Question about Cars & Trucks

Open Question

Rvr gdi 2.4 almost starting but wont

Put 4 lifters in now almost starts but maby not getting enough fuel or carborn build up smothering spark plugs

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

latoss101
  • 47 Answers

SOURCE: gdi 1800 cedia wagon-odometer 80,000km exact, starting, no power

yes

Posted on Jan 03, 2009

  • 103 Answers

SOURCE: no sparks from spark plugs in the 97 nissan maxima wont start up

This car has seporate coil packs for each cylinder, have you tried swapping the front bad one with a good one to see if they switch ?
The engine you just put in may have come with some blown coils.
Hope this helps
Sam

Posted on May 13, 2009

dttech
  • 4803 Answers

SOURCE: im getting spark for the plugs and im getting

A 1999 GMC Yukon has a fuel-injected engine. They are known for the fuel injector lines inside the intake plenum to break and flood the engine. If you are pouring starter fluid and gas in the intake you are only making it worse. replace the injector assembly with the "new improved" injector assembly and replace the plugs, then it will probably start.

This subject is covered by GM Technical Service Bulletin No.: 00-06-04-003B

See GM Parts List below. This replacement Injector assembly is now also available in the aftermarket.
f098b90.gif

Posted on Nov 11, 2009

  • 1 Answer

SOURCE: i have a mitsubishi pagero

i have a mitsubishi pagero exceed gdi v6 3500cc it stall the engine and responde well while cold but on load it starts to die. somebody told me to replace the fuel enjection pump, but i don´t know where to buy. will that solve my problem.
please help me on that.

Posted on Jan 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 mitsubishi rvr 2.4l gdi wont start ,good battery and starter good spark to plugs tank pump good flow.


If you have spark and your fuel pressure is good next to check your timing get a timing light and check your timing

Oct 10, 2015 | Mitsubishi Cars & Trucks

2 Answers

My car cranks but will not start RVR GDI mitsubishi


Check all fuses first, then with an assistant, check for spark with a spark tester. if there is spark at 2 plugs, check for fuel pressure at the fuel rail with a gauge. Engines need three things to run, fuel, spark, and compression. If there is spark and fuel, do a compression test, if the timing belt jumped/broke, you won't have any

Mar 03, 2015 | Mitsubishi Cars & Trucks

1 Answer

1998 Mitsubishi Galant 1.8 GDI (EA1A model) starting problem. So it's not starting but turning engine over. Checked the spark plugs and they were oily. Cleaned them and still not firing. checked to see if...


Dude....putting 2 stroke fuel into a 4 stroke engine is just silly, but not where your problem lies. Check the coils to see if it is generating spark...if not then check the ignition module....even 'oily' the plugs should fire.

Oct 30, 2014 | 1998 Mitsubishi Galant

2 Answers

92 vw passat 2.0 16v wont start.


I bet it's the gas. After some time the gas will no longer be volatile enough to start the car. Try draining all the fuel and putting in some fresh gas. Remember, when you try to start it again you'll need to get the new gas through the pump and lines before it will start. Also, check the condition of the injectors. Old gas can start to break down and build up a film that could be on your injectors (or clog your fuel filter- better check that too). Hope this helps.

Feb 01, 2013 | 1992 Volkswagen Passat

1 Answer

Changed head gaskets now it wont start


Find out what is missing. Does it have spark? Does it have fuel?
Recheck your work and make sure you have everything plugged in. Connecting a scanner can help a lot with this because if you forgot to plug something in, it will usually set a fault code to tell you which circuit/circuits are not working.

Also, there may not be anything wrong. I have had several where the lifters were collapsed and it did not want to start after doing an intake or cylinder head gasket replacement. When this happens, you just have to keep cranking it for a while to let it build-up some oil pressure to get it started (make sure the battery is fully charged). It will usually make noise (lifters clattering) and run bad for a few minutes after it starts. This should clear up after about five minutes of running.

