Question about 2000 Chevrolet Blazer

2 Answers

Where is the blower motor located on 2000 Chevy Blazer?

Posted by on

  • dreadula Jan 08, 2009

    I am replaceing the heater core and in the manual it says that there is a mounting stud inside the heater case behind the blower motor resister. Does that sound right? Where is the blower motor resister located?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

It is located under the hood on the right side (passenger side) of the engine compartment. It's right behind the coolant recovery tank with the computer on top of it. It's in the cooling duct housing almost touching the right fender, where it says cut here for service, get in there and it's mounting screws will be visable.

Posted on Jan 10, 2009

  • flash3001 Feb 03, 2011

    Thank you, it sounds like the most logic answer. (There is no way you can locate this part under or behind the glove box)

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 196 Answers

It should be on the passenger side under the glove box the resistor will have 2 wires going to the blower motor and probly 2 screws holding it in.

Posted on Jan 08, 2009

×

6 Suggested Answers

  • 2 Answers

SOURCE: blower motor

You have to cut the outer case cover ...It is marked where it has to be cut

Posted on Aug 02, 2008

emissionwiz
  • 61168 Answers

SOURCE: Blower motor location for 2000 Caravan

The motor is located just under the glove box on the passenger side. I remove the glove box then the panel below the glove box. I also go ahead and pull back the carpet and the padding under the motor. It is held in place by 3-4 bolts that take a 7-8 millimeter socket. I use a swivel extension for the back bolts. The motor with the fan blade attached is a tight fit, just keep wiggling and pulling it should come out. Try to remove the old moter without cracking the fan blade, because sometimes the replacement motor doesn't come with a blade

Posted on Sep 17, 2008

SOURCE: purge solenoid location

which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. i'll answer both, lol

the locations are described as if you are looking at the engine from the front of the car with hood open.

on the blazer:

it is located on the left side of the intake manifold just under and behind the throttlebody. it is a canister looking device.

on the silverado:

it is located on the intake manifold on the left side in about the same spot as the blazer. providing the silverado has the 5.3 or 5.7 liter engine. if it also has the 4.3 then obviously it will be the same.

hope this helps!

Posted on Feb 17, 2009

  • 4 Answers

SOURCE: 2002 Chevy Impala Blower resistor location

It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: Installing a blower motor in a 98 Chevy Blazer

96 chevy S10 p/u truck 4cyl 2.2 liter
shift solenoid electrical problem

Posted on Oct 06, 2009

  • 11 Answers

SOURCE: where is the blower motor in 98 chevy blazer

under the hood in the top left corner

Posted on Dec 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I find the blower resistor on a 2000 chevy S10 pickup


Here's what it look's like,it's located next to blower motor,remove electrical connector and two screws and ala,it's off.

Jan 31, 2013 | Cars & Trucks

1 Answer

My 1996 Chevy Blazer blower isn't blowing air. Fuse is ok. What next?


Faulty blower motor resistor or blower motor resistor connector faulty.Wiggle blower motor resistor connector with the ignition and fan switches on.

Jun 17, 2012 | 1996 Chevrolet Blazer

1 Answer

How do you replace a blower motor resistor on


It is located on the right rear of the engine compartment. held in by two screws.

Jun 29, 2011 | 1997 Chevrolet Blazer

2 Answers

Blower not working on 1997 chevy blazer


Check the blower motor relay, usually located under the hood in a box, also check the fuse in the fuse panel for the blower motor. If both of those are good then you have a bad blower motor.

Mar 17, 2011 | 1997 Chevrolet Blazer

1 Answer

Where is the location of the blower motor resistor on a 1997 Chevy S10 Blazer?


Under the dash panel in the heater box on the passenger's side next to the blower motor, it's held in by 2 screws.

Jan 13, 2011 | 1997 Chevrolet Blazer

1 Answer

I am trying to replace my starter on a 2000 chevy blazer. Where is it located?


follow red wire from battery towards engine/motor it will be attached to the starter motor it should be between the engine/motor and the gearbox/transmission...hope that helps

Aug 30, 2010 | 2000 Chevrolet Blazer

1 Answer

Locate heater motor 2000 chevy blazer


you have move center floor air distribution duct blower motor is behind hinge pillar trim kick panel.

Dec 10, 2009 | 2000 Chevrolet Blazer

1 Answer

Installing a blower motor in a 98 Chevy Blazer


96 chevy S10 p/u truck 4cyl 2.2 liter
shift solenoid electrical problem

Oct 01, 2009 | 1998 Chevrolet Blazer

1 Answer

Have a 2000 chevy blazer, just replaced blower module .still no heat or ac and selector switches don't light up when pressed


my 2000 chevy blazer zr2 4x4 the a/c switch that does 123 and 4,the a/c only works on num 3 setting.ive just replaced the whole a/c sytem and blower relay.it wont work on num 4 at all and when it does it cuts off on its own and then works on setting 3 only?what to do?

Mar 05, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

452 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...