Question about 2002 Chevrolet Monte Carlo

1 Answer

I have a 02 Monte Carlo. I have changed crankshaft sensor, camshaft sensor, starter, fuel pump, engine module, f-p filter, tune up and the car still stalls and dies.. I have had the crankshaft learning procedure done on a diagnostic comp., and still the car dies any suggestions please. Car will crank, fire, idle, go about 3 blocks r.p.m's jump, putts, then die... Then takes forever to fire back up, Then won't idle... Any suggestion would be great already put a small fortune in it.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Chevrolet Master
  • 762 Answers

Did The OBDII scan of the stored fault history, indicate all of the parts you changed were bad. The TPS (throttle position sensor) is the only sensor that is subject to physical wear and age (2002). A dirty air filter will put the MAF (mass airflow sensor) out of range. Always let the stored fault history be your guide to any repairs to avoid buying parts you don't need. Also be aware of the low oil sensor function, it will disable the ignition if more than a quart low. Always do the cheapest fixes first.

Posted on Jun 02, 2017

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 94 chrysler concorde. The problem is it won't start, I have replaced the fuel pump and the fuel pump relay fuse. And it still won't start. What should I do now?


check see if you getting spark if not.have vechicle code scan could have faulty ECM .faulty camshaft sensor and crankshaft sensor.make sure engine has been tuned up.replace fuel filter change spark plugs and wires. before engine can run need fuel and spark.either one not working car will not crank.

Jan 12, 2013 | Cars & Trucks

1 Answer

2002 taurus 3.0L OHV stalls when hot have replaced IAC,camshaft position sensor,fuel pump and there are no codes on engine stall occurs most often when slowing and turning


If you have to wait to restart its usually a faulty coil or ignition module.
Someone would need to troubleshoot the ignition system when the engine fails to start to proceed. Could be a faulty relay too.

Sep 13, 2012 | 2002 Ford Taurus

1 Answer

I have a 1997 monte carlo that will run fine when you first start it and it sputters while driving and after about 10 miles it will die and wont start till the next morning. i changed the fuel pump and...


Hello: WHEN IT DOESN'T START THAT IS THE TIME YOU NEED TO DIAGNOISE THE PROBLEM. A INTERNAL COMBUSTION ENGINE NEEDS THREE THINGS TO RUN- AIR, FUEL AND SPARK. CHECK FUEL PRESSURE. CHECK FOR SPARK TO THE SPARKPLUGS. IT COULD BE THE ENGINE COMPUTER , THE IGNITION MODULE. IT COULD BE THE CRANK SENSOR. WITHOUT HANDS ON DIAGNOSIS I WOULD BE GUESSING.

Sep 29, 2011 | 1997 Chevrolet Monte Carlo

1 Answer

Car dies while i'm driving not when you stop just simply dies while i'm driving had the 02 sensor replaced and injectors cleaned and had a vas air syst (ma flow???) replaced and it still dies


If the check engine light is on you need to get the codes pulled. Without knowing the primary culpretes for this are intermitant crank sensor, camshaft position sensor, or knock sensor. If its not on its most likely a over heating coil or a bad ignition module. Another possibility is going to be the fuel pump going bad. However that is unlikely but possible.

Mar 17, 2011 | 2003 Chevrolet Monte Carlo

1 Answer

2000 monte carlo no gas no spark new fuel pump good modual and coils help! camshaft crankshaft???


No gaurantees, but it most likely needs a crankshaft sensor. That sensor triggers both the spark and the fuel injectors.

Feb 22, 2010 | 2000 Chevrolet Monte Carlo

2 Answers

Engine will crank but will not start and run.


Change the fuel filter first! It is located on most models passenger side center to rear center of van & tucked up near frame rail. Good luck!

Dec 01, 2009 | 1999 Ford Windstar

Not finding what you are looking for?
2002 Chevrolet Monte Carlo Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...