Question about 1994 Plymouth Voyager

2 Answers

How many bolts on my starter...94 plymouth voyager

I need to know how many bolts i need to take off this starter..it's a 94 voyager

Posted by on

  • yadayada
    yadayada May 11, 2010

    2 mounting bolts and then the wiring.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 146 Answers

You have two one on the bottom and one that goes through the transmission . they are15 mm. you also have a starter wirethat is 13 mm and little plastic plug.

Posted on Jan 08, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 185 Answers

2 nuts that hold the wires on. and two bolts that hold it on to the housing. Thanks for using fixya.

Sincerely

JC

Posted on Jan 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

94 VOYAGER STARTER CLICKS


Will it crank in neutral, and have you checked the starter to see if it has power when the key switch is in the start position ?

Jun 12, 2013 | 1994 Plymouth Voyager

1 Answer

Removing starter 98 plymouth voyager 3.3


3.3L & 3.8L Engines To Remove:
  1. Disconnect and isolate the negative battery cable.
  2. Raise and safely support the vehicle.
  3. Disconnect the wiring from the starter and starter solenoid.
  4. Remove the starter mounting bolts.
  5. Remove the starter and spacer from the bellhousing.
To Install:
Starter motor removal/installation (3.3L & 3.8L engines) chry-02-33-788.gif

  1. Place starter spacer in position on bellhousing, make sure flange is toward flywheel.
  2. Place starter in position on bellhousing.
  3. Install the mounting bolts and ground wire. Tighten the bolts to 40 ft. lb. (54 Nm).
  4. Connect the wiring to the starter and solenoid.
  5. Lower vehicle.
  6. Connect the negative battery cable.
  7. Verify correct starter operation.
prev.gif next.gif

Oct 13, 2010 | 1998 Plymouth Voyager

1 Answer

I need to hotwire my 94 plymouth voyager ES because the ignition was vandalized. Which wires do I need to connect?


all but the yellow one, it's the starter wire. connect it to start and seperate after started

Jul 04, 2010 | 1994 Plymouth Voyager

2 Answers

Where is the starter relay located? 93 plymouth grand voyger 3.3L New starter,but just clicks, will start after many tries.


Check drivers fender area, under hood, near strut mount. You should be able to hear and feel click in one of those relays. Check part #'s on them, they are usually same for 2 or 3, which allows you to use another to test circuit before replacing so you know.

Nov 25, 2009 | 1993 Plymouth Grand Voyager

1 Answer

R&R Starter 1999 Plymouth Voyager w/3.3 V6


The likely problem is the contacts in the solenoid on the side of the starter. Does the solenoid click when trying to start the car? Disconnect one battery cable before doing anything with it. I fixed mine by removing the end of the solenoid case and building up the badly eroded input terminal bolt head with silver solder--worked great. You have to work under the car to get to these parts--use jack stands for safety.

Jul 16, 2009 | 1999 Plymouth Grand Voyager

1 Answer

How hard to replace 1998 plymouth voyager starter


hi disconect battery take starter wirres off then 3 bolts on bellhousing that hold the starter on then re install

Jul 12, 2009 | 1998 Plymouth Voyager

1 Answer

Need diagram for power steering belt on 94 plymouth voyager


r u needing the belt diagram for the power steering,alternator,etc etc...? if so email me at(DarkOctober1@yahoo.com) and i can send u a pic of the diagram i have. i have a 1994 plymouth voyager 3.3l just so u know.

May 11, 2009 | 1994 Plymouth Voyager

1 Answer

94 plymouth voyager 94 won't shift to higher gear


Trans is in limp mode. Speed sensor problem with the transmission. Take it to the dealer. I had mine done for 186 bucks.

May 06, 2009 | 1994 Plymouth Grand Voyager

1 Answer

How many bolts on my starter


three bolts the very top one you have too pull the passenger wheel and reach in with a long extension too too get too it

Jan 08, 2009 | 1994 Plymouth Voyager

1 Answer

94 Plymouth Voyager Water Pump


thw water pump stuff you need is here

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280215d73

The heater stuff is here

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280216054

Hope this helps! good luck!

Sep 15, 2008 | 1994 Plymouth Voyager

Not finding what you are looking for?
1994 Plymouth Voyager Logo

Related Topics:

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...