash because of noise. Google search flasher units to see what the look like.
1ST double check that all the bulbs for the pass. side turn signals are working. if even one is out it can make the blinker not "blink". so compare the pass. side lights to the driv. side to make sure u did not miss something. NEXT,if thats not the problem, then u can locate the flasher by 1ST looking in the fuse box(probably inside the glove box or under the drivers side dash) theres a good chance it might not be there(years ago every car had the flasher in the fuse box) SO TURN ON THE DRIVERS SIDE BLINKER (key on) and LISTEN OR FEEL UNDER THE DASH FOR THE FLASHERS NOISE--LOOK NEAR THE STEERING COLUMN,BRAKE PEDAL, EVEN BEHIND THE ASH TRAY!! hope this helps you!
No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below: Troubleshooting Procedure To start troubleshooting this problem:
Turn the key to the on position (do not start engine)
Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
you need to go back over all the bulbs. Take each one out and put it back in making sure its working properly. Most likely a bulb is not grounding. I had this on a f-150 that took two days to track down. Good luck