Question about Hyundai Motor 2004 Sonata

Open Question

2002 XG350 P0350 pertains to which coil pack on a v6 engine?

Posted by on

5 Suggested Answers

maklean
  • 1665 Answers

SOURCE: Error code P0350

P0350 Ignition Coil Primary/Sensor Circuit If there is no voltage at either of 2 ignition coil group during 32 ignitions, the PCM determines that a fault exists and a DTC is stored.. http://hmaservice.com/viewer/dispimg.asp?path=/data/Passenger/HY/HMA/ENG/DTC-images/HY-EF13-IMAGES-ENG/ef24035011.jpg

Posted on May 22, 2008

  • 2039 Answers

SOURCE: Hyundai Sonata 2002 EF-B V6 2.7L

put the bad coil in the place of a good on and check it after that our be sure hope it help fixya our post thanks pierre

Posted on Jul 15, 2008

  • 67 Answers

SOURCE: location of the coils on a 2002 xg350 eng.

take off engine cover and there will be three on the front valve cover and 2 10mm bolts on each coil pack holding them down

Posted on Apr 08, 2009

  • 162 Answers

SOURCE: 2002 accent 1.5 no spark..replaced coil pack

hook up a scanner if you have one, check to see if your scanner is registering a crank signal.

Posted on Jul 31, 2010

  • 14585 Answers

SOURCE: I own a Hyundai xg350

Heat is usually the cause for most coils going bad. It can be from the inside or outside of the coil. It is possible that you got a defective coil. Just because they are new doesn't mean they work. Factory flaw. Take it back and try it again.

Posted on Nov 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0351 code loss of power 2.3L08ford ranger,it warms slow and really need to eliminate1~voltage regulator is where?) & 2~ ground through PCM) 3~knowing limits&threashholds{sensorsIGNcircuit}?Ty 0$


P0351 loss of power ? That's not what this code is about . P0351 - Ignition Coil A Primary/Secondary Circuit ,you have a bad coil and possibly a bad coil driver inside the PCM . Do yourself a favor an take your vehicle to a qualified repair shop !
P0351 - Ignition Coil A Primary/Secondary Circuit Description: See the description for DTC P0350. Possible Causes: See the possible causes for DTC P0350. Diagnostic Aids: See the diagnostic aids for DTC P0350. Application Key On Engine Off Key On Engine Running Continuous Memory Coil-on-plug (COP) ignition testing - GO to Pinpoint Test JF . GO to Pinpoint Test JF . Coil pack ignition testing - GO to Pinpoint Test JE . GO to Pinpoint Test JE .
P0350 - Ignition Coil Primary/Secondary Circuit Description: Each ignition primary circuit is continuously monitored. The test fails when the powertrain control module (PCM) does not receive a valid ignition diagnostic monitor (IDM) pulse signal from the ignition module (integrated in the PCM). Possible Causes:
  • Open or short in the ignition START/RUN circuit
  • Open coil driver circuit
  • Coil driver circuit short to ground
  • Damaged coil
  • Coil driver circuit short to VPWR
Diagnostic Aids: Use the 12-volt non-powered test lamp to verify START/RUN voltage at the ignition coil harness connector.
Check the coil driver circuit for open, short to VPWR, or short to ground. Application Key On Engine Off Key On Engine Running Continuous Memory All GO to Pinpoint Test JE .

Feb 18, 2017 | 2008 Ford Ranger

2 Answers

I HAVE REPLACED THE COIL PACKS AND THE COMPUTER ON MY 2006 F150,BUT I STILL GET AN ERROR CODE OF 352.WHY IS THIS ?