Feb 21, 2012 | 2001 Chevrolet Lumina

1 Answer

My 2001 Lincoln Continental has been sitting for over two years, It did start for about a minute but it wont start again. what can I do


BATTERY DEAD MORE LIKELY.CAR BEEN SITTING FOR 2 YEARS GAS IN FUEL TANK WEAK FULL OF WATER, YOU NEED TO REMOVE DRAIN OUT OLD FUEL IN THE FUEL TANK. YOU NEED ADD NEW FUEL IN FUEL TANK,CHANGE FUEL FILTER, IF CAR BEEN SITTING FOR TWO YEARS.I WOULD REMOVE SPARK PLUGS ONE AT A TIME REMOVE EACH SPARK PLUG SQUIRT FEW DROPS OF OIL INTO CYLINDER THEN REINSTALL SPARK PLUG, REASON I SAY TO DO THIS PROCEDURE IT HELP PISTON RINGS SEAL UP ENOUGH TO BUILD UP COMPRESSION SO YOU CAN START THE ENGINE WHERE IT BEEN SITTING TOO LONG.YOU NEED CHANGE ANTIFREEZE AND THERMOSTAT.REPLACE RADIATOR HOSES TO BE ON THE SAFE SIDE,REPLACE AIR FILTER.

Jul 30, 2011 | 2001 Lincoln Continental

1 Answer

Have a 1985 buick centruy with a 2.5 seems like its loading up with to much fuel wont start.I have spark timing is good, compression good, and changed the temp sensor. tried a different maf sensor(used)...


If you have spark, and the timing is good, you are either not getting enough fuel or there is not enough compression. If you checked the spark from the spark plug wires and got a spark, try changing the spark plugs. The spark from the plugs may be too weak to ignite the fuel.

Have you changed your fuel filter? This is a very common cause of a no start condition. Have your fuel pressure tested to ensure you are getting the correct amount of fuel. Also, you could try replacing your Fuel Pressure Regulator.

Feb 17, 2011 | 1985 Buick Century

2 Answers

Tapping noise under valve cover


SOUND LIKE WORN LIFTERS OR HYDRALIC LASH ADJUSTER NEED ADJUSTING OR OIL COULD BE DIRTY NEED CHANGING.CHANGE OIL FILTER AND CHANGE ENGINE OIL.USE RIGHT OIL VISCOSITY USE OIL NOT TOO THICK.USE 10W -30 OIL ADD BOTTLE LIFTERS CLEANER OR QUIETNER TO OIL CRANK CASE DONT OVER FILL CRANK CASE.IF LIFTERS STILL NOISEY THEY COULD BE WORN OUT.

Oct 14, 2010 | Hyundai Sonata Cars & Trucks

1 Answer

2002 blazer crank but wont start


2 things that you have to check on no starts every time. Spark at spark plug and fuel. Turn key to run position and listen at gas tank for fuel pump to run you should hear a whining noise. This will only happen for 3 to 4 seconds then it will shut off until engine starts. You can turn key off then to run every 3 to 4 to listen for fuel pump. You may hear the relay click off in engine area even if pump does not run. Fuel pump failure is pretty common. If pump is running pull spark plug out or put a spare plug into spark plug wire and have someone crank engine set plug on engine and watch for spark. This will give you a starting point. Hope it helps.

Mar 30, 2010 | 2002 Chevrolet Blazer

1 Answer

My 2003 ls300 Satrun wont start


Need to have Fuel and Sparks to fire up an engine. Let's check it out..
1- Start several times.
2- Take off one spark plug.
3- If it is wet, there is fuel.
4- If it is dry, no fuel. Fix this problem
5- While spark plug is out, touch it to the engin chasis and have a helper to start the ening so you can see if there is spark strong enough.
6- If there is no spark, Fix this problem.
7- If there fuel and spark then check out cold start valve, it is bad causing flood so it could not ignite.

Sep 08, 2009 | 2003 Saturn ION

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...