Question about 2001 Volvo S60

1 Answer

Want to install new replace lift-o-mat stabillus trunk support

Need illustration or directions to install new lift-o-mat trunk supports folr a volvo S60 2002. my replcement part number is SG415005

Posted by on

  • Anonymous Mar 29, 2014

    THE LIFT PIN CAME OUR OF MY 2000 VOLVO V70 REAR HATC, NEED ILLUSTRATION HOW TO ATTACHE

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Volvo Master
  • 1,779 Answers

Ive never changed them in a Volvo, but the several other vehicles I have, it's just a snap on socket to attach or remove. So, to remove, gently pry apart, to install, push round opening onto round 'ball' til it snaps in place. They should come w/ instructions.

Posted on Jan 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace battery in 200 s500


The S 500 battery is in the trunk on the passenger side look in the extreme right hand corner of the trunk lift up the mat you will see a black cover over the battery remove it in the battery is there

Jul 11, 2014 | 2000 Mercedes-Benz S-Class

1 Answer

How do you install stabilus lift-o-mat trunk struts with metal ends?


pry the tin clips off the ends with a small screw driver the new one will snap on

Sep 21, 2012 | 2000 Jeep Grand Cherokee

1 Answer

HI, I have got the new Azera trunk lift support cylinders. I do not know how to replace the old lifts with new ones. please send the steps if anyone know how to do this.


These gas filled struts have a "U" shaped clip on both ends of the strut. Using a small flat tip screwdriver, pop these clips outward (not all the way out). Lifting the trunk lid slightly will allow you to remove these struts and install the new ones.

Sep 09, 2011 | Hyundai Azera Cars & Trucks

1 Answer

How do you replace a 2001 Mazda 626 Fuel Filter


Fuel Filter On all models except the Millenia, the fuel filter is attached to a bracket located in the left rear of the engine compartment, next to or beneath the brake master cylinder fluid reservoir. On the Millenia, the fuel filter is located beneath an access cover in the trunk. Access to the cover is achieved by removing the trunk mat to expose the cover.
---
REMOVAL & INSTALLATION Except Millenia
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable Fig. 1: Exploded view of a common fuel filter and related components 7923mg68.gif

    • Air intake hose and/or filter housing, if necessary
    • Fuel line clamps, if equipped
    • Fuel lines from the filter and plug the openings
    • Filter clamp bolt/nut by loosening them.
    • Fuel filter from its mounting bracket
    NOTE: Note the direction of the flow arrow on the filter so the replacement filter can be installed in the correct position. To install:
  4. Install or connect the following:
    • Fuel filter in its mounting bracket, making sure the flow arrow is pointing in the proper direction
    • Fuel lines to the fuel filter
    • Fuel line clamps, if equipped
    • Air intake hose and/or filter housing, if removed
    • Negative battery cable
  5. Pressurize the fuel system and check all connections for leaks.
Millenia
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Insure the ignition switch is OFF.
  3. Relieve the fuel system pressure.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Trunk mat
    • Service hole cover
    • Fuel lines from both ends of the fuel filter
    • Fuel filter and bracket
    • Fuel filter from the mounting bracket.
    To install:
  5. Install or connect the following:
    • Filter in the bracket. Tighten the nut to 70-95 inch lbs. (8-11 Nm).
    • Fuel lines to the filter
    • Service hole cover
    • Trunk mat
    • Negative battery cable
  6. Run the engine and check for any fuel leaks.
prev.gif next.gif

Oct 17, 2010 | 2001 Mazda 626

2 Answers

Where is the spare tire and how do you get to it


Look in the trunk, there should be a compartment under the rug or mat, lift the mat and you should see the cover of the compartment, lift that cover, the tire should be right there.

Aug 18, 2009 | 1988 Chevrolet Camaro

1 Answer

I need to replace the fuel pump in my 940 Volvo.


Disconnect battery ground strap before beginning to work on the fuel/electrical system. Do not smoke or have anything in the area which can ignite or cause sparks

  1. Drain enough fuel from tank to prevent spilling, no more than 4 gallons (16 liters) of fuel should remain. Use suitable pumping equipment.
  2. Remove floor mat and panel from trunk.
  1. Disconnect wiring harness connector to sending unit. Remove wires from connector.
  2. Disconnect ground wire to sender. Push wires through grommet.
  3. Remove cover for access to tank sending unit.
  1. All models: Disconnect from the fuel tank sending unit:
    1. Breather hose C
    2. Return hose A
    3. Supply hose B
    4. Filler hose D
    5. Wiring harness from clip E
  1. Clean area and unscrew fuel tank sender/pump cap or equivalent. Remove tank sender/pump and seal.
  2. Remove pump from sender/pump assembly.
INSTALLATION
  1. Inspect the pump for damage, feed pump hose and wiring for wear. Replace as needed.
  2. Install new pump to sender/pump assembly.
  3. Install rubber seal in neck of tank. Lubricate inside of seal.
  1. Install fuel tank sender/pump unit. Align it with the moulded joint (arrows) on tank.
  2. Apply rustproofing compound to exposed metal portions of tank sender.
CAUTION : With tape or rubber caps, protect fuel sender openings from overspray.
  1. Torque fuel tank sender/pump lock ring to: 22 ft-lb (30 Nm)
  2. Reassemble components in reverse order. Use tie straps to secure all hoses and wiring.

Jun 04, 2009 | 1995 Volvo 940

1 Answer

Need to replace the Stabilus lift o mat gas


Use a screwdriver to pull up/out the tab on the ends where they hook onto the ball. Then measure the length of the strut fully extended. That will give you the size. On my motorhome, I needed 100 lb struts on the doors. Your struts may have the lb printed on them.

Apr 15, 2009 | 2001 Volvo S60

2 Answers

Fuel filter on a 1996 Mazda Millenia


The fuel filter is accessable from inside the trunk. remove the trunk carpet mat. You will notice a circular panel on the left side which is held to the trunk floor with two screws. remove the screws and panel and you will immediately see the fuel filter. When replacing the fuel filter, note the direction of fuel flow and Do Not Install The New Fuel Filter Backwards!

Sep 12, 2008 | 2000 Mazda Millenia

Not finding what you are looking for?
2001 Volvo S60 Logo

Related Topics:

809 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...