P0352 - Ignition Coil B Primary/Secondary Circuit Description: See the description for DTC P0350. Possible Causes: See the possible causes for DTC P0350. Diagnostic Aids: See the diagnostic aids for DTC P0350. Application Key On Engine Off Key On Engine Running Continuous Memory Coil-on-plug (COP) ignition testing - GO to Pinpoint Test JF . GO to Pinpoint Test JF . Coil pack ignition testing - GO to Pinpoint Test JE . GO to Pinpoint Test JE .
P0350 - Ignition Coil Primary/Secondary Circuit Description: Each ignition primary circuit is continuously monitored. The test fails when the powertrain control module (PCM) does not receive a valid ignition diagnostic monitor (IDM) pulse signal from the ignition module (integrated in the PCM). Possible Causes:
  • Open or short in the Ignition START/RUN circuit
  • Open coil driver circuit
  • Coil driver circuit shorted to ground
  • Damaged coil
  • Coil driver circuit shorted to VPWR
Diagnostic Aids: Use the 12-volt non-powered test lamp to verify START/RUN voltage at the ignition coil harness connector.
Check the coil driver circuit for open, short to VPWR, or short to ground. Application Key On Engine Off Key On Engine Running Continuous Memory Coil pack ignition testing GO to Pinpoint Test JC . Coil-on-plug (COP) ignition testing GO to Pinpoint Test JB . Without me testing , it's hard to say what you got going on ! Coil packs ? What engine does it have ? 5.4 L ? should have coil on plug ignition .

Jan 13, 2017 | 2006 Ford F-150 Regular

1 Answer

2005 Ford f 150 4.2liter Check engine light P0352


Does your f150 have coil on plug or coil pack ignition system !
P0352 - Ignition Coil B Primary/Secondary Circuit Malfunction Description: See the description for DTC P0350. Possible Causes: See the possible causes for DTC P0350. Diagnostic Aids: See the diagnostic aids for DTC P0350. Application Key On Engine Off Key On Engine Running Continuous Memory Coil-on-plug (COP) ignition testing - GO to JF1 GO to JF1 Coil pack ignition testing - GO to JE1 GO to JE1
What this code is say is there is an open in the coil electrical circuit . Had this code on a few ford's where the problem was the PCM - engine computer ! Spark plug gap got worn so far as to cause the coil to break down and send 20,000 volts to the coil control transistor inside the engine computer . Watch this video !
Ford 5 4 shorted coil primary winding and bad computer driver Doesn't matter this is a 5.4 L , works the same way !

Jan 02, 2017 | Ford Cars & Trucks

1 Answer

Morning,I have this 2 codes on my Toyota avanza.P1601 and P0350 what do they mean and how can I solve them


p1601: compression code

p0350: ignition coil primary/secondary circuit

did you change your spark plug (do you change them regularly)
coil pack is on its way?

is the car misfiring when started?
if yes then change coil.

May 19, 2016 | Toyota Cars & Trucks

1 Answer

2002 Hyundai XG350 L.also had codes Po304, Po350


P0304 miss on cylinder 4
P0350 ignition coil primary/secondary circuit

May 18, 2015 | Hyundai Cars & Trucks

1 Answer

I own a Hyundai xg350 2003 model. The engine is a 3.5l V6. One of the 3 frontal ignition coils got burnt and i got it replaced with another hyundai ignition coil. The replacement coil also got burnt on the...


Heat is usually the cause for most coils going bad. It can be from the inside or outside of the coil. It is possible that you got a defective coil. Just because they are new doesn't mean they work. Factory flaw. Take it back and try it again.

Nov 26, 2010 | 2002 Hyundai XG350

1 Answer

2002 C240 V6 How can I check the coil


swap them if possible why you have engine light misfire

Jan 03, 2010 | 2001 Mercedes-Benz C-Class

1 Answer

Need to locate spark plugs on 2004 hyudai xg 350 6 cyl 3.5


once you remove the engine cover, on each valve cover you will see coil packs. remove these coil packs and right underneath are the spark plugs. replace with either ngk or nippondenso. happy holidays

Dec 30, 2009 | 2002 Hyundai XG350

1 Answer

Location of the coils on a 2002 xg350 eng.


take off engine cover and there will be three on the front valve cover and 2 10mm bolts on each coil pack holding them down

Apr 07, 2009 | 2002 Hyundai XG350

Not finding what you are looking for?
Hyundai Motor 2004 Sonata Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...