Question about 1999 Oldsmobile Intrigue

1 Answer

Transmission filter replacement 1999 oldsmobile intrigue

I was just needed to know the torque needed when I put the transmission pan back on the transmission after I change the filter. I have a 1999 olds intrigue with a 3.8L engine.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

25 ft pounds is pretty commont on trany pans.

Posted on Jan 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I have a 00 Bmw 323ci I just put a new used transmission in it I got a new filter and gasket for the transmission but I need to know what's the torque for the bolts when putting the pan back on


on transmission and oil pans i normally torque them to where you can see the gasket compressed to where its starting to fill the gap between the pan and the trans and i've never had a leak yet

Oct 06, 2015 | BMW Cars & Trucks

1 Answer

Mazda 1999 B3000 what specifically needs to be replaced when transmission fluid get into the radiator?


The radiator must have an internal leak between the coolant and the reservoir for cooling the transmission fluid. Replace the radiator, drain and flush the engine and heater core, and drain and replace the transmission filter. You will need to remove the lower transmission pan, let it drain out (about 6 quarts), then replace the filter that is there, just underneath the pan. If you see any evidence of coolant in the transmission fluid, put it back together, run the vehicle for a bit-till the engine has warmed up, a short drive should do-then shut it off and drain the transmission fluid again.

When the transmission is drained this way, not all the transmission fluid will be drained-about half will still be in there, mostly in the torque converter. So if the fluid is contaminated, you need to drain and refill at least twice.

Aug 24, 2014 | Cars & Trucks

1 Answer

1999 oldsmobile intrigue stalls and surges under deceleration conditions only. Idles in neutral fine, accelerates fine, has no apparent miss. Can put in gear and travel great until under negative torque...


Do you have any codes? If so, what are they?
If not, this could be a mechanical problem with either the torque converter itself or some sort of stuck valve in the valve body inside the transmission.
I just replaced the valve body in my wife's 1999 Mercury Sable and it cleared up a number of problems she was having with shifting and torque converter lock up.
I hope this helps.
Good Luck!

Sep 21, 2013 | 1999 Oldsmobile Intrigue

1 Answer

I need a transmission but i need to know the ID # for a intrigue 2000 transmission


Info may be in owner's manual at http://www.manualowl.com free PDF

Apr 11, 2012 | 2000 Oldsmobile Intrigue

1 Answer

I have a 2002 mercury cougar V6 automatic and I know what the problem is. My car needs to have the transmission pan taken out and replaced along with the gasket. My dad and I want to fix it ourselves but...


easy job. Just loosen pan bolts enough to let the fluid start draining from one end. As more drains, keep loosening the pan bolts till you can remove pan and finish draining what's left in the pan. At this time, most people would also change the transmission filter body: it's right on bottom of trans. when the pan is removed, easily accesible. Parts stores sell a kit with new filter and pan gasket included. Anyway, now you are ready to install new pan gasket. Clean gasket mating surfaces as clean as you possibly can. let no oil or fluid get back on there. Place gasket on (most don't recommend adding sealant or gasket compound). Put pan on with all bolts fingertight. Then starting from center outward, start tightening them down to torque specs-it'd be pretty light torque, like around 20 ft-lbs-might want to ask a ford mech. what torque specs are. When done, refill ****** and check for leaks after running car.

Oct 14, 2011 | 1999 Mercury Cougar

1 Answer

The transmission on my 1998 Oldsmobile Intrigue had worked perfectly and then I had noted that the transmission only worked in 1st, 2nd, and reverse gears. When I try to put the transmission into drive,...


The transmission fluid, filter, shift solenoid needs to be inspected.That might be causing this problem of transmission not going in drive mode with gas pedal pressed down.------- The transmission needs to be taken apart and inspected, may be solenoid not opening/ closing properly or gears dried up and fluid is required. first inspect the transmission fluid and filter.if fluid is low, get the fluid changed and if filter is dirty, get it replaced.but if problem is same, then transmission needs to be torn out and inspected internally for worn out solenoids and clutch plates and valves.--------- this will help.Thanks.Helpmech.

Sep 13, 2011 | 1998 Oldsmobile Intrigue

1 Answer

My sons first car he is looking at 1998 oldsmobile intrigue. What is the transmission life expectancy with 168000 if it has been well maintained.


An "intriguing" question, and one with out a real answer, except that if it has been well maintained, then to keep it that way. The transmissions on these GM's are average, like any car ,and can be as good or better than the engine. If there is concern for this, ask for records of transmission filter and fluid changes, which should happen roughly after every 50,000 mi. After purchasing, have the transmission fully flushed to include the torque converter.

Feb 16, 2011 | 1998 Oldsmobile Intrigue

1 Answer

How do i change the transmission filter on a 2000 oldsmobile intrigue?


drop the pan off the transmision and let all the fluid drain out. the filter will be right there shouldnt have any bolts in it but make sure and pull it slowly out of its slot and replace with a new one then put a new gasket on the pan and put it back together

Jul 25, 2010 | 2000 Oldsmobile Intrigue

1 Answer

How do you change the transmission fluid in a 1998 oldsmobile intrigue?


Drop the pan, replace the filter, refill with transmission fluid, check your OM for type and quantity, recheck when warm in park.

Oct 20, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Torque settings for transmission pan bolts on a 98 Olds Intrigue?


10 -15 fp. If you put a gm filter on this it will have made in gasket bolt spacers to keep you from over-tightening bolts

Apr 14, 2009 | 1998 Oldsmobile Intrigue

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

Related Topics:

370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...