Question about 2002 Ford Ranger Regular Cab

2 Answers

Air bag sensor

I have a 2000 ford ranger, can someone please tell me where the sensor is located so i can look and make sure everything is connected. thank you

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi Kyle, I have the same basic problem, It is as follows.My air bag lght comes on & stays on coutinious,Also flash's on & off.(This is the air bag light in the dash) The problem is worse when i have been driving on rough country roads. Kyle your solution sounds easy enough but you did not say where the circut board was?? I would apprerciate a little help. Reuben Griffith. crow_shooter@sbcglobal.net

Posted on Feb 12, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

A possible solution. i have a 2002 ranger in which the air bag light would present itself. i discoved that the passenger air bag indicater bulb was out if i had the airbag on or off. its located next to the key switch. i pulled it appart and notice the bulb was bad. replacing it fixed the problem. there is a catch. this bulb is solderd to the circuit board and you have to get it from radioshack. is a simple task if have a solder kit. hope that helps.

Posted on Jan 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The ford ranger 2000 4l., v6, have a/c air filter and it that true, can you tell me where it located.


some have what is called CABIN FLTER it under glove box if it has one i not to sure butjust look if it does it will be their.........

Dec 24, 2010 | 2000 Ford Ranger SuperCab

1 Answer

2000 Ford Ranger- engine stalling when slowing down to idol


replace th air idle bypass valve this is located on the throtle body and has 2 screws with 1 plug with 2 wires to it

Dec 29, 2009 | 2000 Ford Ranger SuperCab

1 Answer

Hi I have a 2000 Ford Ranger and the air bag light is flashing


The light (on the key switch) that indicates whether the passenger airbag is on or off is, more than likely, burned out. You can either replace the whole switch ($$$) or you can take it apart and solder a new led into the circuit board. You can get the bulb at radio shack (make sure it is 12v). Good Luck!

Nov 17, 2009 | 2000 Ford Ranger SuperCab

1 Answer

I have a 2000 Ford Ranger w/ a code 19 flashing on the dash, The bags were blown , have replaced them and the air bag computer still have a code 19 Any ideas?


you will have to replace the Restraint Control Module to clear the error. Until then the airbag should not deploy in a crash. It should be located under the radio.

The part will run in the neighborhood of $100

Oct 22, 2009 | 2000 Ford Ranger SuperCab

1 Answer

ATS sensor on 2003 Ford Ranger/2.3 engine


In the bottom of the air box.

Please rate this solution.

Jan 16, 2009 | 2003 Ford Ranger Regular Cab

1 Answer

2003 Ford Ranger/2.3 ATS


In the bottom of the air box.

Please rate this solution

Jan 16, 2009 | 2003 Ford Ranger Regular Cab

1 Answer

2003 Ford Ranger/2.3 O2 sensor - How many and Where located ???


Engine Heated oxygen and catalyst monitor sensors—2.3L engine44e2701.jpg

Jan 16, 2009 | 2003 Ford Ranger Regular Cab

1 Answer

Air bag


When you first start the truck the air bag system does a diagnostic. The light comes on because there is a fault in the system. Needs to be scanned, I suspect they will find a problem with the front impact sensor. Either it was damaged, or the wiring to it was damaged when you went into the ditch.

Mike

Jan 07, 2009 | 2002 Ford Ranger Regular Cab

2 Answers

96 Ford Ranger air bag lite


The sensor that is located near the front bumber is bad. It's not hard to change. I had an accident a few months ago and rebuilt the front end of the truck myself. I had to replace the sensor.

Jul 29, 2008 | 1996 Ford Ranger SuperCab

Not finding what you are looking for?
2002 Ford Ranger Regular Cab Logo

503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...