Question about 2006 Hyundai Santa Fe

Open Question

2006 Santa Fe Monsoon Stereo Crossover removal

Where are they and how do I remove them. After market stereo and speakers. There are more wires in the front doors for the 3 speakers than there are at the back of the amp so there must be crossovers somewhere that split the signal. I think the right one isnt working properly any way. I dont want to run all new wire.

Posted by on

3 Suggested Answers

  • 1 Answer

SOURCE: 2000 f150 ford coolant crossover problems 5.4 liter engine

sitting timimg chain on 2000 f150 5,4

Posted on Jan 28, 2009


  • 1 Answer

SOURCE: 2006 hyundai santa fe stereo wiring color code

I was given two Lanzar 6.5 and two Pioneer 6.5 speakers. There is nothing wrong with my stock speakers, I just wanted to add a little more thump and clarity. I took off the front drivers side interior panel, Which wasn't all that bad, but i'm having major problems putting it back together. I'll get into that a bit later. I figured swapping the old for the new would be simple. Being it has two wires (pos/neg) going to the driver/speaker cone and two wires going to the tweeter portion that goes over the lower part, four wires total. The wires are White, Brown, yellow, and Black going into a black clip, then they turn black coming out the other side. I cut the four after the clip. My new speakers have only two posts to accommodate the driver and tweeter. So I left off the two for the tweeter and it sounded awful. I tried combining the two positive and two negative and hooking it up that way. That too sounded awful. The tweeter was squealing and chirping. I tried every configuration. They all sounded like ***. What am I doing wrong. I know people swap out stocks for after market all the time. I wanted to be sure my new speaker wasn't defective, so I tried all four (Both brands) with the same results. So I gave up and put the original back in. It sounds fine, just like it had before. But now I can't put the door panel back on. I know it's just tricky and i need more patience. I'm so bummed. I have these great speakers and have no idea why I can't install them. Do I need some aftermarket clip? It seems so easy, why is it so flappin hard? I've done this with other cars in the past with no issues. This four wire thing is killing me... Please HELP ME!!!!!!!!

Posted on Jan 24, 2011

sulavaca
  • 1007 Answers

SOURCE: what is the pink wire for in the stereo of a 2006 Hyundai Santa fe? and what do I connect the dimmer wirefrom the santa fe to in a new stereo

The pink wire from the stereo unit is often the dimmer wire, and is connected to a power feed from the vehicle's side lights. Not all stereos have a dimmer function however, and may not have this wire available.

Posted on Nov 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 Hyundai Santa Fe with a Monsoon sound system. I reinstalled the stock head unit and with it powers on, it's locked? How do I unlock the Monsoon Stereo head unit?


Look in user manual or on back of head unit for unlock code. If not written down. You will have to contact the dealer and provide serial code from back of radio. It's a anti theft protection.

Sep 09, 2015 | Hyundai Cars & Trucks

1 Answer

What is the pink wire for in the stereo of a 2006 Hyundai Santa fe? and what do I connect the dimmer wirefrom the santa fe to in a new stereo


The pink wire from the stereo unit is often the dimmer wire, and is connected to a power feed from the vehicle's side lights. Not all stereos have a dimmer function however, and may not have this wire available.

Nov 04, 2012 | 2006 Hyundai Santa Fe

1 Answer

Where is the fuse located for a 2003 Hyundai Sante Fe CD Player


facing the engine when you open he hood they are on the front right hand side with a large black cover over them. There is also internal fuses on the driver door side, below the dashboard, just above...


Performance Chip

May 23, 2012 | 2003 Hyundai Santa Fe

1 Answer

On my 2002 Santa Fe, while playing the radio the speakers keep going on and off; but the cd player is fine. How would I gain access to replace the stereo?


to access the stereo you need to remove the dash piece around the control panel. after that you will see 2 or 4 screws holding in the stereo housing remove that and the stereo should slide right out. good luck.

Feb 06, 2011 | 2002 Hyundai Santa Fe

1 Answer

2006 hyundai santa fe stereo wiring color code


I was given two Lanzar 6.5 and two Pioneer 6.5 speakers. There is nothing wrong with my stock speakers, I just wanted to add a little more thump and clarity. I took off the front drivers side interior panel, Which wasn't all that bad, but i'm having major problems putting it back together. I'll get into that a bit later. I figured swapping the old for the new would be simple. Being it has two wires (pos/neg) going to the driver/speaker cone and two wires going to the tweeter portion that goes over the lower part, four wires total. The wires are White, Brown, yellow, and Black going into a black clip, then they turn black coming out the other side. I cut the four after the clip. My new speakers have only two posts to accommodate the driver and tweeter. So I left off the two for the tweeter and it sounded awful. I tried combining the two positive and two negative and hooking it up that way. That too sounded awful. The tweeter was squealing and chirping. I tried every configuration. They all sounded like ***. What am I doing wrong. I know people swap out stocks for after market all the time. I wanted to be sure my new speaker wasn't defective, so I tried all four (Both brands) with the same results. So I gave up and put the original back in. It sounds fine, just like it had before. But now I can't put the door panel back on. I know it's just tricky and i need more patience. I'm so bummed. I have these great speakers and have no idea why I can't install them. Do I need some aftermarket clip? It seems so easy, why is it so flappin hard? I've done this with other cars in the past with no issues. This four wire thing is killing me... Please HELP ME!!!!!!!!

Jul 10, 2010 | 2006 Hyundai Santa Fe

1 Answer

Which wire is which in replacing an old stereo in


go to best buy and buy a wiring kit. it has manual to guide you step by step. best of luck

Aug 07, 2009 | 2004 Hyundai Santa Fe

1 Answer

How do I put in a stereo system on a santa fe 2001


remove the two screws that are behind ash tray pull that part out remove wire clip to cig, lighter. there are two screws on the bottom of the plastic around the radio. use a pry tool or butter knife to pry the plastic surround from around the radio. disconect the wire clips for the hazard lights an rear defrost clock.etc...remove the four screw that hold the radio in place. if u need more info let me know

Jul 07, 2009 | 2001 Hyundai Santa Fe

1 Answer

Wiring after market stereo to factory wiring equipt with factory amp


you have to get the cable that conects your factory deck harness to the aftermarket deck, and that will allow you to use your factory speakers and amp, the wire harness is availiable at canadian tire or any stereo shop

May 05, 2009 | 2001 Pontiac Grand Am SE

1 Answer

06 hyundai monsoon radio won,t turn on.


Just got an update from a dealer that might work...take the head unit out and unplug the power for about 30 sec. plug back in and the unit should basically reset itself. If that doesn't work I'm out of guesses.

Dec 27, 2008 | 2006 Hyundai Santa Fe

Not finding what you are looking for?
2006 Hyundai Santa Fe Logo

Related Topics:

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...