Question about 1999 Dodge Intrepid

1 Answer

Replaced the blower motors and had Air Conditioning. Now no heat

I had no air conditioning and they replaced the blower motors because it was also over heating. I had air after that and now that it is winter, I have noticed that I have NO HEAT and the over heating has started again. What can I do?

Posted by on

  • 2 more comments 
  • wolgirl2004 Jan 09, 2009

    Yes, I checked the level and was able to add some coolant to the overflow. There is no coolant in the oil. This last Summer, I did not have any air conditioning and the car would over-heat on occasion. When I took it in, they stated that my blower motors were not working and then also that I had some fuses that were blown. They replaced the blower motors and the fuses and now, since it is Winter, when it came to using my heat, I discovered that it would come and go. Now I have NO heat and the car is over-heating once again.

  • Mike Butler
    Mike Butler May 11, 2010

    Also ,Check if the radiator fan comes on when temperature gauge hits the normal running temperature on your gauge, or close to it.

  • Mike Butler
    Mike Butler May 11, 2010

    O .K. Now I think were getting some where. So when you say blowers, you mean the radiator fans under the hood. I call the blowers the fans that blow air out of your heater/defroster inside the car. Exactly where is/was your level on the coolant return bottle, is it up to the level required, marked on the side of the bottle for full hot, & full cold? If engine is currently cool, can you take rad cap off carefully & see if level is up close to top, inside the radiator. What engine does your car have in it? Has the thermostat been changed lately?

  • Mike Butler
    Mike Butler May 11, 2010

    have you checked your coolant level in rad & bottle?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Thank you, however, I have the problem under control.

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

A rattle and vibration coming frfom inside air conditioning vents


  1. Check the air conditioner fuse and replace as necessary.
  2. Air conditioner system discharged. Have the system evacuated, charged and leak tested by an MVAC certified technician, utilizing approved recovery/recycling equipment. Repair as necessary.
  3. Air conditioner low pressure switch defective. Replace switch.
  4. Air conditioner fan resistor pack defective. Replace resistor pack.
  5. Loose connection, broken wiring or defective air conditioner relay in air conditioning electrical circuit. Repair wiring or replace relay as necessary.

Nov 23, 2010 | 2008 Volkswagen Jetta

1 Answer

Air conditioner sporadically blows air when it should be constant. Air filters cleaned and computer unit replaced, what have we missed?


The blower, if working sporadically should be replaced or the relay to it. If the blower is on all of the time that the ignition is on, but air isn't coming out of the vents, there is a vacuum motor problem in the heating ventilation and air conditioning system, behind the dash board and hvac panel.

Aug 13, 2010 | 2000 Buick Park Avenue

1 Answer

Air conditioning


check blower motor resistor common problem on most vehicles..

Jul 11, 2010 | 2004 Infiniti I35

1 Answer

How to troubleshoot the electrical air conditioning system 2000 GMC Yukon Denali. I put in new resistor, relay and dealer blower motor and it still doesn't do anything. Air conditioning control switch...


The compressor on the air conditioner in my 2000 GMC Yukon XL went out last summer. Had it and the whole line replaced at a local air conditioning shop last fall. Used it little before cold weather. Warm weather this spring and no cold air. We could hear the compressor trying to kick in. The shop told us that the control console was bad and had to be replaced. They told us the part was on back order and did not know if they would be abel to get one any time soon. We took the Yukon into the local GM dealership. They told us that the high side fitting was bad and that the freon was very low and that they would have to deal with that first to check the system. Called back to the air conditioning shop and they said they had a console come in and they would put it in and check the high side fitting. I now have cold air and questions. Bought Yukon in 2005 used, had always had problem of not switching to cold air once the heater has been used. We were told changing the console should fix that. It has not changed. I feel like the console angle was a scam, that the system was just low on freon. Each shop was blaming the other for trying to scam me. And what can fix the heat to cold issue? If anyone has answers I would sure appreciate the knowledge.

Jul 02, 2010 | 2000 GMC Yukon Denali

1 Answer

2000 chevy impala, air conditioning does not work


It sounds like the blower resistor needs to be replaced and the blower motor it self. Auto Zone will have the blower and resistor that you need to replace and will have the step by step instructions for you to get the job done with common tools and will take about 2 hours if your good with tools. Good luck and keep me posted. Setting 5 should have 12 volts running to the blower motor so check the wire harness for voltage readings at the blower motor harness clip, you may only just need a new blower motor.

Nov 08, 2009 | 2000 Chevrolet Impala

1 Answer

When you turn the heat on the blower motor starts making a grinding noise


could have debris in the fan housing or the blower motor bushings or bearings are going out. take the fan out of the air conditioning case and vacuum out the air conditioning/heater core assembly case. then hook everything back up and see if this works.

Oct 12, 2009 | 2000 Chevrolet Silverado 1500

1 Answer

Air conditioning works on high level


Replace power module. Its under the hood. In the air duct up against the firewalll. About 12" to the left of the blower motor. Has 2 connectors on top. Its black. May be hard to notice. Probably have to remove cross brace to get at.it. Then remove 3 screws and pull it out. Put in new one. Reattach brace

Jun 28, 2009 | 1996 Plymouth Voyager

1 Answer

Heating and air conditioning


The blower motor works on high setting ONLY when the blower resistor is bad. The blower motor resistor is held in place with 2 screws and attached into the heater housing under the right side of the dashboard. You can identify the resistor by the big wires that are connected to the connector. If this heating/cooling system is the auto temp type, the part is a bit high on the price.

Feb 10, 2009 | 2005 Jeep Grand Cherokee

1 Answer

1995 Buick Lesabre- heater blower


Notes Electronic Automatic (RPO C68)/ Dual Zone Air Conditioning (RPO CJ2) 62396444

Jan 09, 2009 | 1996 Buick LeSabre

Not finding what you are looking for?
1999 Dodge Intrepid Logo

Related Topics:

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...