Question about 1999 Ford Explorer

1 Answer

Hi I have a 1999 ford explorer and the drivers side seat belt won't plug in is this something I can fix myself?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 95 Answers

If you mean that the buckle won't lock into the latch, or receiving part of the seat belt mechanism, yes. The latch probably needs to be replaced, but I would recommend having the dealer replace it so that the torque specifications and legal obligations are met. You might have something in it that could be cleaned out with compressed air, but you want to make sure it locks securely in the event of an accident. 

Posted on Jan 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't the driver's side seat belt in my 2012


possibly there is something stuck in the belt not letting it retract

Apr 15, 2012 | 2012 Scion xB Base Wagon 2.4L 4-cyl....

1 Answer

Turn signal and flasher dont work


For 1999 Ford Truck Explorer 4WD 4.0L EFI SOHC 6cyl check the Flasher; this is located in front seating area, driver side, behind dash, mounted on steering column .

Hope this helps (remember to rate and comment this answer).

Mar 14, 2011 | 1999 Ford Explorer

1 Answer

The air bag light is on while driving my 1999 Ford Explorer


disconnect the battery and then find the sensor wiring connector under the front seats ,pull teh plug in and out a couple of times ,if no joy then disconnect battery again and plug and un plug the other end of the cable onto the pyrotechnic device at the bottom of the seat belt anchor

Nov 09, 2010 | 1999 Ford Explorer

1 Answer

Driver side seat belt retractor broke. how to fix?


yes you can. I suggest you go to the scrapyard and purchase one there. they are easy to replace and inexpensive.

Jul 09, 2010 | 1994 Toyota Corolla

1 Answer

My driver seat is broken on my 1999 Ford Explorer XLS. I just picked up a used 2000 Explorer Sport seat with 6-way power adjust. Where can I find power for the seat? There is a plug below the seat but it...


Basically, you need to find one of the wires in the original harness,that will have power in it,and make the seat operate. I sure
hope you left a little slack on the wiring plug, when you cut it,or
you'll need to bypass the plug connection altogether. they make special connector pin removal tools,so you can remove and reinstall the wires at the plug. My suggestion to you is, go get or
barrow a digital multimeter, so you can find the actual powered wire in the harness,so you can just find the wire from the seat, that
requires the power, and make your seat work properly.
Good luck.

Mar 31, 2010 | 1999 Ford Explorer

1 Answer

Airbag light indicates code 51 on 2005 ford explorer sport trac. codes not listed in owners manual or repair manual. does anyone know without putting a computer on it?


It is a very plain code it has something to do withthe drivers side seat belt buckle. Either out of range short to power or ground etc. Need a more specfic code to pnpoint exact problem but I can tell ya it is in your drivers seat belt connection somewhere

Apr 11, 2009 | 2005 Ford Explorer Sport Trac

1 Answer

The driver seat of my ford explorer has come loose


remove seat - 4 bolts mounting to floor - unplug and remove seat - look for missing bolt, probly on floor under seat or in seat, reassemble seat back, install and plug in seat

Mar 20, 2009 | 1999 Ford Explorer

1 Answer

Driver side seal belt


remove trim - coulpe screws and look behind trim, most likely belt twisted

Mar 13, 2009 | 1999 Ford Explorer

1 Answer

Driver side seat back is loose


Sounds like your latch is broken. You can replace the latch, it is spring loaded .Once you remove the trim around the latch and pull the seat cover up you can gain access to the bolts. You will need a torx bit ,I believe a t40 not sure. 13mm and 15mm socket.

Jan 26, 2009 | 1999 Ford Explorer

2 Answers

1999 Dodge 2500 passenger side seat belt wont release


so after completely tearing the seat apart I found 2 wires going up to the seat belt mechanism from under the seat, these wires got caught in the seat mechanism underneath and were shredded. There must be a small solenoid inside the seat belt mechanism because I could hear it click after I repaired the wires(this circuit is live even with the ignition off) Im not sure how it all works but this solved my problem.

May 21, 2008 | 1999 Dodge Ram 2500 4WD

Not finding what you are looking for?
1999 Ford Explorer Logo

325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...