I have disconnected battery to charge for 6 hours but now when switching ignition on the large display ( touch screen sat nav fitted ) wants a system code.i have no codes with the manuals supplied.
How do i get this?
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
why didnt you write it on the sun visor ?? wheres the original little card thingy ,cant help without removing the radio to obtain the chassis number just pay the admin fee its easier then write it on the sun visor back of .
many things will cause no start problems could have faulty ignition switch.use test light see if power going to starter if not check ignition fuse to starter.if power going to starter, more likely starter solenoid or starter faulty.if ignition fuse okay and starter and solenoid okay still no start problem could be in the ignition switch or inhibitor switch faulty.code scan for faulty theft security system which will also cause no start conditions.
Electronic Park Brake (EPB)
On some 2003 MY-on S-TYPE vehicles, a customer may report a concern of premature
parking brake pad wear or the brakes binding. This condition can result if the electronic
park brake (EPB) system is not re-calibrated after the removal of the rear brake callipers
to replace the brake pads.
Should a customer express concern regarding the above, refer to the calibration
procedure detailed in this bulletin.
1. Reset the EB module:
a. Switch off the ignition.
b. Disconnect the battery for 30 seconds. For additional information, refer to STYPE
Workshop Manual Section 414-01.
c. Reconnect the battery.
2. Start the engine.
3. Firmly apply and release the foot brake five times.
4. Confirm that the message NOT CALIBRATED" or APPLY FOOT AND PARK
BRAKE" is displayed on the instrument cluster message center. This indicates that
the parking brake is in calibration mode.
5. Lightly press the foot brake pedal.
6. Apply the parking brake by using the EB switch.
7. Release the parking brake.
8. Release the foot brake.
9. Confirm that the brake warning lamp is no longer illuminated on the instrument
pack and that the NOT CALIBRATED" message is no longer displayed in the
10. Apply and release the EPB five times to ensure no error is present. _____________________________________________________________________________
NB: It is also possible the actuator is bad though.
If the vehicle is not fitted with a
touch-screen, adjust the clock using the
audio system controls as follows:
1. Press and hold MODE until TA
VOLUME is displayed.
2. Repeatedly press MODE until
CLOCK SET is displayed.
3. To select 12 or 24 hour format, press
the seek up/down keys.
4. Press MODE to continue
5. If 12 hour is selected, use # to denote
AM or PM.
6. Use the key pad to enter the time in
four digit format.
7. To exit, press and hold MODE until
the display reverts to audio mode.