Question about 1995 Buick Park Avenue

2 Answers

Car won,t start, getting fire from the module,gas is coming up to

Injectors,but car won,t start?

Posted by on

  • 1 more comment 
  • dodobrown46 Jan 09, 2009

    yes I,ve checked the coils and fuses not the timing it turns like it want to start but won,t

  • dodobrown46 Jan 09, 2009

    It just turns when i turn the key to start I don,t know if the gas is getting to the plugs

  • Phillip Ridener
    Phillip Ridener May 11, 2010

    Could you be more specific on what the car is doing? Thank you. PHil

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 585 Answers

Check the fuel pressure with a gauge. It should be 45 PSI or more. Lack of any fuel pressure indicates a problem with the fuel pump. Presence of low pressure could be the pump, fuel filter, or a leak in the flexible line in the tank. Have to ask yourself too, any chance of water in the tank?

Posted on Jan 09, 2009

  • Bruce Volkers
    Bruce Volkers Jan 10, 2009

    Take out a spark plug and look at it. Is it dry or is it wet? If it's wet, does it smell like gas? If it's wet and doesn't smell like gas it may be water. Wet or dry, put it back in. If it's dry, you might try starting fluid. Be very careful with that, follow the label directions and observe the safety precautions indicated on the label. I take no responsibility for any carelessness.
    If it responds to the starting fluid, check the fuel pressure.


×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

Have you checked the fuel pump, or the timing, or coil pack, or fuses?

Posted on Jan 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My van wont start no fuel or spark ?


Sounds like it could be the ignition module in the distributor. You have a throttle body instead of a carb. The injectors get a ground signal from the engine computer when they are supposed to open. The ignition module takes a signal from the pickup coil in the bottom of the distributor and decides when to fire the plugs and also the injectors.
If the injectors and the coil has power, it could be the module or the pickup coil.

Oct 31, 2014 | Cars & Trucks

1 Answer

1992 4.3 v6 tbi s10 starting problem. Won't squirt


Are the injectors getting power and a ground signal from the computer ?

Sep 06, 2013 | Cars & Trucks

1 Answer

I can't get fire out of my distributor put new


Check to see if you have injector pulse using a noid light.

Aug 20, 2013 | Cars & Trucks

1 Answer

I changed the fuel pump but the van still won't


And you know the fuel filter is good? Could be injector problem: just as a check, spray some starting fluid into the intake and see if engine runs a few seconds. If it does, it is a fuel problem. Check injector fuse, as a start. Check fuel pressure. Check injector circuit. If engine won't start with starting fluid, check if you are getting spark. Problem may be in the ignition system.

Aug 13, 2013 | Cars & Trucks

1 Answer

94 volvo 960 wagon engine turns over but it won't


have you check for injector pulse? if no pulse or no ignition fire, most likely it is the ECM.

Jun 13, 2012 | Cars & Trucks

1 Answer

I have a 2004 cavalier that has a new coil new starter new module and new crank sensor in it but want start it gets gas and oil


if fuel is getting to injectors, are the injectors plugged ! if you are getting fuel to engine plus a good spark it should start. check the plugs for fouling out. maybe there not firing right. if a plug or plugs are not firing. then they will be wet on the tips of the plug. crank engine a few times, then pull the plugs to see if they are firing.if not firing, check for bad plug wires. theres so many things that can cause this. its hard to say without being there!

Feb 06, 2012 | 2004 Chevrolet Cavalier

2 Answers

1989 K1500 was running fine and just quit. Not getting gas but I can hear the fuel pump start when I turn the key on. took fuel line off of TBI and seem to have plenty of gas flow but nothing comes out of...


you need to have the fuel pressure checked with a gage and volume as if its not at the spec the injectors won`t open to spray enough fuel.also you should check the injectors for proper voltages and ground as if these are not within specs then the injectors won`t work either

Oct 17, 2011 | 1989 Chevrolet K1500

1 Answer

I have an 89 chevy c1500, 5.7, 2wd. Had it running and trying to get it timed. During this process i noticed the injectors quit giving gas. I put gas in it and nothing changed so i have been chasing the...


the reason the injectors stopped is because the motor is not running.this is a safety precaution built into the computer so the engine won`t flood.if the fuel pump is not working then you will have to check powers and grounds at the fuel pump connector by the gas tank to see if the unit is getting fed power and ground.someone will have to try to start the car while you check this out as there is a 2 second prime circuit if the car is not turning over.also this system uses the distributor to know that the engine is turning over to start.you may have a bad pickup coil in the distributor.this system also grounds the injectors through the ecm so you should have power to the injectors when the ignition is turned on,for your information.

Apr 08, 2011 | 1990 Chevrolet K2500

2 Answers

Fuel system.....all of a sudden nothing , won't start. not getting fuel. Fuel pump is making noise....will start, then stalls, no smell of fuel. Holding gas pedal down, nothing, no smell of fuel.....fuel...


I once worked on a Buick that did this. Try spraying starting fluild in the throttle body. If it starts and runs until it burns the fluid off, replace the fuel filter. If it still doesn't run after this, remove the ignition control module (found under the coil where all your spark plug wires come from, or under the cover on the 4-cylinder model) and have it tested at Auto Zone. If the 'lamp' circuit in the module doesn't work, the fuel injectors won't fire. The PCM uses the reference signal from this module to pulse the fuel injectors in the correct order.

Mar 06, 2010 | 1996 Pontiac Grand Am

1 Answer

Car starts until i let key off from crank position,ldles briefly, then dies like it runs out of fuel.bled off fuel line and there is plenty of fuel and pressure,


It idles briefly since it gets gas from your cold start valve. This means your cold start valve is good.
It dies since after that cold start valve will close as it designed that way so fuel from injectors will take over. But apparently fuel is not coming from injectors. And injectors is controlled by injector module. Injectors are normally closed until injector module tells them to open.
Check out your fuel injectors and Injector Module.
You can buy NOID from any auto part store to test your injectors. If there is no light on then there is a problem with Injector Module. If there is light on the injectors then bad injectors.
Here how NOID looks
http://www.sjdiscounttools.com/ta36330.html

Sep 25, 2009 | 1992 Oldsmobile 88

Not finding what you are looking for?
1995 Buick Park Avenue Logo

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...