Question about 2005 Hummer H2

1 Answer

Help: I have a 2005 H2 HUMMER SUT; I purphased a H2 HUMMER FUEL DOOR CHROME. I having probelms installing this fuel door, here is what the instructions state: Step 1: Trim template, lay over stock fuel bucket and mark holes with a sharp object: Q: Do lay this trim template right over the plastic cover of the exiting fuel linning? Step 2: Remove bucket and drill holes using 7/32 drill bit: No problem; Step 3: Place Fuel door face door, make sure the four holes line up before pealing adhesive back. No problem; Step 4: Screw fuel bucket to door using the four screws provided; Q: How do you screw the four screws if they are in the back side of the new Fuel Door? Do you remove the inside wheel wall to get from the inside or do you just adhesive to install? Please advice....

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

YOU NEED TO REMOVE INSIDE TRIM .

Posted on Aug 22, 2009

5 Suggested Answers

  • 19 Answers

SOURCE: Hummer H2 SUT DTC Code C0563

C0563 - Calibration ROM Checksum Error
Not sure what it means but thats what I found when I looked it up

Posted on Oct 28, 2008

  • 1 Answer

SOURCE: I just got my 2007 hummer h2 sut, but I don't know how to turn on

The fog lights run by default during the day in the "auto" position. To activate the headlights and the fog lights you need modify the jumper position in the fuse box for the lights. "see fuse box diagram"

Posted on Jun 26, 2009

abdoush
  • 12 Answers

SOURCE: change light on 2006 hummer h2

it can be easily changed by removing the plastic cover then u will see the light bulb, don't try to change it from the back, it wont open :)

Posted on Sep 08, 2009

  • 1 Answer

SOURCE: I need to remove the luggage racks from my 2007 Hummer h2 SUT

I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Posted on Dec 27, 2009

dttech
  • 4803 Answers

SOURCE: The reduce engine power message

The Powertrain Control Module (PCM) is shutting down your throttle body control for some reason and limiting how much throttle you can apply. The only way to find out why it is doing this is to scan the PCM for Diagnostic Test Codes (DTCs) and diagnose any existing codes accordingly. It is very likely to be caused by a fault in your throttle position sensor or accelerator pedal position sensor circuits.

There is a Technical Service Bulletin (TSB) for your vehicle which covers a known problem with reduced engine power and sets DTC P2138. The known problem is that the Accelerator Pedal Position (APP) sensor circuits are being infiltrated by water intrusion into a connector and causing erratic voltage readings at the PCM. It is TSB reference # 07-06-04-019D

Posted on Jul 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Theft lock


You can't. You need to see the dealer to have the system scanned for faults.

Nov 15, 2012 | 2005 Hummer H2 SUT

1 Answer

The Hummer 2005 H2 sut shows service air bag Now I will check with dealer but could this be expensive


Why would you bother with a dealer after the warrantee runs out ?

Never heard of the 200,000 repair shops available,with better
results & cheaper than a dealer.

You can't ask what something costs
You do not have any idea what ,if any problems you may have

Aug 09, 2011 | 2008 Hummer H2

1 Answer

What's the capacity of the rear diff, I want to change the fluid. 05 Hummer H2 SUT


actually just fill till it comes out of the hole but generally will hold less than 2 quarts. make sure that you have the correct diff fluid and any additives that it requires. dealer can get you the correct additive. cheers

Dec 30, 2009 | 2005 Hummer H2

1 Answer

I bought a chrome locking fuel door and it came without instructons. How do I install? I have an H2 with an existing locking chrome door on it. It si rusting and I want to replace.


You can check online from the maker of the new cap and see if they have installation instructions there. If not call your local Hummer dealer and see if they can help you out.

Nov 28, 2009 | 2005 Hummer H2

1 Answer

I need to remove the luggage racks from my 2007 Hummer h2 SUT


I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Nov 27, 2009 | 2007 Hummer H2 SUT

2 Answers

Is there a reset button for the compressor-air suspension


When I replaced my air suspension bag it reinflated upon starting the Hummer. I did not have to reset anything. You may check the fuses in the event it ran so much to blow one and prevent the compressor from burning up.

Jul 09, 2009 | 2005 Hummer H2

1 Answer

How check hummer 2005 sut H2 before to buy


is the car low milage ? by taking it for a drive you will be able to tell if everything works and stepping on the brakes lightly you will be able to tell if there is any noise coming from them.. take it on the road and step down on it to see if it accelerates good.. make sure it shifts smooth and there should be no smoke coming from anyhere.. check under the hood to see if it is clean everywhere. this tells you if it has been taken care of .windshield broken? check for chips here also.. interior clean ? this lets us know if its been taken care of also... if its late model and low miles you probably will be ok.. driving it will tell the story about how it is going to run ... holler if you have more.. Jerry

Apr 28, 2009 | 2007 Hummer H2 SUT

1 Answer

Hummer H2 SUT DTC Code C0563


C0563 - Calibration ROM Checksum Error
Not sure what it means but thats what I found when I looked it up

Oct 27, 2008 | 2005 Hummer H2

1 Answer

2005 H2 SUT problems


how often is the belt breaking? excess revolutions can cause premature wear. flushing the cooling system with the proper cleaners, refilling with dexcool and DISTILLED water can reduce the engine temp in h1's by at least 10 degrees in the desert. this i have done. also if the cooler for the transmission has not been upgraded to handle the new trans you will still get an overheat. you can also put a electric fan on the trans cooler. the belt may not be aligned properly.

Aug 01, 2008 | 2005 Hummer H2

Not finding what you are looking for?
2005 Hummer H2 Logo

Related Topics:

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...