Question about 1993 Honda Accord

3 Answers

I need the specs to set the timing or a how to instruction to set

I need instructions on how to set the timing on a 1993 Honda Accord Lx. It has not jumped time we have to change the water pump due to a leak.

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 47 Answers

You can buy the manual for the whole car here :http://www.tradebit.com/filedetail.php/739064-1991-1993-honda-accord-service-manual you may find this more usefull and it may help you better for the future

Posted on Jan 09, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 916 Answers

Put motor TDC on #1 which is the furthest away from the distributor take motor mount off and support the front of motor with a jack. #2 take off your drive belts power steering and ac etc. Now lower the jack down a little and take off valve cover and power steering pump,set aside and remember were your bolts go.#3 take off timing cover 10 mm bolts all around the out side of the cover take top off out the top and put a 3/4 socket on a impact and take the bolt out of the center of the crankshaft take the crank pully off and remove bottom part of timing cover out through the bottom raise or lower the jack as needed#4 now their is a back balance shaft bolt in the back of the motor its a bolt take the bolt out and put a screw driver through there to hold the balance shaft from turning and getting out of time note make sure it is the bolt behind the not the round bolt with the hex in it the bolt in the block directly behind that round bolt. Put key way pointing straight up on cam gear and crank gear do this before removing old timing belt or balance shaft belt the front balance shaft has a notch cut out on the shaft that runs the gear put it straight up.#5 loosen tensioner and take the belts off. Now put your timing belt and balance shaft belt back on make sure everything stays in time nothing moves.

Posted on Jan 09, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,110 Answers

Try this

with the key in the ignition and turned ON but the radio turned OFF,

Press and hold the SOUND button.
until you hear a beep. The displayed
time begins to blink

Change the hours by pressing the
H (radio station Preset button 4) side of the bar until the numbers advance to the desired time.

Change the minutes by pressing the M
(radio station Preset 5) side of the bar until the
numbers advance to the desired time.

When you are finished, press the
SOUND button again to set the time.

hope that helps

Posted on Jan 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Installingwater pump 1993 honda accord


If you sit on a driver's seat, the timing belt and the water pump is located on your left most side on the engine under the hood, behind the main pulley. The main pulley accommodates the alternator belt, ac belt and power steering belt, if any.
The water pump and timing belt are both enclosed in the timing belt case.

Apr 24, 2014 | 1993 Honda Accord

2 Answers

1993 honda accord lx new coil no spark


The 1993 Honda Accord LX came with a 2.2 Liter Inline 4 cylinder engine. It gets 125 horsepower. ------------------------------------------------------------------------------
Renault CAN Clip

Apr 08, 2013 | 1993 Honda Accord

1 Answer

My 93 hondA ACCORD HAS JUMPED TIMING AND WONT START. HOW DO YOU SET THE TIMING WITHOUT THE CAR RUNNING?


if it jumped time then you cant,it needs a new timing belt or chain wichever your cars has.pretty major job even for a tech

Nov 14, 2012 | 1993 Honda Accord

1 Answer

My 1993 honda accord SE is overheating


It's certainly the water pump. Have the timing belt and balancer belt changed at the same time.

Jun 10, 2010 | 1993 Honda Accord

1 Answer

How to install a water pump in a 1993 Honda Accord, 2 door, automatic


It is an expert job.....you need to remove the timing belt first before removing the water pump. It;s best to replace the water pump every time ou replace your timing belt.

Apr 20, 2010 | 1993 Honda Accord

1 Answer

1987 HONDA ACCORD LX WATER LEAK


Yes, there is a "bypass outlet" coolant hose that connects from the water pump inlet pipe (metal pipe that runs from back of water pump along engine block to lower radiator hose) to the intake manifold.

I am not sure about the "black box" - not enough detail.

Jul 14, 2009 | 1987 Honda Accord

1 Answer

Motor using water and wanting to over heat?


It sounds like the pump, if it is leaking from the water pump, you should stop driving it right away as the pump is driven off the cam timing belt and if that comes off, major damage to the engine will occur. There is also a balance shaft belt under the timing cover, it should always be changed with the timing belt when the water pump is replaced.

http://arrc.epnet.com/autoapp/8680/chiltonimages/8680/86803139L.gif

Apr 09, 2009 | 1992 Honda Accord

1 Answer

1993 honda lx run cool while running ,but after it


check thermostat might be sticking or radiator may need flushing if it only heats up while idling check your electric fan may not be coming on try turning on the a/c the 2 cooling fans should come on then if they do then i would check the cooling fan switch if they do not come on when the a/c is switch on you may have a bad electric fan motor or wiring to the fan or fan relay

Feb 26, 2009 | 1993 Honda Accord

1 Answer

How to put a new timing blet on a 1993 honda accord LX 2.2 L


well chances are you now have bent valves , if you bought the car with a bad timing belt then most likely the valves are bent since that motor is an interference engine.

Feb 08, 2009 | 1993 Honda Accord

Not finding what you are looking for?
1993 Honda Accord Logo

570 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

68970 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...