Question about Cars & Trucks

Open Question

Caseih mx 135 won't start when its cold, safety switch not making contact

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: truck won't start. i

CODE SCAN FOR FAULTY TRANSMISSION RANGE SWITCH OR FAULT IN THE THEFT SECURITY SYSTEM. TRANSMISSION RANGE SWITCH LOCATED ON SIDE OF TRANSMISSION ON THE MANUAL SHAFT AND LEVER WHICH SHIFT CABLE CONNECTS TO SHIFT LEVER.

Posted on Jul 07, 2011

Ad
johnjohn2
  • 5763 Answers

SOURCE: Car won't start and the battery is fine. I think

You could be right, a quick test to see if it the switch or starter would be to have someone hold the key in the crank postion with clutch pedal down and see if the small wire at starter has power, if it has power then its not the clutch switch but rather the starter itself. or you can unplug the safty switch and jump the connector and see if it starts, if it does then its the switch if not then it could be the starter, check starter for power as i listed above and if theres power replace the starter. hope this is helpful. good day.

Posted on Aug 22, 2011

  • 5401 Answers

SOURCE: 1992 mx-3 v6 won't start. will hit sparaticly as if about to start but just won't catch. checked crank pos. sensor. need suggestions on how to proceed.

Check for a blue snapping spark on 2 or 3 plug wires(or all of them). If you get good spark, then ignition is likely not the problem. A weak or sporadic spark could be a bad coil or coil pack, or a bad ignition module (the ignitor).Check the coils with a volt-ohmmeter per the specs for your car. The ignitor can be tested at a parts store.
If spark is good, check fuel filter, fuel pressure, check timing marks on crank pulley and cam marks, Try a little starting fluid in the air intake and see if it runs for a moment. If so, then it's likely a fuel delivery problem. If no change, then it's likely an ignition circuit problem.
Good luck.

Posted on Dec 30, 2011

  • 2 Answers

SOURCE: car won't start. Starts w/o problems later on. i need to replace the neutral safety switch which has been getting stucked lately

if you can unplug the leads to the switch and then place an ohm meter on the two contacts, the switch should be opened when the clutch is not depressed and read ohms when the clutch is depressed

Posted on Jun 08, 2012

Hobbit_who
  • 2044 Answers

SOURCE: 2000 ford windstar won't start after changing safety neutral switch?

You need to adjust the Switch, it thinks you are in Gear

Posted on Apr 09, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford windstar won't start after changing safety neutral switch?


You need to adjust the Switch, it thinks you are in Gear

Apr 09, 2013 | 2000 Ford Windstar

1 Answer

92 olds cutlass supreme, shifter moves into gear, but car will not move. Help


It\'s right where the shifter cable goes into the shaft, look
right next to the steering cloumn under the hood,the switch
won\'t keep the car from moving tho,it just wouldn\'t start.But you
could look there to make sure the cable hasn\'t broken or come
unhooked. The cable goes to an arm about 3 inches long just
make sure the arm moves when shifting.
comparebanner.jpg

Duralast/Neutral Safety Switch

viewdetailsshelf.gif

Mar 16, 2013 | 1992 Oldsmobile Cutlass Supreme

1 Answer

Intermittent starter won't engage on mercrusier7.4 1988 boat engine


might be a burned spot on the starter contacts where the brushes power the motor.
tap the starter to see if problem goes away.
sometimes you can clean the contacts but that is a temporary fix.

Mar 11, 2013 | Cars & Trucks

1 Answer

Ive got a 93 mazda mx-6. the motor came out of a 97 ford probe 2.0. with that being said.. 2 days ago, i drove it down a bumpy road (slow) at a coast. it dies and won't start. ive looked everywher


According to the wiring diagram, there is no inertia switch on a Mazda MX-6. The fuel pump circuit only has a pump relay which is powered by a fuse and grounded by the computer.
And if the car did have an inertia switch it would not affect the ignition system.
If you have no spark and no fuel pressure I would check the circuits for the pump, coil, and computer at those fuse locations and beyond. Could have shaken something loose at the key switch or in the wiring.

Sep 16, 2012 | 1993 Mazda MX-6

1 Answer

Car won't start. Starts w/o problems later on. i need to replace the neutral safety switch which has been getting stucked lately


if you can unplug the leads to the switch and then place an ohm meter on the two contacts, the switch should be opened when the clutch is not depressed and read ohms when the clutch is depressed

Jun 08, 2012 | 1997 Kia Sportage

1 Answer

Why is my for ford econoline won't start , i need to jump the starter solenoid to make it start


If your solenoid has two of the small terminals, one will be marked "S" and the other will be marked "I" in most cases. The terminal for the start switch is the "S" terminal If that is the one you are jumpering to the battery terminal to start it, check your "Neutral Start Safety Safety switch."
If you have a manual transmission, it will be on the clutch pedal- it may simply be out of adjustment. If you have an automatic, it will be on the transmission, on the selector shaft, it too may be out of adjustment. Sometimes simply moving and holding the column selector against the stop is enough to get it to close the circuit..

Jan 29, 2012 | Cars & Trucks

1 Answer

Car starts when cold and goes dead and won't start until cold again


Sounds like you might have a faulty ignition switch and ignition lock cylinder.These cars are known for the ignition switches getting hot and then they won't start.

Dec 30, 2011 | 1996 Pontiac Grand Am

1 Answer

1998 Mazda B4000 truck wont start sometimes


When you say it won't start, do you have any power at all, does the radio play? Does it click or make a noise of any kind? Is it a cold non start or a warmed up non start? There are a lot of factors to consider in a non start. I still have an occasional cold non start, with full power to my lights, radio, etc. Don't want to make myself sound dumb, but for me it was gear shift (controller). Not really the safety neutral switch, but put it in neutral or move the gear lever and my car would start right away. Chances are while waiting to let it start up you have hit the handle a few times and maybe knocked into position to let it start. If this isn't your problem more info is needed.

Dec 05, 2011 | 1998 Mazda B-Series

3 Answers

85' chevy manual truck ignition issues. won't start. i think its in the collumn somewhere. new keyswitch, starter,alternator, battery and cable ends.


When you say it won't start I assume you mean it will not turn over. Have you replaced the ignition switch? Not the key tumbler but the ignition switch. Have you checked the clutch safety switch?

Oct 02, 2011 | 1985 Chevrolet Chevy

1 Answer

There's an electrical switch on the clutch pedal arm (sort of like a brake lamp switch on the brake pedal arm). What does it do?


One of two things - if the switch closes when you press the pedal, it's an ignition safety requiring the clutch to be pressed when starting the car. If it's closed with the clutch pedal released it's a cruise control safety, so that cruise disengages if you push the pedal in (so the engine doesn't over-rev).

Aug 11, 2011 | 1997 Mazda MX-5 Miata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...