Question about 1999 Mitsubishi Galant

1 Answer

Spark plug removal 99 mitsu galant

Im wondering how much work is entailed in changing the spark plugs on a 99 mitsu galant. It appears that the intake manifold must be removed to access the back three, and from the looks of the front three they are likley in bad condition. This car has 171,000 miles and is in dire need of some tlc. Is there any easy solution to this problem?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

No i would replace the plug wires to while you the intake off , thanks kdc744

Posted on Jan 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im not sure what a tune up entails.


Find your spark plugs blow compressed air around the plug to get rid of any dirt.Spray some nut buster type spray down by the threads on the plug. If your car has spark plug wires replace them one at a time. If you have coils on top of the plugs back off the two screws a little at a time so the coil housing doesn\'t cock and break. After the old plugs have soaked for about ten minutes put a socket on the plug turn the plug out about a half a turn and tighten back up then back out two turns and go in one. There is carbon on the threads and if you just take them out it could damage the aluminum head.To get to some plugs on a V6 they are under the intake plenum. Remove plenum and re install with new gasket later (It\'s easy). Take your new plugs and make sure thy are platinum or better and gap them for your engine.Put antiseze on the threads. Install the plugs by hand to make sure they start threading right and then torque down.Change air filter if needed

Mar 03, 2013 | 2000 Chrysler Sebring

1 Answer

1999 mitsu galant v6 no spark at coil


Do you have a test light,check at the plug that conects to coil to see if you have power to plug,if not you are going to need a scanner hooked up to car.brad

Sep 16, 2011 | 1999 Mitsubishi Galant

2 Answers

Where are the spark plugs on a 2005 galant 2.4


REMOVE TOP ENGINE COVER,REMOVE CYLNDER HEAD CENTER COVER,YOUR WILL SEE IGNITION COILS SETS ON TOP OF SPARK PLUGS.ALL 4 SPARK PLUGS EACH, WILL HAVE A IGNITION COIL ON TOP OF THEM.REMOVE THE COIL SCREW THEN UNPLUG THE COIL ELECTRICAL CONNECTOR.REMOVE COIL, THEN YOU CAN REMOVE SPARK PLUG.YOU WILL NEED A LONG EXTENSION AND A LONG SPARK PLUG SOCKET TO REMOVE SPARK PLUG.

Apr 08, 2011 | 2005 Mitsubishi Galant

1 Answer

I have 2005 outlander with 96k. dealer recommends timing belt and water pump replacements. what are the other belts that the dealer is talking about. they also recommend transmission maintenance- change...


they are correct ,actually this should have been done at 60k, im sure they are referring to the drive belts ,if you are getting this done at the dealer they will use genuine mitsu parts ,but if you take it to an independent garage make sure they use OE compatiable ,quality parts mitsu can be picking about the parts you put in them , esp. trans fluid MUST BE mitsu SP3 !!!!!! and spark plugs must be denso or ngk plugs only no bosch!! or youll be doing again

Feb 24, 2011 | 2005 Mitsubishi Outlander

1 Answer

How do you change the plugs on a 2003 mitsu gallant 4 cyl


Your coils and spark plug caps are one in the same. You need to unbolt the coil/plug caps on top of the valve cover. Lift them out of the way and you will find the spark plugs underneath.

Oct 06, 2010 | 2003 Mitsubishi Galant

1 Answer

How to remove the intake manifold to replace rear spark plugs for a 2001 galant mitsubishi v6


you shouldnt have to remove the manifold. you can access those plugs by removing the front tire and go in that way.

May 04, 2010 | 2001 Mitsubishi Galant

1 Answer

How to change spark plug on a 2001 galant


sparkplugs are under bonnet in the top of the engine you need a plug socket to remove them but dont forget which leads go where or car wont start after

Apr 02, 2010 | 2001 Mitsubishi Galant

1 Answer

Free how to change spark plugs on a 2000 mitsubishi galant es


You have to pull the spark plug boots out of the valve cover and use a long extension with a spark plug socket and remove them.

Mar 29, 2010 | 2000 Mitsubishi Galant

1 Answer

2001 mitsu galant V6, misfire in #1cylinder


check fuel injectors, fuel pressure regulator, air filter. cat converter, O2 sensor. failure of any of these wastes fuel. air/fuel ratio should be normal.

Oct 04, 2009 | 2001 Mitsubishi Galant

Not finding what you are looking for?
1999 Mitsubishi Galant Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...