Question about 2002 GMC Envoy

1 Answer

2002 GMC Envoy

My heater blower does not work on setting 1 or 2. It works fine on 3, 4, or 5. What is the problem? And how do I fix it.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 196 Answers

Sounds like the blower motor resister to me this piece controls the speeds of the blower motor it should be close to the blower motor on the passenger side it should have wires going to the blower motor very easy to replace.

Posted on Jan 08, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2005 envoy heater blower will not work on speeds one to four but five works fine

You likely have a defective blower motor resistor pack and/or a damaged connector attached to the pack. These parts are located near the blower motor behind and below the glovebox.

Oct 16, 2011 | 2005 GMC Envoy

1 Answer

2002 GMC Envoy heater Problem heater fan under dash-shuts off, but still shows full blower off and on.

will try to help but i think you'll need to have that blower replaced. if it's coming on for a sort while and then shuts off after running a short while it sounds to me like the blower motors heating up inside and then shutting itself off due to a short in the blower motor itself. no really quick fix i know of other than replacement of it. hope this helps and thank you for choosing

Nov 28, 2010 | 2002 GMC Envoy

4 Answers

Heater on my envoy only works on 3-4 setting, could that be the switch.

Thanks for the opportunity to let me help. The blower control switch in your vehicle also uses a blower relay. This relay is generally located on the firewall on the passenger side near the heater fan. You can also look in you vehicle owners manual for the location of the blower relay, it may be also be located in the fuse and relay box under the hood. Generally speaking if the highest setting doesn't work on a GM vehicle it is a high blower Relay. This item is not expensive and can be purchased at most all you local Auto parts stores. If you have a Napa, Orielly's, or AutoZone these stores will also likely help you in the location if you are unable to locate this relay. Here is a general picturepepsiman1967.jpg The installation of this relay is either to remove from the fuse box, or if located near the heater fan housing then you will need to remove the mounting screws, remove the wiring clip, then reverse to install. I hope that this has helped you. D.R. Wilkins

Nov 05, 2010 | 2004 GMC Envoy

2 Answers

Heater on 2002 gmc envoy does not turn on until you reach the setting 4 and then if you do that car dies, was told this is caused by resistance???

Blower motor resister,but shouldn't kill the car.It is mounted under the dash on the passinger side next to the blower motor.All is incased in a plastic cover.You should only have to remove the front screws to get to it.Well good luck and hope this helps.

May 16, 2010 | 2002 GMC Envoy

2 Answers

The blower speed switch only works on 5. The

this problem is caused by a defective blower speed control resistor, it is located near the blower motor, very cheap to replace, part is around $35

Oct 26, 2009 | 2002 GMC Envoy

1 Answer

2002 envoy heater dial only works on the #4

Yes. This is a all too common problem. Replace the resister and it will work like new. Its located under the passenger side dash panel on the under side. Two screws and a plug and your done in 20mins.

Sep 28, 2009 | 2002 GMC Envoy

1 Answer

2002 GMC Envoy-air conditioner/heat

If only some of the fan speeds work this is always the blower motor resistor located in the hvac case inside the right front of the vehicle where your passenger feet would be.the blower motor resistor is available at most larger parts places.I replace 2 or 3 of these a week. Good luck

Aug 22, 2009 | 2002 GMC Envoy

1 Answer

2006 GMC Envoy and the A/C fan wont work in number 5 position

replace the resistor 4 the blower motor that should slove that hope this helps

Mar 05, 2009 | GMC Envoy XL Cars & Trucks

1 Answer

2003 GMC Envoy lower 3 heater fan settings quit working.

had same problem on my XUV. changed the blower motor resistor, located under passenger side dash. easy to change, works no problem.

Jan 20, 2009 | 2003 GMC Envoy

1 Answer

2002 GMc Envoy Blower motor isnt working

do you have power to it..or a bad ground around blower motor? is the head unit not signaling the blower to run?...calling it with A/C or heat or just fresh air ..try all settings and advise...good luck

Jan 08, 2009 | 2002 GMC Envoy

Not finding what you are looking for?
2002 GMC Envoy Logo

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides