Question about 2003 Audi allroad

1 Answer

How to replace the water temp sender in a 2003 Audi Allroad

I need to replace the water temp sender in my 2003 Audi Allroad. I understand the sender is located on the top-rear of the engine (between the engine and firewall). What are the steps necessary to access and replace the temp sender?

Posted by on

  • tachyon280 Jan 23, 2009

    Thanks for the post! However my primary interest/question is; WHAT ARE THE STEPS NECESSARY TO ACCESS THE SENDER? - i.e. exactly where is it and what has to be removed to gain access and what is the best access point (left side, right side, below...)

    Thanks again.


×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 99 Answers

Make sure engine is COLD. put little grease around new sensor and keep it close at hand. Remove the plug on the sensor, then slide the retaining that holds sensor in, out. pull sensor our of housing and quickly replace with new. replace clip and plug. top up coolant if necessary. easy as that..

TL

Posted on Jan 23, 2009

  • Craig Davies
    Craig Davies Jan 23, 2009

    Fair enough but you didnt tell me the what engine was in it.



    Usually there is nothing to take off to get into it, however some of the petrols have the air intake pipe running across the top of it. im assuming its the 1.9tdi and not the V6, the sensor is at the back of the engine. Follow rocker cover back towards the firewall and as it drops down to the gearbox area you will see some coolant hoses with a plastic block with the coolant sensors installed. The sensor is usually green in colour. If you find it, refer to my previous post for removal and refit.



    TL

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When should timing belt be replaced on a 2003 Audi allroad?


60k along with water pump and belts about $1200

Feb 02, 2012 | 2003 Audi allroad

1 Answer

What kind of OBD II reader works on an 2003 audi allroad?


its the 250 dollar scanner that sells at advance auto or autozone i use it on a 2003 audi allroad.

Jan 19, 2011 | 2003 Audi allroad

1 Answer

My 2003 audi allroad suspension is stuck on the lowest hight and won't rise up to any other levels. What is wrong?


sounds like your air supply pump for suspension not functions. you should check the system by professionals.

Jan 16, 2011 | 2003 Audi allroad

1 Answer

My audi allroad 2001, won't start in morning, but if i keep trying it slowly starts to run a bit then die's, slowly it runs more till its warm or burns the gas more. i did smell gas under the hood. can...


very common fault , check the sensors value by the obd and compare on cold engine the air - water temp . it should be the same value if the engine have been parked over night ,if bad sensor the value will be diffrent on the sensors

Dec 18, 2010 | 2001 Audi allroad

1 Answer

My cigarette lighter outlets no longer work with car chargers. Do I need to replace a fuse and where is the fuse box on my 2003 allroad?


For 2003 Audi Allroad the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram. Fuse no.# 33 (15A) = Cigarette lighter (for front & rear sockets).


3d8612d.jpg


Oct 20, 2010 | 2003 Audi allroad

1 Answer

Audi Allroad 2003 Suspension Problem - Front wheel is rubbing fender in turns.


wrong wheels their oversize and do not conform to certificate of homoglonation

Oct 16, 2010 | 2003 Audi allroad

Not finding what you are looking for?
2003 Audi allroad Logo

Related Topics:

449 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70346 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13527 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...