Question about 1986 Ford Bronco II

1 Answer

86 bronco2 hey man i have the new voltage regulator in my hand and i cant find anything that resembles it in the engine compartment. I must be retarded or something!

Posted by on

  • daylen7 Jan 07, 2009

    Thankzzzz!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 60,867 Answers

86 is a split year, some have an external regulator, it would be on the inside of of the fender on the passenger side, so since u say you don't see it then your voltage regulator is mounted on the outside back of the alternator with a oval connector going to it, it is black and silver

Posted on Jan 07, 2009

  • yadayada
    yadayada Jan 07, 2009

    u are most welcome!

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1986 diesel isuzu pickup standard 2.2l 4cyl. A New alternator installed. But still its draining battery, (did engine stall) or does battery drain parked?


The voltage regulator type depends on which alternator you have (there are 2 different ones), on one the regulator is attached to the outside of the alternator and the other it is separate and mounted on the firewall I think. See pictures below so you can ID what you have.
26224962-fvvr1ed2asgwebift2eeby4v-1-0.jpg

26224962-fvvr1ed2asgwebift2eeby4v-1-2.jpg

Jun 24, 2016 | Isuzu Cars & Trucks

1 Answer

Where is the icm high voltage module located on a 1999 chevy express 2500?


What engine does yours have ? 4.3 - 5.0 - 5.7 L An just to get this straight , The ICM high voltage module is ? If you would like help you need to get your terminology correct !
ignition control driver (ICD) module. ,no high voltage module !
The enhanced ignition system used on all OBD II engines somewhat resembles the current distributor ignition (DI) system described in the ignition systems. However, the system has been greatly enhanced in order to make it compatible with the new OBD II regulations. The enhanced ignition system provides a spark at precisely the correct time in order to ignite the air and fuel mixture for optimum performance and fuel economy. The system consists of the following components:
?€¢
Vehicle control module (VCM)


?€¢
Distributor


?€¢
Ignition coil driver module


?€¢
Ignition coil


?€¢
Crankshaft position (CKP) sensor


Ignition Control Module
Top RH side of engine
Engine Controls Component Views
Engine Controls Connector End Views
Ignition Coil
Top RH of engine.

Sep 25, 2015 | Cars & Trucks

1 Answer

Replacing voltage regulator


mostly the voltage regulator is in the unit that holds the brushes in the back of the alternator . Sometimes depending on the make the regulator can be found in the engine compartment. Best to contact an auto electrician to get the right regulator. and where it is located

Sep 28, 2013 | Honda Passport Cars & Trucks

1 Answer

My 86 Audi 5000 CS Turbo has quit running while driving but at stop signs or stop lights with no indication of anything wrong. When I try to start it again the battery is dead. I've bought batteries...


IF ALTERNATOR AND BATTERY BEEN REPLACED.REPLACE THE BATTERY CABLES AND CHECK ALTERNATOR FUSE AND CHECK ALTERNATOR POWER BATTERY FEED WIRE AND VOLTAGE REGULATOR WIRES FOR DAMAGE.

Sep 04, 2011 | 1986 Audi 5000 CS

2 Answers

My alternator on my 86 econoline rv is putting out 45+ volts. Is that possible? Is the alternator fried or wired wrong?


DO NOT run it for long you will burn something up....most likely the ALT. REGULATOR is stuck, advise a new alt and retest....normal out-put is 12.5V>14.0V...15>25A with everything else good....I have never seen 45+V but it's possible with a shorted regulator ....hope this helps you...GL

Jul 11, 2009 | 1999 Mazda Millenia

1 Answer

Voltage regulator on a 1986 ford aerostar


also check the left front corner of the engine compartment sometime the battery have to be removed in order to see it

Jan 22, 2009 | 1986 Ford Aerostar

2 Answers

I cant seem to locate the voltage regulator on my 86 bronco2. I have the new one but i dont see any thing like it anywhere in the engine compartment


it should be on the passenger side on the wheel well cover,,,you should be able to find it pretty easy

Jan 07, 2009 | 1986 Ford Bronco

1 Answer

Location of voltage regulator on a 86 bronco2


should be on or the back or inside the alternator.

Jan 07, 2009 | 1986 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...