Question about 2001 Toyota Sienna

1 Answer

Power Lock doesn't work

Hi! I am Hawk.
I have a Siena CE 2001 Model. Yesterday morning, I couldn't use the power door lock. It didn't work.
And next I found that the interior lights were gone too. Also when I turn key to stop position, the head lights turned off too. Usually, I stop engine and open the door, the head lights turn off.
So I thought that it is fuse problem, but I am not sure. I checked the fuse box, but I cannot understand what the abbr. describe.

Posted by on

  • nolaughingma Mar 23, 2009

    I have the same problem. First, my clock went out, next the power locks would not work or keyless entry would not work and next the light for the interior would not work. I was wondering did changing the fuse help.

  • Anonymous Mar 26, 2014

    no power to door locks /windows/raido/air system/ power mirrors car dose start and the doom light /head lights work

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 2001 sienna xle,,, the power locks fuse box is under the dash to the left of the seering wheel behind the change holder..... changing the fuse should reactive the locks....also u have three fuse boxes under the hood..good luck

Posted on Jan 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Elantra door locks controlled by the drivers door lock no longer work. Happened yesterday.


There should be a fuse that runs the power locks. Check and make sure it didn't blow.

Jun 25, 2014 | 2001 Hyundai Elantra

1 Answer

2001 ford expedtion liftgate window wont lock


The door has contacts I think that provide power to the lock motor, find then and clean them, if the model doesn't have any contact pads then check for a damaged wiring harness into the rear door, if that is ok replace the lock actuator inside the rear door.

Oct 01, 2012 | 2001 Ford Expedition

1 Answer

2008 Chevy Uplander not locking


I had the exact same problem start with mine yesterday. I found a suggestion to check the fuses that are located on the passenger side of the vehicle but I didn't see any problems there so my next step will be to change the driver side door switch which appears to be the master switch.

Jun 28, 2012 | 2008 Chevrolet Uplander

1 Answer

2001 aurora rear door lock and window does not work


There is a door module in each door. This could be the issue and would be the next part I would try. I have also had issues with the connectors going to this module.
Note also that the switches are tied into the master switch on the drivers door. Make sure the "window lock" is not on. Although this would not effect the power door lock.

Dec 10, 2011 | 2001 Oldsmobile Aurora

2 Answers

Hi Mike i have a 2001 olds aurora with both rear doors and windows out of commission. Seems like neither is getting any power the windows don't go up or down and my keyless remote will not unlock or...


There is a control module in each door with connectors. I have already had one where the wiring in the connector was bad. This takes some troubleshooting, but sometimes moving things around while trying to run the windows will should you where the loose connection is.

Oct 18, 2011 | 2001 Oldsmobile Aurora

2 Answers

Does a 2002 Toyota RAV4 have a relay for window motor? This car is one of the cheap-material-made junk one ever buys, it took Toyota years to finally recall transmission problem on sears of 2001-2003 more...


Hi, there is only one relay for all of the windows, so that is not the problem. The likely problem is the switch. I recommend you test the switch using an ohmmeter.
In the case of the door lock, that problem may be a failed lock motor. I recommend you apply power directly to the lock motor to see if it works. If it does, check the switch. If not, replace the motor.

jturcotte_2106.gif

jturcotte_2107.gif

jturcotte_2108.gif

Aug 18, 2011 | 2002 Toyota RAV4

1 Answer

Power door lock on the chevy venture 2000 don't


check the system fuse and or circuit breaker. check the switch wires for damage and loose connections. check the switches for continuity. remove the door panel(s) and check the actuator wiring connections to see if they're loose or damaged. inspect the actuator rods if equipped to make sure they arn't bent or damaged or loose connections. the actuator can ce momentarily. a discernible click indicates that the solenoid is operating properly.

Nov 17, 2009 | 2000 Chevrolet Venture

Not finding what you are looking for?
2001 Toyota Sienna Logo

471 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...