Question about 2005 Chrysler Town & Country

1 Answer

Automatic door locks do not work

When using the remote the automatic door locks do not work on all doors except the rear tail gate lift. the power door lock on interior door does not activate locking.the power windows work fine.

Posted by on

  • JulieKW Jan 25, 2009

    I have to same problem. Could it be a bad fuse?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 22 Answers

For that problem you will have to take it to the dealer the body control module stores codes that will aid in diagnosing the problem. one of the more common problems, a software issue. the body computer may need to be reflashed to the latest software level to correct.

Posted on Jan 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2005 chevy tahoe my doors all licks but my liftgate door with window stays open use to lock w all my doors? I havent check anytjing yet? I cant lock it.


Here is how it works !
Liftgate Locking Operation
The lift gate will lock any time the vehicle is shifted out of park on vehicles equipped with an automatic transmission and at vehicle speeds exceeding 5 kph with manual transmission. This happens in conjunction with auto door locks if enabled or independently of auto door locks if the feature is disabled. This ensures that the lift gate is locked anytime the vehicle is shifted out of park or when the vehicle is in motion.
The lift gate lock relay supply and coil sides receive a constant voltage through the battery voltage supply circuit and the ECC fuse. The normally closed contact is connected to ground and the control side is connected to the body control module (BCM). A lock function will occur when a door lock switch activation, keyless entry lock transmission, auto door lock function or a lift gate lock function has been received by the BCM. The BCM will then ground the control side of the lift gate lock relay. This energizes the relay and allows voltage to be applied to the lift gate lock actuator lock control circuit. Since the other side of the lift gate lock actuator is connected to the normally closed contacts of the door unlock relay to ground, the lift gate will lock. When an unlock function occurs the BCM will ground the control side of the unlock relay and the rear doors and lift gate will unlock.
The BCM also runs diagnostics on the lift gate lock relay control circuit and will set DTC B3825 as current and also send a Class 2 message to the DIC. The DIC will display REPLACE LIFTGATE FUSE to inform the driver that a fault has been detected in the lift gate lock circuit and that the lift gate is not locked. Faults that will set the DTC and cause the DIC to display the message could be any of the following:
?€¢
An open ECC fuse


?€¢
An open or short to ground in the lift gate lock relay battery positive voltage circuit


?€¢
A faulty lift gate lock relay


?€¢
An open or short to ground in the lift gate lock relay control circuit


?€¢
A short to ground in the lift gate lock actuator lock control circuit


?€¢
A faulty BCM

May 14, 2016 | Cars & Trucks

1 Answer

Rear tailgate will not unlock


You will need to detrim the tailgate and manually access the latch mechanism and release the tailgate and find out the cause of the fault.

Apr 25, 2016 | Mitsubishi Cars & Trucks

1 Answer

2008 explorer door locks not locking from door switches


This is not a good thing. Ford uses a computer called the GEM and that means General Electronics Module. It controls:
  • Low Coolant Indicator On Cluster
  • Brake Indicator on Cluster
  • DRL - Control
  • Wipers
  • AutoLamps
  • Rear Defrost
  • Interior Lamps(dome)
  • High Beam Indicator only (cluster)
  • Low Coolant indicator
  • Key-in Buzzer
  • Seatbelt indicator only (Cluster)
  • Trunk Pop Relay
  • Power Locks
  • Door Ajar Sensors
  • Door Keyless entry pad
  • Remote Keyless Entry
  • One Touch Down (power window)
  • Air Bag Tone
  • Anti Theft (perimeter Alarm) (SEL, or SE(s) with mods)
  • Lift gate ajar (wagon)
  • Liftgate Pop
  • Accessory Delay signal (accessory that work after engine off, prior to door ajar)
  • Battery Saver Relay signal (accessory that work after engine off, 15 mins) Map lights, vanity mirrors

They are located behind the radio in the dash and they are $$$ about 600 USD.

Jan 27, 2014 | 2008 Ford Explorer

1 Answer

2008 Pontiac Torrent lift gate will not open


Hotnurse37. I'd you fix your problem. I have same issue. Fuse is okay. Remote will open all doors but I can't even hear the rear attempting to unlock. Did get access to emergency release after trying for a long time. Lock and latch looked fine but back to same problem after closing lift.

Apr 04, 2013 | 2008 Pontiac Torrent

2 Answers

My rear lift gate does not unlock. The rest of doors do, it is a four door. Also my front drivers side window does not roll up or down. Here again JUST the drivers window, the rst roll up and down. Could...


They are not related ...
The lift gate locking mechanism can be accessed by removing the interir trim pannel on the gate ... and locating the locking actuator and replacing it...
The same can be done for the power window motor ... remove the interior trim panel and replace the power window motor...

Hope I helped !!

Oct 06, 2010 | 1999 Jeep Grand Cherokee

2 Answers

Rear tail gate will not open


how to i open a stuck lift garte on a ford winstar 2000 lock broken too

Jun 14, 2009 | 2001 Ford Escape

1 Answer

When driving the vehicle the interior lights flash on and off the power locks flutter and the door ajar chimes.


Check the rear lift gate switch. Or it could be that one of the doors or the rear lift gate is out of adjustment and not closing tightly. Try closing all doors and lift gate then from the outside push in on the doors and see if they go in. If it is the doors , when you push on the one that is causing the problem the door ajar chime will stop .

Feb 19, 2009 | 1997 Plymouth Voyager

4 Answers

Remote starter does not work but will unlock and lock doors.


I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John

Dec 08, 2008 | 2005 Pontiac G6

1 Answer

Remote lock for back doors and rear tail gate door


Actually I found a solution. I remove the lock relay form the fuse panel and placed it back in place. I did not replace it. After doing this they worked. I probably need to replace the relay at some point, but for now that solved the problem. It was hard for me to believe that there is a separate relay for the lock and unlock circuit.

Sep 28, 2008 | 2005 Chevrolet Suburban

1 Answer

Power door locks do not work at all lights flash when remote is used to unlock doors. automatic lock feature does not work Once manually unlocked, sliding side doors work ok. tail gate can be used to opens...


the reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators. even if you change the acuators the locks still will not work until the code is cleared.

Sep 14, 2008 | 2000 Dodge Grand Caravan

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...