Question about 2004 Ford Freestar

1 Answer

Engine rattle when A/C is on...2004 Ford Freestar

Why do I hear a slight rattle (right side of engine) when I turn on the A/C? Noticed it about 3 weeks ago. When I turn the A/C off, rattle goes away. I've got 53,000 miles on it...

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 32 Answers

Some noise from the AC pump is normal, but if the noise is changing or gets worse then the pump is probable going bad and will need serviced or replaced.

Posted on Sep 19, 2009

4 Suggested Answers

  • 1075 Answers

SOURCE: 2004 Nissan Altima Wanders at Highway Speeds

check tyre pressures on front two wheels,if problem persists get you two front wheels lined and balanced this will solve your problem.adrian

Posted on Feb 16, 2009

  • 82 Answers

SOURCE: 2004 chevy express looses power dramaticaly on

Fuel supply issue or restricted exhaust? Step on throttle while someone feels amount of pressure out of tailpipe.

Posted on Jun 22, 2009

jbass706
  • 167 Answers

SOURCE: 2004 Ford Freestar SE- rear rattle and vibrates

Anti-rattle hardware missing on rear brakes or worn caliper guide pins.

Posted on Oct 25, 2009

ghost45
  • 1280 Answers

SOURCE: i have an 09 accent

Vehicle is still under US warranty - Take to Authorized Hyundai Service Department & have it diagnosed/repaired under warranty (was this vehicle in an accident?... if so, contact Insurance agent for proper instructions).

Posted on Feb 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Install a belt tensioner in 2004 freestar


2004 Ford Freestar:
Accessory belt drive removal and installation:
    1.Put the vehicle in neutral, and put it on hoist.
    2.Rotate the accessory drive belt tensioner counterclockwise.
    3.Push the spring clip towards the belt tensioner to lock the accessory drive belt tensioner in place and remove the belt.
    4.To install the accessory drive belt, on the engine, rotate the accessory drive belt tensioner counterclockwise till the spring clip releases.
    5.Install the belt.



25393426-h5votn0blg1f11botl1palbw-3-1.png

Jan 31, 2015 | 2004 Ford Freestar

4 Answers

Why is my 2004 Ford Freestar engine rattles when I accelerate even after a tune up has being done to the engine?


Pre-ignition or knock maybe. Ignition timing over-advanced, fuel mixture weak, or possibly the plugs. Faulty knock sensor?

Oct 24, 2014 | 2004 Ford Freestar

1 Answer

Where is the cowl on a 2004 ford freestar


its the black cover that covers wiper motor and half the engine in front of your windshield need to take that off to get to back side of engine also to get to your computer

Feb 27, 2013 | 2004 Ford Freestar

1 Answer

WHAT IS THE FIRING ORDER FOR A FORD FREESTAR 4.2l V6?


The spark plug firing order is ( 1 - 4 - 2 - 5 - 3 - 6 )

The engine cylinders are 1 , 2 , 3 from front to rear on the passenger side of the engine and 4 , 5 , 6 from front to rear on the drivers side of the engine

The coil pack towers are numbered 1 , 2 , 3 from front to rear in the row nearest the passenger side and 5 , 6 , 4 from front to rear in the row nearest the drivers side


hope this clarifies the situation for you



Sep 06, 2012 | 2004 Ford Freestar

1 Answer

2004 ford freestar van idles rough


For rough idle and error code issues on your ford freestar.Click the link below:----
http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html
--------This will help.Thanks.

Jan 31, 2012 | 2004 Ford Freestar

1 Answer

How to change the coil in a 2004 ford freestar 3.9L


The ignition coil on a 2004 Ford Freestar is a bit of work to replace. Here are some steps:
1. Disconnect the negative battery cable;

2. Remove windshield wiper arms (you might need a cheap puller to get the arms off the spindles), marking the windshield with tape to help you reposition the wiper arms;
3. Remove the trim screws from the upper cowling and remove the cowling;
4. Remove a bunch of screws from the lower cowling, taking care not to remove the screws holding the wiper motor onto the lower cowling;
5. Remove the lower cowling with the wiper motor attached;
6. There is a large black piece on the passenger side of the car that covers up a big part of the engine. There are three screws that if you loosen you'll be able to remove this part;
7. Now you can get to the ignition coil, which is on the back of the engine; remove the wires (marking where the go);
8. There are only three screws that hold the coil on. Two on your right and one on the left (as you look into the engine compartment). Remove the three screws and the coil comes right out.
Good luck!

Sep 10, 2011 | 2004 Ford Freestar

1 Answer

Were is the pcv valve on a 2005 ford freestar


pcv valve is located on the valve cover of the engine. you will see a line running close to the middle of the valve cover gently pull the line out of the valve cover, the pcv valve will be on the end of the line. take out the pcv shake it, if it rattles it is okay, if you don`t hear a rattle it needs to be replaced. Also I personally would change the pcv valve every 25,000 to 30,000 miles because they are usually inexpensive.

Feb 12, 2011 | 2005 Ford Freestar

1 Answer

2004 Freestar-In Jan. it just started hesitating and it would not get over 30 mph. I had it towed to the dealer and they could not find problem. I picked it up and it ran good. I noticed the radio had lost...


Take van to reputable Ford dealer and have them hook it up to computer and check for any codes.
The vehicle computer might have to be reset for the egr system.What they did was disconnect your battery for the quicki reset for vehicle, thats why your radio had reset.

Mar 28, 2010 | 2004 Ford Freestar

2 Answers

Orange fluid leak (most likely power steering fluid)


Check your hoses around your power steering resevoir, you might have a pin hole leake in one of the hoses. Make sure to keep an eye on the fluid level. As long as you keep fluid in it you won't burn out the pump.

Apr 28, 2009 | 2004 Ford Freestar

Not finding what you are looking for?
2004 Ford Freestar Logo

Related Topics:

270 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...