Question about 2000 Dodge Dakota Quad Cab

2 Answers

Engine check light

I attached a obdII scanner to a 2000 dodge dakota Quad cab with a 4.7L engine to find out what the code would be for the light coming on, the error code is P1698, no ­ No CCD/J1850 Message From TCM/PCM. What does this mean and haw can it be fixed, this happens only after using a remote starter a couple of time and then the light will come and have this same code all the time. The truck still runs fine.

Posted by on

  • Anonymous Mar 27, 2014

    truck runs fine just can't get the check engine light off

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,559 Answers

It means that it didn't receive a signal from the transmision module.
Have your transmission control module checked.

To reset your engine codes:
Remove the negative terminal of your battery (10mm wrench).
Turn your ignition key to START and hold it there for about 15 seconds.
Turn your ignition key to OFF and remove it.
Connect the negative terminal of your battery.

TCM (Trans control Module)
(electronic transmission control module)

Posted on Jan 09, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

It probably has to do with the remote start:

http://www.wjjeeps.com/faultcodes.htm (same engine)

P1698 (M)
No CCD/J1850 Message From TCM
No CCD/J1850 messages received from the electronic transmission control module (EATX) or the Asian transmission controller.
P1698 (M)
No CCD/J1850 Message From PCM
Bus communication failure to PCM. A “Companion DTC” was set in both the ECM and PCM. May be caused by after market remote starter. Remove after market remote starter. This code can be set as the remote starter is activated and the pcm receives ignition run voltage and the tcm does not.

Posted on Jul 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 dodge dakota quad cab (4.7L / V*). My check engine light kept coming on after tightening the loose gas cap. I purchases a new gas cap specifically for my truck and the light came on again...


Check that there are no other leaks in the gas filler neck or gas tank itself that would cause the gas cap error to cause the check engine light to go on.

A lack of pressure in the tank can cause the check engine light to go on, erroneously signalling that the gas cap is loose or missing.

Good luck on this repair.

Oct 18, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

2000 Dodge Dakota check engine light code p455


PO455-EVAP Contol System Leak Detected

Gas Cap
EVAP canister purge valve stuck closed
Loose hoses
Vent solenoid stuck open
Fuel tank pressure sensor
Etc

That should keep you busy for awhile

Best take it to a shop with an EVAP Smoke Machine and Professional Scanner

May 13, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

Have 2000 dodge dakota quad cab air conditioner quits


When you recharged the vehicle did you have it vacuumed?

Apr 09, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

2002 dodge dakota with a check engine light code 442


P0442:

Small leak detected in evaporative purge system

if i had to guess I would say that your gas cap is not on tight enough or that is is bad. chrysler has had a lot of bad gas caps that cause EVAP service engine lights.

Feb 12, 2010 | 2000 Dodge Dakota Quad Cab

2 Answers

I have a 2000 Dodge Dakota Quad cab SLT 4x4 that won't start. The engine will turn over but, as soon as I release the key, it shuts off. The ABS and BRAKE dash lights stay on.


It could be a cam or crank sensor. Have someone plug a OBD II reader in and pull all the codes.
That will give you some idea.
Please let me know what you find.

Feb 10, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

I have a 2000 Dodge Dakota Quad Cab 3.9L V-6 w/ cooling problems


Check coolant, adjust drive belt, check radior core and radiator grill clean, remove and chweck thermostat, check cooling fan, check ignition timing, water ppump may be going out, improper grade engine oil.

Jun 30, 2009 | 2000 Dodge Dakota Quad Cab

1 Answer

Check Engine Light comes on and off w/ P0304 code


this may be a defective fuel injector or a defective PCM (powertrain control module).

May 30, 2009 | 2000 Dodge Dakota Quad Cab

1 Answer

2000 Dodge Dakota 4.7 L P0320 Code


p 0320 is for the crank sensor which should be on the passenger lower side of the engine near the bell housing

Dec 13, 2008 | 2000 Dodge Dakota Quad Cab

Not finding what you are looking for?
2000 Dodge Dakota Quad Cab Logo

1,433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...